2017 MAZDA MODEL CX-5 Owners Manual (in English)

7–3
If Trouble Arises
Flat Tire
Spare Tire and Tool Storage
Spare tire and tools are stored in the locations illustrated in the diag\
ram.
Tiedown eyelet Flat tire hold-down bolt
Jack lever
Lug wrench Jack
Type A
Type B
Tiedown eyelet
Flat tire hold-down bolt
Jack lever
Lug wrench Jack
Some models.
CX-5_8FN1-EA-16L_Edition1.indb 32016/12/12 10:07:18

7–4
If Trouble Arises
Flat Tire
Jack
To remove the jack
1. Open the luggage board, and lift it.

2. Remove the jack.


To secure the jack
Perform the removal procedure in reverse.
Maintenance
   Always keep the jack clean.  Make sure the moving parts are kept
free from dirt or rust.
   Make sure the screw thread is
adequately lubricated.

Spare Tire
Your Mazda has a temporary spare tire.
The temporary spare tire is lighter and
smaller than a conventional tire, and is
designed only for emergency use and
should be used only for VERY short
periods. Temporary spare tires should
NEVER be used for long drives or
extended periods.
WARNING
Do not install the temporary spare tire
on the front wheels (driving wheels): Driving with the temporary spare tire
on one of the front driving wheels is
dangerous. Handling will be aff ected.
You could lose control of the vehicle,
especially on ice or snow bound roads,
and have an accident. Move a regular
tire to the front wheel and install the
temporary spare tire to the rear.

CX-5_8FN1-EA-16L_Edition1.indb 42016/12/12 10:07:19

7–5
If Trouble Arises
Flat Tire
CAUTION
 When using the temporary spare tire, driving stability may decrease compared
to when using only the conventional tire.
Drive carefully.
 To avoid damage to the temporary spare tire or to the vehicle, observe the
following precautions:
 Do not exceed 80 km/h (50 mph). Avoid driving over obstacles. Also, do not drive through an automatic car
wash. This tire's diameter is smaller
than a conventional tire, so the
ground clearance is reduced.
 Do not use a tire chain on this tire because it will not fi t properly.
 Do not use your temporary spare tire on any other vehicle, it has been
designed only for your Mazda.
 Use only one temporary spare tire on your vehicle at the same time.


To remove the spare tire
1. Open the luggage board, and remove it.



2. For vehicles equipped with a sub- woofer, uncouple the connector.


Connector
NOTE
Extra strength may be required to
uncouple the connector. Be sure to squeeze
the tab fi rmly.

CX-5_8FN1-EA-16L_Edition1.indb 52016/12/12 10:07:19

7–6
If Trouble Arises
Flat Tire
3. For vehicles equipped with a sub-woofer, loosen the hold-down bolt and
remove the woofer and spare tire.



For vehicles not equipped with a sub- woofer, turn the spare tire hold-down
bolt counterclockwise and remove the
spare tire.

Spare tire hold-down bolt

To secure the spare tire
Store the spare tire in the reverse order
of removal. After storing, verify that the
spare tire is stored securely.
Changing a Flat Tire
NOTE
If the following occurs while driving, it
could indicate a fl at tire.
   Steering becomes dif fi cult.   The vehicle begins to vibrate
excessively.
  The vehicle pulls in one direction.
If you have a fl at tire, drive slowly to a
level spot that is well off the road and out
of the way of traf fi c to change the tire.
Stopping in traf fi c or on the shoulder of a
busy road is dangerous.
WARNING
Be sure to follow the directions for
changing a tire: Changing a tire is dangerous if not
done properly. The vehicle can slip off
the jack and seriously injure someone.
No person should place any portion
of their body under a vehicle that is
supported by a jack.

Never allow anyone inside a vehicle
supported by a jack: Allowing someone to remain in
a vehicle supported by a jack is
dangerous. The occupant could cause
the vehicle to fall resulting in serious
injury.

NOTE
Make sure the jack is well lubricated
before using it.

CX-5_8FN1-EA-16L_Edition1.indb 62016/12/12 10:07:19

7–7
If Trouble Arises
Flat Tire
1. Park on a hard, level surface off the right-of-way and fi rmly set the parking
brake.
2. Put a vehicle with an automatic transaxle in Park (P), a manual
transaxle in Reverse (R) or 1, and turn
off the engine.
3. Turn on the hazard warning fl asher.
4. Have everyone get out of the vehicle and away from the vehicle and traf fi c.
5. Remove the jack, tool, and spare tire (page 7-3 ).
6. Block the wheel diagonally opposite the fl at tire. When blocking a wheel,
place a tire block both in front and
behind the tire.


NOTE
When blocking a tire, use rocks or wood
blocks of suffi cient size if possible to hold
the tire in place.

