2017 MAZDA MODEL CX-5 Owners Manual (in English)

6–29
Maintenance and Care
Owner Maintenance
Wiper Blades
CAUTION
 Hot waxes applied by automatic car washers have been known to aff ect the
wiper's ability to clean windows.
 To prevent damage to the wiper blades, do not use gasoline, kerosene, paint
thinner, or other solvents on or near
them.
 When the wiper lever is in the AUTO position and the ignition is switched ON,
the wipers may move automatically in
the following cases:
 If the windshield above the rain sensor is touched.
 If the windshield above the rain sensor is wiped with a cloth.
 If the windshield is struck with a hand or other object.
 If the rain sensor is struck with a hand or other object from inside the vehicle.
 Be careful not to pinch hands or fi ngers as it may cause injury, or damage the
wipers. When washing or servicing the
vehicle, make sure the wiper lever is in
the OFF position.

Contamination of either the windshield or
the blades with foreign matter can reduce
wiper effectiveness. Common sources are
insects, tree sap, and hot wax treatments
used by some commercial car washes.

If the blades are not wiping properly,
clean the window and blades with a good
cleaner or mild detergent; then rinse
thoroughly with clean water. Repeat if
necessary.
Replacing Windshield Wiper Blades
When the wipers no longer clean well, the
blades are probably worn or cracked.
Replace them.
CAUTION
 To prevent damage to the wiper arms
and other components, do not try to
sweep the wiper arm by hand.
 Do not bend the blade rubber unnecessarily when replacing it.
Otherwise, the metal stiff ener in the
blade may deform and the windshield
wiper operation may be adversely
aff ected.

NOTE
When raising both windshield wiper arms,
raise the driver's side wiper arm fi rst.
When lowering the wiper arms, slowly
lower the wiper arm from the passenger's
side fi rst while supporting it with your
hand. Forcefully lowering the wiper arms
could damage the wiper arm and blade,
and may scratch or crack the windshield.

CX-5_8FN1-EA-16L_Edition1.indb 292016/12/12 10:07:09

6–30
Maintenance and Care
Owner Maintenance
1. Raise the wiper arm.
CAUTION
To prevent damage to the windshield
let the wiper arm down easily, do not
let it slap down on the windshield.

2. Slide the blade component in the direction of the arrow while pressing
the wiper arm tab to remove the blade
component from the wiper arm.


3. Pull the blade rubber in the direction
of the arrow and slide it to a position
where the blade holder groove can be
checked.

Groove
CX-5_8FN1-EA-16L_Edition1.indb 302016/12/12 10:07:09

6–31
Maintenance and Care
Owner Maintenance
4. Pull the end of the blade rubber from the blade holder groove in the direction
of the arrow and remove the blade
rubber from the blade holder.


Groove
5. Insert the end of the new blade rubber
into the groove of the blade holder until
it contacts the end of the blade holder.


Groove

CX-5_8FN1-EA-16L_Edition1.indb 312016/12/12 10:07:09

6–32
Maintenance and Care
Owner Maintenance
6. After pulling the blade rubber in the direction of the arrow and sliding the
blade rubber to a position to check the
blade holder groove, slide the blade
rubber end in the opposite direction.


Groove

7. Make sure that the blade rubber is correctly installed to the blade holder.
8. Align the wiper arm tabs with the blade component grooves.


Tabs
Grooves
9. Align the blade component projection
with the wiper arm notch.


Notch
Projection

10. Slide the blade component and install it to the wiper arm.



11. Slowly lower the wiper arm onto the windshield.

Replacing Rear Window Wiper Blade
When the wiper no longer cleans well, the
blade is probably worn or cracked.
Replace it.
CAUTION
To prevent damage to the wiper arm
and other components, do not move
the wiper by hand.

CX-5_8FN1-EA-16L_Edition1.indb 322016/12/12 10:07:10

6–33
Maintenance and Care
Owner Maintenance
1. Remove the cover and raise the wiper arm.


2. Firmly rotate the wiper blade to the right until it unlocks, then remove the
blade.


CAUTION
To prevent damage to the rear window,
do not let the wiper arm fall on it.

