1997 SSANGYONG KORANDO Service Repair Manual

Page 137 of 2053

SSANGYONG KORANDO 1997  Service Repair Manual D AEW OO M Y_2000
SECTION 1D1
M162 ENGINE COOLING
CAUTION: Disconnect the negative battery cable before removing or installing any electrical unit or when a
tool or equipment could easily come in cont

Page 138 of 2053

SSANGYONG KORANDO 1997  Service Repair Manual 1D1 -- 2 M162 ENGINE COOLING
D AEW OO M Y_2000
SPECIFICATIONS
GENERAL SPECIFICATIONS
ApplicationDescription
Cooling TypeWater Cooling Forced Circulation
RadiatorCirculation TypeDouble Cross Flow
Radia

Page 139 of 2053

SSANGYONG KORANDO 1997  Service Repair Manual M162 ENGINE COOLING 1D1 -- 3
D AEW OO M Y_2000
SPECIAL TOOLS AND EQUIPMENT
SPECIAL TOOLS TABLE
124 589 15 21 00
Tester603 589 00 40 00
Fan Clutch Holder

Page 140 of 2053

SSANGYONG KORANDO 1997  Service Repair Manual 1D1 -- 4 M162 ENGINE COOLING
D AEW OO M Y_2000
DIAGNOSIS
SYSTEM LEAKAGE TEST
Tools Required
124 589 15 21 00 Tester
Test Procedure
1. Loosen the cap a little and release pressure and re-
move the cap.

Page 141 of 2053

SSANGYONG KORANDO 1997  Service Repair Manual M162 ENGINE COOLING 1D1 -- 5
D AEW OO M Y_2000
MAINTENANCE AND REPAIR
ON-VEHICLE SERVICE
COOLANT DRAIN AND FILL UP
Draning & Filling up Procedure
1. Loosen the cap a little and release pressure and re

Page 142 of 2053

SSANGYONG KORANDO 1997  Service Repair Manual 1D1 -- 6 M162 ENGINE COOLING
D AEW OO M Y_2000
6. Remove the de-- aeration hose clamp in the coolant
pump and remove the de-- aeration hose.
7. Fill up the coolant through the coolant reservoir
tank.

Page 143 of 2053

SSANGYONG KORANDO 1997  Service Repair Manual M162 ENGINE COOLING 1D1 -- 7
D AEW OO M Y_2000
COOLANT CONNECTION FITTING
Preceding Work: Removal of cooling fan shroud
1 Bolt (M8 X 100, 2 pieces)
22.5-- 27.5 NSm (16.6-- 20.3 lb-ft) .............
2

Page 144 of 2053

SSANGYONG KORANDO 1997  Service Repair Manual 1D1 -- 8 M162 ENGINE COOLING
D AEW OO M Y_2000
WAT E R P U M P
Preceding Work: Removal of V-- belt
Removal of air admission housing
1 Air Admission Housing
2 Oil Cooler Pipe Line
3 Seal Replace.......