Page 1417 of 1771

Dashboard
Component Removal/Installation (cont'd)
Dashboard center panel/Radio panel/Switch panel
removal:
1, Carefully detach the clips, then pull out the dash-
board center panel.
DASHBOARD
CENTER PANEL
CLIMATE
CONTROL
UNIT
2. Disconnect the connectors, then remove the dash-
board center panel.
3. Make sure you have the anti-theft code for the
radio, then write down the frequencies for the
radio's preset buttons.
4. Remove the screws, then pull out the radio panel
with the stereo radio/cassette player. Disconnect the
connectors and antenna lead, then remove it.
CONNECTORS
STEREO RADIO/
CASSETTE PLAYER
ANTENNA
LEAD
SHOP TOWEL
5. Installation is the reverse of the removal procedure.
NOTE:
Make sure the connectors and antenna lead are
connected properly.
Enter the anti-theft code for the radio, then enter
the customer's radio station presets.
Driver's switch panel removal:
1. Carefully detach the clips, then pull out the driver's
switch panel. Disconnect the connectors, then
remove it.
DRIVER'S SWITCH
PANEL
2. Installation is the reverse of the removal procedure.
NOTE: Make sure the connectors are connected
properly.
RADIO
PANEL
CONNECTOR
CONNECTORS
CONNECTORSProCarManuals.com
Page 1418 of 1771
Glove box removal:
1. Open the glove box.
2. Detach the damper clip. Remove the bolts while hold-
ing the glove box, then remove it.
5 x 0.8 mm
9 N-m (0.9 kgf-m,
7 Ibf-ft)
DAMPER CLIP
DAMPER
GLOVE BOX
SIDE AIR VENT
Open the glove box, then push the
clips from the glove box opening by
hand, and pull it out.
Bolt locations, 2
3. Installation is the reverse of the removal procedure.
Side air vent (Front passenger's)/Side defogger trim
removal:
Clip locations
SIDE DEFOGGER TRIM
Carefully pry it at the rear edge,
then remove it.
SHOP
TOWEL
HOOK CLIP
HOOK
CLIP
Push here.ProCarManuals.com
Page 1419 of 1771
Replacement
SRS component s ar e locate d in thi s area . Revie w th e SR S
componen t locations , precautions , an d procedure s i n th e
SR S sectio n 24 befor e preformin g repair s o r service .
NOTE:
• A n assistan t i s helpfu l whe n removin g an d installin g
th e dashboard .
• Tak e car e no t t o scratc h th e dashboard , bod y an d
relate d parts .
1 . Remove :
Dashboar d lowe r cove r (se e pag e 20-65 )
Kne e bolste r (se e pag e 20-65 )
Cente r consol e (se e pag e 20-64 )
Glov e bo x
Kic k panel s (se e pag e 20-63 )
2 . Remov e th e dashboar d cente r trim .
DASHBOAR DCENTER TRI M
3. Mak e sur e yo u hav e th e anti-thef t cod e fo r th e radio ,
the n writ e dow n th e frequencie s fo r th e radio' s prese t
buttons .
Clip location s
ProCarManuals.com
Page 1420 of 1771

Dashboard
Replacemen t (cont'd )
4. Lowe r th e steerin g colum n (se e sectio n 17 ).
T o avoi d accidenta l deploymen t an d possi -
bl e injury , alway s disconnec t th e driver' s airba g connec -
to r befor e lowerin g th e steerin g colum n (se e sectio n 24 ).
NOTE : T o preven t damag e t o th e steerin g column , wra p it
wit h a sho p towel.
10 x 1.2 5 mm38 N- m (3. 9 kgf-m ,
2 8 Ibf-ft )
8 x 1.2 5 mm16 N- m (1. 6 kgf-m ,12 Ibf-ft )Replace .
STEERIN GCOLUMN
STEERIN G JOIN TCOVE RCLAMP S
5. Disconnec t th e dashboar d wir e harnes s connector s
an d harnes s clips .
CLIPSCONNECTO R
DASHBOAR DWIRE HARNES S
DASHBOAR DWIRE HARNES S CONNECTOR
S
CONNECTORS
6. Remov e th e airba g bracket .
T o avoi d accidenta l deploymen t an d
possibl e injury , alway s instal l th e protectiv e shor t
connecto r o n th e fron t passenger' s airba g connec -
to r whe n th e SR S mai n harnes s i s disconnecte d
(se e sectio n 24 ).
6 x 1. 0 m m9.8 N- m(1.0 kgf-m ,
7. 2 Ibf-ft )
AIRBA GBRACKE T
FRONT PASSENGER' SAIRBAG
ProCarManuals.com
Page 1421 of 1771

