1997 SSANGYONG KORANDO Service Repair Manual

Page 1529 of 2053

SSANGYONG KORANDO 1997  Service Repair Manual SSANGYONG  MY2002
7A-28  HEATING AND VENTILATION SYSTEM
AIRFLOW THROUGH VENTS
KAA7A220
1 Side Ventilation Vents (Face Position)
2 Front windshiel Defroster Vents
3 Conter Ventilation Vents (Face Posit

Page 1530 of 2053

SSANGYONG KORANDO 1997  Service Repair Manual SECTION 7C
MANUAL CONTROL / SEMIAUTO
TEMPERATURE CONTROL HEATING,
VENTILATION AND AIR CONDITIONING
SYSTEM
CAUTION: Disconnect the negative battery cable before removing or installing any electrical un

Page 1531 of 2053

SSANGYONG KORANDO 1997  Service Repair Manual SSANGYONG  MY2002
7C-2  MANUAL & SEMIAUTO-HVAC
SPECIFICATIONS
REFRIGERANT
Core Size (LxWxT)
Core Type
Expansion Valve Type
Thermostat
Resister Type
Cooling CapacityApplicationDescription237.0 x 232.0

Page 1532 of 2053

SSANGYONG KORANDO 1997  Service Repair Manual MANUAL & SEMIAUTO-HVAC  7C-3
SSANGYONG  MY2002
PRESSURE SWITCH
Type
High (OFF)
Low (ON)ApplicationDescriptionDirect
OFF : 32 ± 2 Kgf/cm
2, DIFF : 6 ± 2 Kgf/cm2
OFF : 2.0 ± 0.2 Kgf/cm2, ON : 2.1 ±

Page 1533 of 2053

SSANGYONG KORANDO 1997  Service Repair Manual SSANGYONG  MY2002
7C-4  MANUAL & SEMIAUTO-HVAC
DIAGNOSIS
Insufficient
cooling
 Check blowing outlet
Normal outlet
 Check outlet temperature
 Check fan motor operation
Motor operates
with poor outle

Page 1534 of 2053

SSANGYONG KORANDO 1997  Service Repair Manual MANUAL & SEMIAUTO-HVAC  7C-5
SSANGYONG  MY2002
DEFECTIVES IN FAN MOTOR CIRCUIT
Fan Motor Does Not Run
Blown fuse
Battery voltage is low
Faulty wiring
Faulty groundChecksActionCheck for short and repla

Page 1535 of 2053

SSANGYONG KORANDO 1997  Service Repair Manual SSANGYONG  MY2002
7C-6  MANUAL & SEMIAUTO-HVAC
Oily clutch plate
Low voltage
Faulty electric connection or operationChecksActionClean oily plate using cleaning agent.
Charge battery or check for cause

Page 1536 of 2053

SSANGYONG KORANDO 1997  Service Repair Manual MANUAL & SEMIAUTO-HVAC  7C-7
SSANGYONG  MY2002
DIAGNOSIS USING THE MANIFOLD GAUGE
On normal operation during the cooling cycle, the
manifold gauge must indicate approximately 1.5 - 2.0
kg/cm
2 at low