Page 2465 of 2492
NON-SIDE OPENING ELEMENT MECHANISMS
Rear screen and luggage compartment lid locks
52
52-2
REMOVING THE REAR SCREEN LOCK
After removing the trim (section 73-A),
disconnect connector (A).
Remove the two mounting screws (B).REMOVING THE REAR SCREEN STRIKER PLATE
Remove the two mounting screws.
The arrows indicate the adjustment options.
REFITTING
To refit, proceed in the reverse order to removal.
16831R1
16876S
A
Page 2466 of 2492
NON-SIDE OPENING ELEMENT MECHANISMS
Rear screen and luggage compartment lid locks
52
52-3
REMOVING THE LUGGAGE COMPARTMENT LID
LOCK AND STOP
After removing the trim (section 73),
Remove:
– the two mounting bolts on the stop,
– the two mounting bolts on the lock.Disconnect the connector from the lock.
Using a flat-nosed pliers, apply light pressure to the
stop (C) and remove the lock.
REFITTING
Check that the lock operates correctly.
To refit, proceed in the reverse order to removal.
16785-1R
16877R
16786R1
A
Page 2467 of 2492
NON-SIDE OPENING ELEMENT MECHANISMS
Rear screen and luggage compartment lid locks
52
52-4
REMOVING THE STRIKER PLATE AND THE PAD
ON THE BODY
Remove:
– the two striker plate bolts,
– the two pad bolts.
NOTE: the movement arrows indicate the adjustment
options.REFITTING
To refit, proceed in the reverse order to removal.
WARNING: If removing the striker plate and the pad
at the same time, the striker plate is no longer
supported.
16878S
A
Page 2468 of 2492
NON-SIDE OPENING ELEMENT MECHANISMS
Luggage compartment lid exterior handle
52Luggage compartment lid exterior handle
REMOVAL
After removing the luggage compartment lid trim
(section 73-A),
remove the handle mounting bolt (A).
Disconnect the connector from handle (B).Remove the handle.
REFITTING
To refit, proceed in the reverse order to removal.
16785R
16787S
52-5
B
Page 2469 of 2492
WINDOWS
Rear screen
54P
154WINDOWS
Rear screen
APPEARANCE AND OPENING CLEARANCES
A = 3 ± 2 mm
B = 5.5 ± 3 mm
IMPORTANT: it is vital that you fit the four self-
adhesive adjustment stops (part no. 82 00 048 913) to
the rear window surround, before bonding it.1 Location of the adjustment stops.
2 Adjustment stop
3 Adhesive tape
Refer to Technical Note 371A for information on how
to prepare and bond the windscreen.
18067R
18076R
16884-1R
54-1
A
Page 2470 of 2492
EXTERIOR PROTECTION
Front bumper protection
55P
155EXTERIOR PROTECTION
Front bumper protection
REMOVAL
Remove:
– the lower mounting bolts (A),– the upper mounting bolts (B),
– the two bolts attached to the towing brackets (C).
17591R
16882R
16881R
55-1
A
Page 2471 of 2492
EXTERIOR PROTECTION
Front bumper protection
55S
55-2
Pull manually on the two ends of the protection to
release the part.
REFITTING
To refit, proceed in the reverse order to removal.
18078R
A
Page 2472 of 2492
EXTERIOR PROTECTION
Front and rear valance protections
55SFront and rear valance protections
NOTE: it is not possible to remove the front protection section without first removing the rear protection section.
55-3
B