2003 DAEWOO MATIZ Service Repair Manual

AUDIO SYSTEMS 9F–9
DAEWOO M-150 BL2
D109D557
FRONT SPEAKER COVERS
Removal Procedure
1. Remove the door trim panel. Refer to Section 9G, In-
terior Trim.
2. Remove the speaker cover from the door trim panel.

Remove the screws (1).

Remove the speaker cover (2).
D109D558
Installation Procedure
1. Install the speaker cover to the door trim panel with
the screws.
2. Install the door trim panel. Refer to Section 9G, Interi-
or Trim.
D109D559
REAR SPEAKERS
Removal Procedure
1. Disconnect the negative battery cable.
2. Open the tailgate.
3. Remove the rear speaker from the rear parcel side
shelf.

Disconnect the electrical connector (1).

Remove the screws (2).

Remove the rear speaker (3).
D109D560
Installation Procedure
1. Install the rear speaker to the rear parcel side shelf
with the screws.
2. Connect the electrical connector.
3. Connect the negative battery cable.

9F –10 AUDIO SYSTEMS
DAEWOO M-150 BL2
D109D561
ROOF ANTENNA
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the interior courtesy lamp. Refer to Section
9B, Lighting Systems.
3. Remove the roof antenna.

Remove the screw from the vehicle inside (1).

Remove the roof antenna (2).
D19D562A
3 Nm
Installation Procedure
1. Install the roof antenna with the screw.
Tighten
Tighten the roof antenna retaining screw to 3 Nm (27
lb-in).
a. Roof antenna retaining screw.
2. Install the interior courtesy lamp. Refer to Section 9B,
Lighting Systems.
3. Connect the negative battery cable.

AUDIO SYSTEMS 9F–11
DAEWOO M-150 BL2
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
ApplicationNmLb-FtLb-In
Roof Antenna Retaining Screw3–27

9F –12 AUDIO SYSTEMS
DAEWOO M-150 BL2
SCHEMATIC AND ROUTING DIAGRAMS
AUDIO SYSTEM CIRCUIT
(Left–Hand Drive Shown, Right–Hand Drive Similar)
D19D209B

DAEWOO M-150 BL2
SECTION 9G
INTERIOR TRIM
CAUTION: Disconnect the negative battery cable before removing or installing any electrical unit or when a
tool or equipment could easily come in contact with exposed electrical terminals. Disconnecting this cable
will help prevent personal injury and damage to the vehicle. The ignition must also be in B unless otherwise
noted.
TABLE OF CONTENTS
Description and Operation 9G-2. . . . . . . . . . . . . . . . . .
Interior Trim Panels 9G-2. . . . . . . . . . . . . . . . . . . . . . . .
Pressure Relief Vent 9G-2. . . . . . . . . . . . . . . . . . . . . . .
Floor Console 9G-2. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Parking Brake Cable Cover 9G-2. . . . . . . . . . . . . . . . .
Floor Carpet 9G-2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Component Locator 9G-3. . . . . . . . . . . . . . . . . . . . . . . .
Interior Trim 9G-3. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Repair Instructions 9G-4. . . . . . . . . . . . . . . . . . . . . . . . .
On-Vehicle Service 9G-4. . . . . . . . . . . . . . . . . . . . . . . . . .
Front Door Trim Panel (Standard) 9G-4. . . . . . . . . . .
Front Door Trim Panel (Deluxe) 9G-5. . . . . . . . . . . . .
Rear Door Trim Panel (Standard) 9G-6. . . . . . . . . . . .
Rear Door Trim Panel (Deluxe) 9G-7. . . . . . . . . . . . . .
Rear Door Interior Garnish Molding 9G-8. . . . . . . . . .
Rear Door Exterior Garnish Molding 9G-9. . . . . . . . . Tailgate Trim Panel 9G-9. . . . . . . . . . . . . . . . . . . . . . . .
A–Pillar Trim Panel 9G-10. . . . . . . . . . . . . . . . . . . . . . .
Upper B–Piller Trim Panel 9G-10. . . . . . . . . . . . . . . . .
Lower B–Pillar Trim Panel 9G-11. . . . . . . . . . . . . . . . .
C–Pillar Trim Panel 9G-11. . . . . . . . . . . . . . . . . . . . . . .
Rear Parcel Shelf 9G-12. . . . . . . . . . . . . . . . . . . . . . . .
Rear Parcel Side Shelf 9G-13. . . . . . . . . . . . . . . . . . . .
Front Rocker Trim Panel 9G-13. . . . . . . . . . . . . . . . . .
Rear Rocker Trim Panel 9G-14. . . . . . . . . . . . . . . . . . .
Floor Console 9G-15. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Parking Brake Cable Cover 9G-15. . . . . . . . . . . . . . . .
Floor Carpet 9G-16. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Luggage Compartment Wheelhouse
Trim Panel 9G-17. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Special Tools and Equipment 9G-18. . . . . . . . . . . . . .
Special Tools Table 9G-18. . . . . . . . . . . . . . . . . . . . . . .

9G –2 INTERIOR TRIM
DAEWOO M-150 BL2
DESCRIPTION AND OPERATION
INTERIOR TRIM PANELS
The interior trim panels are molded plastic and fasten
with screws or plastic clips.
PRESSURE RELIEF VENT
When all the windows are closed and the ventilation sys-
tem is on, the addition of outside air to the interior of the
vehicle causes a positive pressure within the vehicle. In
order to relieve the pressure, air is released through one
pressure relief vents. The pressure relief vent is located
in the luggage compartment, behind the spare wheel.
FLOOR CONSOLE
The floor console fits over the tunnel in the floor of the
vehicle and extends from under the center of the instru-
ment panel to the front seat area. The floor console con-
tains the transaxle shift lever and a cupholder.
The sensing and diagnosis module (SDM) for the airbag
system is located under the floor console.
PARKING BRAKE CABLE COVER
The parking brake cable cover should be removed to ad-
just the free play of the parking brake cable.
FLOOR CARPET
The molded one-piece floor carpet goes over both the
front and the rear floor pans.

INTERIOR TRIM 9G–3
DAEWOO M-150 BL2
COMPONENT LOCATOR
INTERIOR TRIM
D19E402A
1. A–Pillar Trim Panel
2. B–Pillar Upper Trim Panel
3. C–Pillar Trim Panel
4. Front Rocker Trim Panel
5. B–Pillar Lower Trim Panel
6. Rear Rocker Trim Panel
7. Rear Parcel Side Shelf8. Wheel House Trim Panel
9. Floor Console
10. Parking Brake Cable Cover
11. Console Cover Assembly
12. Deposit Box
13. Console Boot Assembly

9G –4 INTERIOR TRIM
DAEWOO M-150 BL2
REPAIR INSTRUCTIONS
ON–VEHICLE SERVICE
D109E532
FRONT DOOR TRIM PANEL
(STANDARD)
Tool Required
KM 475–B Trim Remover.
Removal Procedure
1. Remove the door pull from the front door.

Remove the screws (1).

Remove the door pull (2).
D109E533
2. Remove the inside door handle.

Remove the screw (1).

Disconnect the inside door handle rod (2).

Pry off the inside door handle (3).
D109E534
3. Remove the window regulator handle from the front
door.

Using a cloth, pull out the clip (1).

Remove the regulator handle (2).