1993 FORD MONDEO Service Repair Manual

Page 41 of 279

FORD MONDEO 1993  Service Repair Manual Chapter 2  Part A: 
In-car engine repair procedures
Auxiliary drivebelt check and renewal  . . . . . . . . . . . . . See Chapter 1
Camshaft oil seals - renewal  . . . . . . . . . . . . . . . . . . . .

Page 42 of 279

FORD MONDEO 1993  Service Repair Manual Lubrication
Engine oil type/specification  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . See Chapter 1
Engine oil capacity  . . . . . . . . . . . . . . . . . . . . . . . . . . .

Page 43 of 279

FORD MONDEO 1993  Service Repair Manual Torque wrench settings (continued)Nm lbf ft
Engine/automatic transmission rear mounting:
Mounting bracket-to-transmission  . . . . . . . . . . . . . . . . . . . . . . . . . . . 48 to 49 35 to 36
Mount

Page 44 of 279

FORD MONDEO 1993  Service Repair Manual end of the cylinder block, inboard of the
timing belt, and is driven with the power
steering pump and alternator by a flat
“polyvee”-type auxiliary drivebelt from the
crankshaft pulley.
When worki

Page 45 of 279

FORD MONDEO 1993  Service Repair Manual The cylinder head is provided with two oil
galleries, one on the inlet side and one on the
exhaust, to ensure constant oil supply to the
camshaft bearings and hydraulic tappets. A
retaining valve (ins

Page 46 of 279

FORD MONDEO 1993  Service Repair Manual specifications were available from Ford, but a
typical reading would be in excess of 12 bars.
All cylinders should produce very similar
pressures; any difference greater than 10%
indicates the existen

Page 47 of 279

FORD MONDEO 1993  Service Repair Manual throttle linkage as described in Chapter 4.
Where fitted, disconnect also the cruise
control actuator cable (see Chapter 12).
3Remove the timing belt upper cover (see
Section 9).
4Disconnect the crank

Page 48 of 279

FORD MONDEO 1993  Service Repair Manual 16Unscrew the bolts and nuts securing the
manifold to the cylinder head and withdraw it
(see illustration). Take care not to damage
vulnerable components such as the EGR pipe
and valve as the manifold