1998 SSANGYONG MUSSO Workshop Repair Manual

GLASS AND MIRRORS 9L-11
5. Apply sealant to the glass.
lTurn over the glass and apply sealant.
lUneven application of sealant may cause water leakage
after installation of glass.
lDo not touch the glass moldings and dam rubber while
applying sealant.
6. Using suction holders, install the tailgate glass within
5minutes after application of sealant.
lFix the glass with adhesive tape.
lApply sealant additionally between the quarter outer
panel and tailgate glass moldings.

9L-12 GLASS AND MIRRORS
1 Auto Dimming Room Mirror Assembly
2 Sensor (Front)
3 Sensor (Rear)
AUTO DIMMING ROOM MIRROR
Layout
4 Switch
5 Cover
6 Lamp

GLASS AND MIRRORS 9L-13
Check & Service
If reflection ratio is not adjusted automatically during night
driving when AUTO switch is pressed, check each connectors
for proper connection and power flow to the auto dimming room
mirror using multi tester.
1. Yellow (Connected to back-up lamp)
2. Blue (Ground)
3. White (Power)
Voltage Rating
Operating Current
Over CurrentDV 12V
1 A
3 A
Function
When ignition switch is turned ON, green lamp on auto dimming
mirror will turn in and glare reflection ratio will be automatically
adjusted. By positioning AUTO switch to ON, 2Sensors will
automatically adjust refection ratio after sensing rear and
surrounding brightness to reduce driver’s eye fatigue during
driving though tunnel or in night.
When OFF switch is pressed, the lamp goes out and it will be
operated as a normal rear view mirror and shift lever is
positioned in reverse, the auto dimming function will be
automatically OFF.
Specifications

9L-14 GLASS AND MIRRORS
Removal & Installation Procedure
1. Removal the room mirror cover (arrow).
2. Disconnect 3-pin connector.
3. Removal the mirror assembly.
4. Installation should follow the removal procedure in the
reverse order.

SECTION 9N
FRAME AND UNDERBODY
TABLE OF CONTENTS
Dimension . . . . . . . . . . . . . . . . . . . . . . . . . . 9N-2
Frame . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9N-2
Component Locator . . . . . . . . . . . . . . . . . . . 9N-3
Body Mountings . . . . . . . . . . . . . . . . . . . . . . . 9N-3
Body Mounting-Sectional View . . . . . . . . . . . . 9N-4
Skid Plate . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9N-5

9N-2 FRAME AND UNDERBODY
DIMENSION
FRAME

FRAME AND UNDERBODY 9N-3
COMPONENT LOCATOR
BODY MOUNTINGS
1 Upper Insulator
2 Lower Insulator
3 Washer Tube
4 Plain Washer
5 Bolt
6 Grommet
7 Nut8 Plate
9 Upper Insulator
10 Lower Insulator
11 Bolt
1 2 Nut
13 Washer

9N-4 FRAME AND UNDERBODY
BODY MOUNTING-SECTIONAL VIEW