3. Pull down the blade rubber and slide it out of the blade holder.


4. Remove the metal stiffeners from the blade rubber and install them in the
new blade.


CAUTION
Do not bend or discard the stiff eners.
You need to use them again.

5. Carefully insert the new blade rubber.
Then install the blade assembly in the reverse order of removal.


CX-5_8FN1-EA-16L_Edition1.indb 332016/12/12 10:07:10

6–34
Maintenance and Care
Owner Maintenance
Battery
WARNING
Wash hands after handling the battery and related accessories: Battery posts, terminals and related accessories contain lead and lead compounds,
chemicals known to the State of California to cause cancer and reproductive harm.


Read the following precautions carefully before using the battery or inspecting
to ensure safe and correct handling:

Always wear eye protection when working near the battery:
Working without eye protection is dangerous. Battery fl uid contains SULFURIC ACID
which could cause blindness if splashed into your eyes. Also, hydrogen gas produced
during normal battery operation, could ignite and cause the battery to explode.


Wear eye protection and protective gloves to prevent contact with battery fl uid:
Spilled battery fl uid is dangerous.
Battery fl uid contains SULFURIC ACID which could cause serious injuries if it gets in eyes,
or on the skin or clothing. If this happens, immediately fl ush your eyes with water for
15 minutes or wash your skin thoroughly and get medical attention.


Always keep batteries out of the reach of children:
Allowing children to play near batteries is dangerous. Battery fl uid could cause serious
injuries if it gets in the eyes or on the skin.


Keep fl ames and sparks away from open ba ttery cells and do not allow metal
tools to contact the positive (
) or negative ( ) terminal of the battery when working
near a battery. Do not allow the positive (
) terminal to contact the vehicle body:
Flames and sparks near open battery cells are dangerous. Hydrogen gas, produced
during normal battery operation, could ignite and cause the battery to explode. An
exploding battery can cause serious burns and injuries. Keep all fl ames including
cigarettes and sparks away from open battery cells.

CX-5_8FN1-EA-16L_Edition1.indb 342016/12/12 10:07:11

6–35
Maintenance and Care
Owner Maintenance
Keep all fl ames, including cigarettes, and sparks away from open battery cells:
Flames and sparks near open battery cells are dangerous. Hydrogen gas, produced
during normal battery operation, could ignite and cause the battery to explode. An
exploding battery can cause serious burns and injuries.

NOTE
Before performing battery maintenance, remove the battery cover.



CX-5_8FN1-EA-16L_Edition1.indb 352016/12/12 10:07:11

6–36
Maintenance and Care
Owner Maintenance
Battery Maintenance

To get the best service from a battery:
   Keep it securely mounted.  Keep the top clean and dry.  Keep terminals and connections clean,
tight, and coated with petroleum jelly or
terminal grease.
   Rinse off spilled electrolyte immediately
with a solution of water and baking
soda.
   If the vehicle will not be used for an
extended time, disconnect the battery
cables and charge the battery every six
weeks.

Battery Replacement
Contact an Authorized Mazda Dealer for a
battery replacement purchase.
Key Battery Replacement
If the buttons on the transmitter are
inoperable and the operation indicator
light does not fl ash, the battery may be
dead.
Replace with a new battery before the
transmitter becomes unusable.
CAUTION
 Make sure the battery is installed correctly. Battery leakage could occur if it
is not installed correctly.
 When replacing the battery, be careful not to touch any of the internal circuitry
and electrical terminals, bend the
electrical terminals, or get dirt in the
transmitter as the transmitter could be
damaged.
 There is the danger of explosion if the battery is not correctly replaced.
 Dispose of used batteries according to the following instructions.
 Insulate the plus and minus terminals of the battery using cellophane or
equivalent tape.
 Never disassemble. Never throw the battery into fi re or water.
 Never deform or crush.  Replace only with the same type battery (CR2025 or equivalent).

CX-5_8FN1-EA-16L_Edition1.indb 362016/12/12 10:07:11