2017 MAZDA MODEL CX-5 Owners Manual (in English)

4–25
When Driving
Instrument Cluster and Display
Average Fuel Economy
The average fuel economy is calculated
every minute from the total traveled
distance on the trip meter and the total
fuel consumption, and the average fuel
economy for either TRIP A or TRIP B is
displayed.


The average fuel economy and trip
meters can be reset by pressing the INFO
switch for 1.5 s or more while in each
mode. After the data is cleared, the fuel
consumption is recalculated and the
- - - L/100 km (- - - mpg) for the one
minute prior to it being displayed is
indicated.
Current Fuel Economy
This displays the current fuel economy
by calculating the amount of fuel
consumption and the distance traveled.



Maintenance Monitor
The following maintenance period
notifi cations can be displayed by turning
the Maintenance Monitor on.
   Scheduled Maintenance  Tire Rotation  Oil Change
For the setting method and indications
for the maintenance monitor, refer to the
Maintenance Monitor.
Refer to Maintenance Monitor on page
6-16 .
The maintenance monitor displays the
information when the ignition is switched
ON.
NOTE
This function is inoperable while the
vehicle is being driven.

Message display
When the remaining time or the distance
approaches 0, a message is displayed each
time the ignition is switched ON.


CX-5_8FN1-EA-16L_Edition1.indb 252016/12/12 10:05:45

4–26
When Driving
Instrument Cluster and Display
*Some models.
NOTE
  If any of the INFO switch is pressed
while a message is displayed, it will no
longer be displayed the next time the
ignition is switched ON.
  After the vehicle is serviced and the
remaining time/distance is reset, the
message for the next maintenance
period will be displayed when the
remaining distance or time to the next
maintenance period approaches 0
(displays when engine is started).
  If there are multiple messages, they are
displayed according to their order.
  If OFF is set for Messages, messages
are not displayed.

Blind Spot Monitoring (BSM) Display
Displays the system status.



Refer to Blind Spot Monitoring (BSM) on
page 4-99 .
Distance Recognition Support
System (DRSS) Display *
Displays the distance between your
vehicle and the vehicle ahead.



Refer to Distance Recognition Support
System (DRSS) on page 4-112 .
Mazda Radar Cruise Control with Stop & Go function (MRCC with
Stop & Go function) Display
*
Displays the currently set system status.



Refer to Mazda Radar Cruise Control with
Stop & Go function (MRCC with Stop &
Go function) on page 4-121 .
CX-5_8FN1-EA-16L_Edition1.indb 262016/12/12 10:05:45

4–27
When Driving
Instrument Cluster and Display
*Some models.
Lane-keep Assist System (LAS) & Lane Departure Warning System
(LDWS) Display
*
Displays the system status.



Refer to Lane-keep Assist System (LAS)
& Lane Departure Warning System
(LDWS) on page 4-135 .
Cruise Control Set Vehicle Speed
Display *
The vehicle speed preset using the cruise
control is displayed.



Refer to Cruise Control on page 4-168 .
Compass Display
The direction the vehicle is moving is
displayed while the vehicle is being
driven.



Display Direction
N North
S South
E East
W West


Warning (Display Indication)
A message is displayed to notify the user of the system operation status \
and malfunctions or
abnormalities.
If the warning light turns on/ fl ashes simultaneously or a symbol is indicated in the display,
check the information regarding the warning light or symbol. (page 4-32 )
When only a message is displayed, refer to Message Indicated in Multi-in\
formation Display.
(page 7-35 )
CX-5_8FN1-EA-16L_Edition1.indb 272016/12/12 10:05:46

4–28
When Driving
Instrument Cluster and Display
*Some models.
Active Driving Display *

Dust-proof sheet
Display
Optical
receiver
Windshield Type
Auto Flip-up Type
Combiner
Optical receiver
Mirror

WARNING
Always adjust the display brightness and position with the vehicle stopped:
Adjusting the display brightness and position while driving the vehicle is dangerous as
doing so could distract your attention from the road ahead and lead to an accident.

