2004 DAEWOO LACETTI Service Repair Manual

Page 225 of 2643

DAEWOO LACETTI 2004  Service Repair Manual ENGINE ELECTRICAL  1E – 11
DAEWOO V–121 BL4
MAINTENANCE AND REPAIR
ON–VEHICLE SERVICE
GENERATOR
Removal Procedure
1.  Disconnect the negative battery cable.
2.  Disconnect the manifold air tempe

Page 226 of 2643

DAEWOO LACETTI 2004  Service Repair Manual 1E – 12IENGINE ELECTRICAL
DAEWOO V–121 BL4
9.  For vehicles equipped with the 1.8L engine, remove
the generator upper mounting bolts to the intake
manifold/cylinder head support bracket, the intak

Page 227 of 2643

DAEWOO LACETTI 2004  Service Repair Manual ENGINE ELECTRICAL  1E – 13
DAEWOO V–121 BL4
3.  Install the generator and the lower support bracket
assembly to the 1.8L engine block (as shown).
Tighten
Tighten the generator and the lower bracke

Page 228 of 2643

DAEWOO LACETTI 2004  Service Repair Manual 1E – 14IENGINE ELECTRICAL
DAEWOO V–121 BL4
10.  Install the air cleaner outlet hose and connect the
MAT electrical connector.
11.  Connect the negative battery cable.
STARTER
Removal Procedure
1.

Page 229 of 2643

DAEWOO LACETTI 2004  Service Repair Manual ENGINE ELECTRICAL  1E – 15
DAEWOO V–121 BL4
4.  Position the starter electrical wire on the solenoid
terminals and the ground wire on the lower stud.
5.  Install the starter solenoid nuts and the

Page 230 of 2643

DAEWOO LACETTI 2004  Service Repair Manual 1E – 16IENGINE ELECTRICAL
DAEWOO V–121 BL4
3.  Install the battery into the tray.
4.  Fasten the bar clamp to the battery by loosely at-
taching the battery rods from the battery tray cut-
outs th

Page 231 of 2643

DAEWOO LACETTI 2004  Service Repair Manual ENGINE ELECTRICAL  1E – 17
DAEWOO V–121 BL4
UNIT REPAIR
STARTER MOTOR
Disassembly Procedure
1.  Remove the starter. Refer to ”Starter” in this sec-
tion.
2.  Remove the starter through–bolts

Page 232 of 2643

DAEWOO LACETTI 2004  Service Repair Manual 1E – 18IENGINE ELECTRICAL
DAEWOO V–121 BL4
1) Rated current draw and no–load speed indicate
a normal condition for the starter motor.
2) Low rpm combined with high current draw is an
indication