Removing a Flat Tire
WARNING
When jacking-up a vehicle, always
shift the shift lever to 1st or R (manual
transaxle vehicle) or shift the selector
lever to P (automatic transaxle vehicle),
apply the parking brake, and place
wheel blocks in the position diagonally
opposed to the jack: Changing a fl at tire without using
wheel blocks is dangerous because
the vehicle may move and fall off the
jack even with the shift lever in 1st or
R, or the select lever is in P, which could
result in an accident.

1. If your vehicle is equipped with steel wheels, pry off the center cap with the
beveled end of the jack lever.



CAUTION
Use the jack lever when removing
the center cap. Using your hands to
remove it may cause an injury. In
addition, using a tool other than the
jack lever may cause damage to the
wheel or the center cap.

CX-5_8FN1-EA-16L_Edition1.indb 72016/12/12 10:07:19

7–8
If Trouble Arises
Flat Tire
2. Loosen the lug nuts by turning them counterclockwise one turn each, but do
not remove any lug nuts until the tire
has been raised off the ground.



3. Place the jack on the ground.
4. Turn the jack screw in the direction shown in the fi gure and adjust the jack
head so that it is close to the jack-up
position.


Jack head

5. Place the jack under the jack-up position closest to the tire being
changed with the jack head squarely
under the jack-up point.


Jacking position
6. Continue raising the jack head
gradually by rotating the screw with
your hand until the jack head is inserted
into the jack-up position.


Tire blocks Jacking position

CX-5_8FN1-EA-16L_Edition1.indb 82016/12/12 10:07:20

7–9
If Trouble Arises
Flat Tire
WARNING
Use only the front and rear jacking
positions recommended in this manual: Attempting to jack the vehicle
in positions other than those
recommended in this manual is
dangerous. The vehicle could slip off
the jack and seriously injure or even kill
someone. Use only the front and rear
jacking positions recommended in this
manual.

Do not jack up the vehicle in a position
other than the designated jack-up
position or place any objects on or
under the jack: Jacking up the vehicle in a position
other than the designated jack-up
position or placing objects on or
under the jack is dangerous as it could
deform the vehicle body or the vehicle
could fall off the jack resulting in an
accident.

Use only the jack provided with your
Mazda: Using a jack that is not designed for
your Mazda is dangerous. The vehicle
could slip off the jack and seriously
injure someone.

Never place objects under the jack: Jacking the vehicle with an object
under the jack is dangerous. The jack
could slip and someone could be
seriously injured by the jack or the
falling vehicle.

7. Insert the jack lever and attach the lug wrench to tire jack.



8. Turn the jack handle clockwise and raise the vehicle high enough so that
the spare tire can be installed. Before
removing the lug nuts, make sure your
Mazda is fi rmly in position and that it
cannot slip or move.



CX-5_8FN1-EA-16L_Edition1.indb 92016/12/12 10:07:20

7–10
If Trouble Arises
Flat Tire
WARNING
Do not jack up the vehicle higher than is
necessary: Jacking up the vehicle higher than
is necessary is dangerous as it could
destabilize the vehicle resulting in an
accident.

Do not start the engine or shake the
vehicle while it is jacked up: Starting the engine or shaking
the vehicle while it is jacked up is
dangerous as it could cause the vehicle
to fall off the jack resulting in an
accident.

Never go under the vehicle while it is
jacked up: Going under the vehicle while it is
jacked up is dangerous as it could
result in death or serious injury if the
vehicle were to fall off the jack.

9. Remove the lug nuts by turning them counterclockwise; then remove the
wheel and center cap.

Locking Lug Nuts
If your vehicle has Mazda optional
antitheft wheel lug nuts, one on each
wheel will lock the tires and you must
use a special key to unlock them. This
key will attach to the lug wrench.
Register them with the lock manufacturer
by fi lling out the card provided in the
glove compartment and mailing it in the
accompanying envelope. If you lose this
key, consult an Authorized Mazda Dealer
or use the lock manufacturer's order form,
which is with the registration card.
Accessory wheel locks cannot be used on
steel wheels. This includes situations when
the spare tire is installed. If the spare tire
is installed, one of the original lug nuts
(which should still be in the vehicle) must
be installed in place of the wheel lock.

Special key
Antitheft lug nut

To remove an antitheft lug nut
1. Obtain the special key for the antitheft lug nut.
2. Place the special key on top of the antitheft lug nut, and be sure to hold
the key square to it. If you hold the key
at an angle, you may damage both key
and nut. Do not use a power impact
wrench.
3. Place the lug wrench on top of the key and apply pressure. Turn the wrench
counterclockwise.

CX-5_8FN1-EA-16L_Edition1.indb 102016/12/12 10:07:20