CX-5_8FN1-EA-16L_Edition1.indb 282016/12/12 10:05:46

4–29
When Driving
Instrument Cluster and Display
CAUTION
 (With Auto Flip-up Type)  Do not try to adjust the angle or open/close the active driving display manually.
Fingerprints on the display will make it diffi cult to view and using excessive force when
operating it could cause damage.
 (With Auto Flip-up Type)  Do not place objects in the vicinity of the active driving display. The active driving display
may not operate or any interference with its operation could cause damage.
 Do not place beverages near the active driving display. If water or other liquids are splashed on the active driving display, it could cause damage.
 Do not place objects above the active driving display or apply stickers to the dust-proof sheet/optical receiver as they will cause interference.
 A sensor is integrated to control the display's luminosity. If the optical receiver is covered, the display's luminosity will lower making the display diffi cult to view.
 Do not allow intense light to hit the optical receiver. Otherwise, it could cause damage.
NOTE
   Wearing polarized sunglasses will reduce the visibility of the active driving display due to
the characteristics of the display.
  If the battery has been removed and re-installed or the battery voltage is low, the adjusted
position may deviate.
  The display may be dif fi cult to view or temporarily affected by weather conditions such as
rain, snow, light, and temperature.
   If the audio system is removed, the active driving display cannot be operated.
CX-5_8FN1-EA-16L_Edition1.indb 292016/12/12 10:05:46

4–30
When Driving
Instrument Cluster and Display
The active driving display indicates the following information:   Blind Spot Monitoring (BSM) Operation Conditions and Warnings Refer to Blind Spot Monitoring (BSM) on page 4-99 .   Distance Recognition Support System (DRSS) Operation Conditions and Warnings Refer to Distance Recognition Support System (DRSS) on page 4-112 .   Traffi c Sign Recognition System (TSR) traf fi c signs and Warnings Refer to Traf fi c Sign Recognition System (TSR) on page 4-105 .    Mazda Radar Cruise Control with Stop & Go function (MRCC with Stop & Go\
function)
Operation Conditions and Warnings
 Refer to Mazda Radar Cruise Control with Stop & Go function (MRCC with \
Stop & Go function) on page 4-121 .
  Lane-keep Assist System (LAS) & Lane Departure Warning System (LDWS) Operation
Conditions and Warnings
 Refer to Lane-keep Assist System (LAS) & Lane Departure Warning System (LDWS) on page 4-135 .
  Smart Brake Support (SBS) Operation Conditions and Warnings Refer to Smart Brake Support (SBS) on page 4-153 .   Cruise Control Operation Conditions Refer to Cruise Control on page 4-167 .   Navigation Guidance (vehicles with navigation system)   Speed limit indicator (vehicles with navigation system)   Vehicle Speed
CX-5_8FN1-EA-16L_Edition1.indb 302016/12/12 10:05:47

4–31
When Driving
Instrument Cluster and Display
Each setting/adjustment for the active driving display can be performed \
on the center
display.

1. Select the icon on the home screen and display the Settings screen.
2. Select the AD-Disp tab.
3. Select the desired item and perform the setting/adjustment.
 Method for adjusting screen brightness (automatically/manually) Screen brightness initial settings (automatic adjustment is selected) Screen brightness adjustment (manual adjustment is selected) Display position of active driving display (display height) Active driving display angle adjustment (display angle correction) The combination of street name display, lane guidance, and turn by turn (TBT) can be changed. (navigation guidance)
 Active driving display ON/OFF (indication) Reset settings (reset)
NOTE
The desired driving position (display position, brightness level, display inform\
ation) can be
called up after programming the position.
Refer to Driving Position Memory on page 2-8 .

CX-5_8FN1-EA-16L_Edition1.indb 312016/12/12 10:05:47

4–32
When Driving
Instrument Cluster and Display
Warning/Indicator Lights
Instrument Cluster varies depending on model and specifi cations.

Center of Dashboard Warning/Indicator lights will appear in any of the highlighted areas
Type A
(With Multi-information Display)
(Without Multi-information Display)
Instrument Cluster
Type B

CX-5_8FN1-EA-16L_Edition1.indb 322016/12/12 10:05:47