1995 ISUZU TROOPER Workshop Manual

'"T1 cO' co w (
RELAY
& FUSE
BOX
(FL-11
RELAY:
NC
COMPRESSOR
BLOWER
MOTOR
RELAY:
NCTHERMOSTAT
,,-;~
H-42'
NC:
AIR
CONDITIONING
(
PRESSURE
SW
RECEIVER
DRIER
B-19
FUSE
BOX
(C-19,
C-201
B-36 RELAY;
HEATER
& NC
NCSW FAN
SW
AND
HEATER
BEZEL
ILLUMINATION
LIGHT
(
MAGNETIC
CLUTCH
INC
COMPRESSOR)
;g ::0 ~ r-0 0 ~ 0 2
n :::J: )> en en Cii m r­m ~ ::u n )> r-eo I w ~ ...a

8 -342 CHASSIS ELECTRICAL
CIRCUIT DIAGRAM
~ IOOV
M:LAV; 8TARTERI1) ITO PAOEI· .. I
E!]~ ENG. ft'AME
. :l
. 5
IOOV-11< II
2L
I LOWER MOTOR
'
fiiELAY; HEATEfii6AIC
C·1t 21A BLOWER
A/C: AIR CONDITIONING
O.IIR O.IIR
IOOV~ 11~----------------------------------------------------------__J
Fig. 8-396
22
H·11
..

CONNECTOR LIST
12 11 10 16 15 ,. 13
I H-411 (W/ABSI
Fig. 8-393
12 11 10 9 16 15 ,, 13
CHASSIS ELECTRICAL 8-339
I H-411 (W/RWALI

8-340 CHASSIS ELECTRICAL
HEATER AND AIR CONDITIONING
GENERAL DESCRIPTION
The circuit consists of the pressure switch, NC switch, electric thermostat, blower motor, fan switch, magnet
clutch of the NC compressor, blower resistor and relay.
The start and stop of the NC is controlled by turning the NC switch on and off. The electric thermostat and the
ECM can stop the operation of the NC temporarily by disconnecting the magnet clutch under the
predetermined conditions
to adjust the room temperature, preventing the abnormal rise of the engine coolant
and reduce the engine load while the NC is in operation.
Refer
to Section 18 "AIR CONDITIONING" for detail.
OPERATING CONDITIONS OF A/C COMPRESSOR (MAGNETIC CLUTCH)
BATIERY(+)
--
~
A/C SW "ON"
~
HEATER & A/C RELAY "ON"
(The contact point is closed except
when starter SW is at ST or OFF position)
(S =:>
¢:!]
PRESSURE D
SW"ON"
¢:::l
~ FAN SW"ON"
u A/C THERMOSTAT
RELAY
"ON"
A/C COMPRESSOR
RELAY"ON"
ECM IA2l "ON"
MAGNETIC
CLUTCH lAIC COMPRESSOR)
"ON"
NOTE:
Arrow marks" =:> " indicate the direction of current
Fig. 8-394
~
1111

CHASSIS ELECTRICAL 8-343
CONNECTOR LIST
'--"" ~ IB-191 [E) [E) [E) I B-361 [E] [TI]
o[J a 6 6 m ~ BiB 4
Fig. 8-397

8-344 CHASSIS ELECTRICAL
CONNECTOR LIST
~
~
Fig. 8-398
..

CHASSIS ELECTRICAL 8 _ 3
45
MEMO

8-346 CHASSIS ELECTRICAL
SUN ROOF
GENERAL DESCRIPTION
The circuit consists of the starter switch, sun roof switch, sun roof control unit, safety stop switch, limit switch,
and sun roof motor.
When the sun
roof switch is turned on, the battery voltage is applied to the sun roof control unit through the
circuit breaker and the power
window relay on the circuit.
Accordingly,
when the sun roof switch is set to "Open" or "Close" position, the open or close relay incorporated
into the control
unit is activated to change the rotational direction of the sun roof motor to open or close the
sun roof.
Also, the operational process (full close-> limit stop-> full open-> safety stop-> full close) ofthe sun roof
is
controlled by the control unit in accordance with signals received from the safety stop switch and limit switch.
OPERATION OF SUN ROOF
1. When the sun roof opens 2. When the sun roof closes
BATTERY(+!
BATTERY(+)
D D SUN ROOF CONTROL UNIT SUN ROO!' CONTIIOI. UNIT
D D
D
D
SUNROOF SW SUNROOFSW
D D
NOTE: ARROW MARKS • =:> • INDICATE THE DIRECTlON 01' CURRENT.
Fig. 8-399
Ill