1993 FORD MONDEO Service Repair Manual

Page 33 of 279

FORD MONDEO 1993  Service Repair Manual evidence of leaks, severe corrosion, or
damage. Make sure that all brackets and
rubber mountings are in good condition, and
tight; if any of the mountings are to be
renewed, ensure that the replacemen

Page 34 of 279

FORD MONDEO 1993  Service Repair Manual brake shoes is not less than the
recommendation given in the Specifications.
14If it is difficult to determine the exact
thickness of the brake shoe linings, or if you
are at all concerned about the c

Page 35 of 279

FORD MONDEO 1993  Service Repair Manual pleated-paper type filter, it cannot be washed
or re-oiled. If it cannot be cleaned
satisfactorily with compressed air, discard
and renew it.
Warning: Wear eye protection
when using compressed air! 
8

Page 36 of 279

FORD MONDEO 1993  Service Repair Manual are correctly secured, and that the radiator
drain plug is securely tightened. Refit the
radiator undershield, noting that it is located
by three clips at its front edge; tighten the
retaining screws

Page 37 of 279

FORD MONDEO 1993  Service Repair Manual 5Refitting is the reverse of the removal
procedure. Ensure that the element and cover
are securely seated, so that unfiltered air
cannot enter the engine.
1The Positive Crankcase Ventilation (PCV)
sys

Page 38 of 279

FORD MONDEO 1993  Service Repair Manual To prevent the possibility of mixing up spark
plug (HT) leads, it is a good idea to try to work
on one spark plug at a time.
4If the marks on the original-equipment
spark plug (HT) leads cannot be see

Page 39 of 279

FORD MONDEO 1993  Service Repair Manual check the cylinder head threads and tapered
sealing surfaces for signs of wear, excessive
corrosion or damage; if any of these
conditions is found, seek the advice of a Ford
dealer as to the best meth

Page 40 of 279

FORD MONDEO 1993  Service Repair Manual 1•26Every 60 000 miles
Every 60 000 miles
Refer to Chapter 2, Part A.
Warning: Petrol is extremely
flammable, so extra precautions
must be taken when working on
any part of the fuel system. Do not s