2003 DAEWOO MATIZ Service Repair Manual

INTERIOR TRIM 9G–13
DAEWOO M-150 BL2
D109E566
REAR PARCEL SIDE SHELF
Removal Procedure
1. Disconnect the negative battery cable.
2. Open the tailgate.
3. Remove the seatback.
4. Remove the rear seat parcel shelf. Refer to “Rear
Parcel Shelf” in this section.
5. Remove the rear speaker from the rear parcel shelf.
Refer to Section 9F, Audio Systems.
6. Remove the rear parcel side shelf.

Remove the screws (1).

Remove the rear parcel side shelf (2).
D109E567
Installation Procedure
1. Install the rear parcel side shelf with the screw.
2. Install the rear speaker to the rear parcel shelf. Refer
to Section 9F, Audio Systems.
3. Install the rear parcel shelf. Refer to “Rear Parcel
Shelf” in this section.
4. Install the seatback.
5. Connect the negative battery cable.
D109E568
FRONT ROCKER TRIM PANEL
Removal Procedure
1. Pry off the rocker trim panel.

Remove the clip (1).

Remove the screw (2).

Pry off the rocker trim panel (3).
D109E569
Installation Procedure
1. Install the rocker trim panel with the clip and the
screw.

9G –14 INTERIOR TRIM
DAEWOO M-150 BL2
D109E570
REAR ROCKER TRIM PANEL
Removal Procedure
1. Remove the rear seat cushion.
D110A508
2. Remove the rear seat belt bolt on the floor.

Remove the bolt (1).

Remove the spacer and the spring washer (2).

Remove the plastic protector from the seat belt an-
chor.
D109E571
3. Pry off the rear rocker trim panel.

Remove the screws securing the rear rocker trim
panel (1).

Remove the clip (2).

Pry off the rear rocker trim panel (3).
D109E572
Installation Procedure
1. Install the rear rocker trim panel with the screws and
the clip.
2. Install the rear seat belt bolt on the floor.
3. Install the rear seat cushion.

INTERIOR TRIM 9G–15
DAEWOO M-150 BL2
D19E573A
FLOOR CONSOLE
Removal Procedure
1. Remove the floor console screws.
D19E575A
2. Remove the gear shift lever boot cover and the floor
console.

Remove the gear shift lever boot cover (1).

Remove the screws (2).

Remove the floor console (3).
D19E576A
Installation Procedure
1. Install the floor console.
2. Install the gear shift lever boot cover to the floor con-
sole.
3. Tighten the floor console screws.
D109E577
PARKING BRAKE CABLE COVER
Removal Procedure
1. Remove the parking brake cable cover.

Remove the screw (1).

Remove the cable cover (2).

9G –16 INTERIOR TRIM
DAEWOO M-150 BL2
D109E578
Installation Procedure
1. Install the parking brake cable cover with the screw.
D109E581
FLOOR CARPET
(Left–Hand Drive Shown, Right–Hand
Drive Similar)
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the front seats. Refer to Section 9H, Seats.
3. Remove the rear seat cushion. Refer to Section 9H,
Seats.
4. Remove the floor console. Refer to “Floor Console”
in this section.
5. Pry off the front rocker trim panel. Refer to “Front
Rocker Trim Panel” in this section.
6. Pry off the rear rocker trim panel. Refer to “Rear
Rocker Trim Panel” in this section
7. Pry off the lower B–pillar trim panel. Refer to “Lower
B–pillar Trim Panel” in this section.
8. Remove the parking brake cable cover. Refer to
“Parking Brake Cable Cover” in this section.
9. Remove the clips under the front seats.
D109E582
11. Remove the floor carpet.
a. Floor carpet.

INTERIOR TRIM 9G–17
DAEWOO M-150 BL2
D109E583
Installation Procedure
1. Install the floor carpet.
2. Install the clips.
3. Install the parking brake cable cover. Refer to “Park-
ing Brake Cable Cover” in this section.
4. Install the lower B–pillar trim panel. Refer to “Lower
B–pillar Trim Panel” in this section.
5. Install the rear rocker trim panel. Refer to “Rear
Rocker Trim Panel” in this section.
6. Install the front rocker trim panel. Refer to “Front
Rocker Trim Panel” in this section.
7. Install the floor console. Refer to “Floor Console” in
this section.
8. Install the rear seat cushion. Refer to Section 9H,
Seats.
9. Install the front seats. Refer to Section 9H, Seats.
10. Connect the negative battery cable.
D109E584
LUGGAGE COMPARTMENT
WHEELHOUSE TRIM PANEL
Removal Procedure
1. Pry off the luggage compartment wheel house trim
panel.

Remove the screws (1).

Pry off the trim panel (2).
D109E585
Installation Procedure
1. Install the luggage compartment wheelhouse trim
panel with the plastic screws.

9G –18 INTERIOR TRIM
DAEWOO M-150 BL2
SPECIAL TOOLS AND EQUIPMENT
SPECIAL TOOLS TABLE
D109E101
KM-475-B
Trim Remover

DAEWOO M-150 BL2
SECTION 9H
SEATS
CAUTION: Disconnect the negative battery cable before removing or installing any electrical unit or when a
tool or equipment could easily come in contact with exposed electrical terminals. Disconnecting this cable
will help prevent personal injury and damage to the vehicle. The ignition must also be in B unless otherwise
noted.
TABLE OF CONTENTS
Description and Operation 9H-2. . . . . . . . . . . . . . . . . .
Seats 9H-2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Component Locator 9H-3. . . . . . . . . . . . . . . . . . . . . . . .
Front Seat 9H-3. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Rear Seat 9H-4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Repair Instructions 9H-5. . . . . . . . . . . . . . . . . . . . . . . . .
On-Vehicle Service 9H-5. . . . . . . . . . . . . . . . . . . . . . . . . .
Front Seats 9H-5. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Head Restraint 9H-5. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Front Seatback 9H-6. . . . . . . . . . . . . . . . . . . . . . . . . . . Front Seat Cushion 9H-7. . . . . . . . . . . . . . . . . . . . . . . .
Front Seats Guide Rail 9H-9. . . . . . . . . . . . . . . . . . . .
Front Seat Cushion Frame 9H-9. . . . . . . . . . . . . . . . . .
Rear Seatback 9H-10. . . . . . . . . . . . . . . . . . . . . . . . . . .
Rear Seat Cushion 9H-11. . . . . . . . . . . . . . . . . . . . . . .
Rear Seatback Latch 9H-11. . . . . . . . . . . . . . . . . . . . .
Rear Seatback Hinge 9H-12. . . . . . . . . . . . . . . . . . . . .
Specifications 9H-13. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Fastener Tightening Specifications 9H-13. . . . . . . . . .

9H – 2 SEATS
DAEWOO M-150 BL2
DESCRIPTION AND OPERATION
SEATS
Important: Do not attempt to change the designed seat
position by altering the designed seat adjuster-to-floor
pan anchor provisions or the seat adjuster-to-seat frame
anchor provisions. Changing the seat position could af-
fect the performance of the seat system.
This vehicle is equipped with low-backed front seats
with separate head restraints and a three-passengerfolding rear seat. Split folding rear seat is optional. Seats
cushions and seatbacks have formed foam pads, which
fit the contours of the full–panel seatback frame assem-
bly and the designed contour of the seat cushion frame.
There are no front seat forward or rearward relocation
provisions provided at either the seat adjuster–to–seat
frame or the seat adjuster–to–floor pan anchor attach-
ments.