7. Remov e th e bolts .
CAUTION : Us e protectiv e plate s o n th e botto m o f
th e fron t pilla r trim .
6 x 1. 0 m m9.8 N- m (1. 0 kgf-m ,
7. 2 Ibf-ft )
6 x 1. 0 m m9.8 N- m (1. 0 kgf-m ,
7. 2 Ibf-ft )
6 x 1. 0 m m9.8 N- m (1. 0 kgf-m ,
7. 2 Ibf-ft )
PROTECTIV E
PLATE
CAP CA
P
IN-CA R TEMPERATUR E
SENSO R CONNECTO RDASHBOAR
D
CLIMAT E CONTRO LUNIT CONNECTOR S
ANTENNALEAD
SRS UNI T 9
. Installatio n i s th e revers e o f th e remova l procedure .
NOTE:
Make sur e th e dashboar d fit s ont o th e guid e pi n
correctly .
Before tightenin g th e bolts , mak e sur e th e dash -
boar d wir e harnesse s ar e no t pinched .
Mak e sur e th e connectors , antenn a lea d an d ai r
hos e ar e connecte d properly .
Ente r th e anti-thef t cod e fo r th e radio , the n ente r
th e customer' s radi o statio n presets .
CLIP
CONNECTO R
8. Lif t an d pul l ou t th e dashboar d half-way , the n dis -
connec t th e connectors , antenn a lea d an d ai r hos e
whil e holdin g th e dashboard .
CAUTION : D o no t dro p th e dashboard .
CAP
SHO P TOWE L
SHO
P
TOWE L
CAP
DASHBOAR DGUIDE PI N
5 x 0. 8 m m9 N- m (0. 9 kgf-m ,
7 Ibf-ft )
PROTECTIV E
PLATE
AIRHOS E
ProCarManuals.com
Page 1422 of 1771
Seats/Seat Belt s
Componen t Locatio n Inde x
REAR SEA T BEL TReplacement , pag e 20-9 0
Inspection , pag e 20-9 2
FRON T SEA T BEL T
Replacement , pag e 20-8 8Inspection , pag e 20-9 2 SHOULDE
R
ANCHO R ADJUSTE R
(se e pag e 20-88 ) REA
R SEA T BEL T BUCKLE /
CENTE R BEL T TONGU E
(se e pag e 20-91 )
FRON T SEAT S
Removal , pag e 20-7 1
Seat-bac k Replacement , pag e 20-7 2
Sea t Cushio n Replacement , pag e 20-7 4
Sea t Cove r Replacement , pag e 20-7 6
Sea t Track s (Manuall y adjustable )
Replacement , pag e 20-7 8
Seat Linkag e (Full y powe r adjustable )Index, pag e 20-7 9
REA R SEAT-BAC KRemoval, pag e 20-8 5
Sea t Cove r Replacement ,
pag e 20-8 7
REA R SEA T CUSHIO N
Removal , pag e 20-8 5
Sea t Cove r Replacement , pag e 20-8 6
FRON T SEA T
BEL T BUCKLE S
(se e pag e 20-89 )
ProCarManuals.com
Page 1423 of 1771

Front Seat
Removal
CAUTION: When prying with a flat tip screwdriver, wrap
it with protective tape to prevent damage.
NOTE: Take care not to scratch the seat covers and body.
1. Slide the front seat forward, then remove the seat
track end covers.
FRONT SEAT
SEAT TRACK
END COVER
2. Remove the bolts.
10 x
1.25
mm
34 N-m (3.5 kgf-m,
25 Ibf-ft)
FRONT SEAT
Driver's: A
Passenger's :B
Driver's: B
Passenger's: A
3. Slide the front seat backward, then remove the seat
track end cover, and remove the bolts.
10 x
1.25
mm
34 N-m (3.5 kgf-m,
25 Ibf-ft)
SEAT TRACK
END COVER
FRONT SEAT
4. Lift the driver's seat, then disconnect the seat harness
connector and seat belt switch connector.
DRIVER'S
SEAT
SEAT BELT SWITCH
CONNECTOR
SEAT HARNESS
CONNECTOR
5. Carefully remove the front seat through the door
opening.
6. Installation is the reverse of the removal procedure.
NOTE: Make sure the connectors are connected prop-
erly (driver's).
10 x
1.25
mm
34 N-m (3.5 kgf-m,
25 Ibf-ft)
Passenger's:
SEAT TRACK
END COVER
SEAT TRACK
END COVER
Driver's:ProCarManuals.com
Page 1424 of 1771
Front Sea t
Seat-bac k Replacemen t
CAUTION: Whe n pryin g wit h a fla t ti p screwdriver , wrap
i t wit h protectiv e tap e t o preven t damage .
NOTE : Tak e car e no t t o scratc h th e sea t cover s an d body .
1 . Remov e th e fron t sea t throug h th e doo r openin g (se e
pag e 20-71 ).
2 . Remov e th e reclin e cover .
Full y powe r adjustable :
Disconnec t th e connectors .
CONNECTOR S
RECLINE
COVE R
Manuall y adjustable :
CAP
RECLIN E KNO B
RECLINE COVE R
3. Remov e th e bac k cover .
NOTE : I f necessary , replac e an y damage d clips .
HOOK S
HOOKS
BAC K COVE R
4. Releas e th e hoo k an d clip . Detac h th e harnes s cli p
(full y powe r adjustabl e seat) . Fol d th e seat-bac k
cove r an d pad , the n remov e th e bolts .
NOTE : Replac e th e release d cli p o f th e seat-bac k
cover wit h a ne w one .
10 x 1.2 5 mm47 N- m (4. 8 kgf-m ,
3 5 Ibf-ft )
CLIP
SEA THARNES S
CLIP
SEAT-BAC KCOVER
PAD
RECLIN E
ADJUSTE R
CLIP
HOO K
ProCarManuals.com