Page 177 of 585

uuInterior Lights/Interior Convenience ItemsuInterior Convenience Items
176
Controls
■ When charging does not start
Perform one of the solution s in the following table.
IndicatorCauseSolution
Green
&
AmberBlinking
simulta- neously
There is an obstacle(s) between
the charging area and the
device.Remove the
obstacle(s).
The device is not within the
charging area. Move the device to the
center of the charging
area where is
located.
AmberBlinkingThe wireless charger is faulty.Contact a dealer for repairs.
1Wireless Charger
*
NOTICE
Do not place any magneti
c recording media or
precision machines within the charging area while charging.
The data on your cards such as credit cards can be
lost because of the magnetic effect. This magnetic
effect can also affect th e operation of precision
machines such as watches.
“Qi” and marks are the registered trademarks
owned by Wire less Power Consortium (WPC).
In the following cases, ch arging may stop or not start:
• The device is already fully charged.
• The temperature of the device is extremely high while charging.
• You are at a place that emits strong
electromagnetic wave or noises, such as a TV
station, electric power plant, or gas station.
A device may not charge if the size or shape of its rechargeable
side is not appropriate for use with the charging area.
Not all devices are compatible with the system.
During the charging phase, it is normal for the charging area and device to heat up.
Changing may be briefl y interrupted when:
• Both doors and the trunk are closed
- to avoid interference with the proper functioning
of the smart entry system.
• The position of the device is altered.
Do not charge more than one device at a time on a
charging area.
* Not available on all models
16 CIVIC 2D HC2 (0A 01 0C)-31TBG6000.book 176 ページ >0>.>/6年>0月>/>0日 金曜日 午後4時>/6分
Page 178 of 585
Continued177
uuInterior Lights/Interior Convenience ItemsuInterior Convenience Items
Controls
There are coat hooks behind the center pillar
on both sides. Pull them down to use them.
■Coat Hooks1Coat Hooks
The coat hook is not designed for large or heavy
items.
16 CIVIC 2D HC2 (0A 01 0C)-31TBG6000.book 177 ページ >0>.>/6年>0月>/>0日 金曜日 午後4時>/6分
Page 179 of 585

uuInterior Lights/Interior Convenience ItemsuInterior Convenience Items
178
Controls
The ignition switch must be in ON (w *1
to use
the seat heaters. The HI setting heats the seats
faster than the LO setting.
Press the seat heater button:
Once - The HI setting (three indicators on)
Twice - The MID setting (two indicators on)
Three times - The LO setting
Four times - The OFF se tting (no indicators on)
When a comfortable temperature is reached
while using the seat heaters in HI, select MID
or LO to keep the seat warm.
*1: Models with the smart entry system have an ENGINE START/STOP button instead of an
ignition switch.
■Seat Heaters *1Seat Heaters
*
Do not use the seat heaters even in LO when the
engine is off. Under such conditions, the battery may
be weakened, making the engine difficult to start.
3WARNING
Heat induced burns are possible when
using seat heaters.
Persons with a diminished ability to sense
temperature (e.g., persons with diabetes,
lower-limb nerve damage, or paralysis) or
with sensitive skin should not use seat
heaters.
* Not available on all models
16 CIVIC 2D HC2 (0A 01 0C)-31TBG6000.book 178 ページ >0>.>/6年>0月>/>0日 金曜日 午後4時>/6分
Page 180 of 585

179
Continued
Controls
Climate Control System
Using Automatic Climate Control
The automatic climate control
system maintains the interior temperature you select.
The system also selects the proper mix of heat ed or cooled air that raises or lowers
the interior temperature to your pr eference as quickly as possible.
Use the system when the engine is running. 1. Press the AUTO button.
2. Adjust the interior temperature us ing the temperature control dial.
3. Press the (on/off) button to cancel.
1Using Automatic Climate Control
If any buttons are presse d while using the climate
control system in auto, the function of the button
that was pressed will take priority.
The AUTO indicator will go off, but functions
unrelated to the button that were pressed will be
controlled automatically.
To prevent cold air from bl owing in from outside, the
fan may not start i mmediately when the AUTO
button is pressed.
If the interior is very warm, you can cool it down
more rapidly by partial ly opening the windows,
turning the system on AUTO, and setting the
temperature to low. Change the fresh mode to
recirculation mode until the temperature cools down.
When you set the temperat ure to the lower or upper
limit, Lo or Hi is displayed.
Models with color audio systemModels with Display Audio
Models without SYNC button
16 CIVIC 2D HC2 (0A 01 0C)-31TBG6000.book 179 ページ >0>.>/6年>0月>/>0日 金曜日 午後4時>/6分
Page 181 of 585
uuClimate Control SystemuUsing Automatic Climate Control
180
Controls
Use the system when the engine is running. 1. Press the AUTO button.
2. Adjust the interior temperature using the dr iver’s side or passenger’s side control
dial.
3. Press the butto n to cancel.
1Using Automatic Climate Control
Pressing the button switches the climate control
system between on and off. When turned on, the
system returns to your last selection.
While in the ECON mode, the climate control system
has greater temperature fluctuations.Models with Display Audio
Models with SYNC button
16 CIVIC 2D HC2 (0A 01 0C)-31TBG6000.book 180 ページ >0>.>/6年>0月>/>0日 金曜日 午後4時>/6分
Page 182 of 585

181
uuClimate Control SystemuUsing Automatic Climate Control
Continued
Controls
■Switching between the recirc ulation and fresh air modes
Press the (recirculation) button a nd switch the mode depending on
environmental conditions.
Recirculation mode (indicator on): Recirculat es air from the vehicle’s interior through
the system.
Fresh air mode (indicator off): Maintains outside ventilation. Keep the system in
fresh air mode in normal situations.
Press the (recirculation) or (fre sh air) button to switch the mode
depending on environmental conditions. Recirculation mode (indicator on): Reci rculates air from the vehicle’s interior
through the system. Fresh air mode (indicator on): Maintain s outside ventilation. Keep the system
in fresh air mode in normal situations.
Models with color audio system
Models with Display Audio
Models with SYNC button
Models with Display Audio
Models without SYNC button
16 CIVIC 2D HC2 (0A 01 0C)-31TBG6000.book 181 ページ >0>.>/6年>0月>/>0日 金曜日 午後4時>/6分
Page 183 of 585
uuClimate Control SystemuUsing Automatic Climate Control
182
Controls
Pressing the (windshield defroster) button
turns the air conditioning system on and
automatically switches th e system to fresh air
mode.
Press the button again to turn off, the
system returns to the previous settings.
■Defrosting the Windshield and Windows1Defrosting the Windshield and Windows
For your safety, make sure you have a clear view
through all the windows before driving.
Do not set the temperatur e near the upper or lower
limit.
When cold air hits the windshield, the outside of the
windshield may fog up.
If the side windows fog up, adjust the vents so that
the air hits th e side windows.
16 CIVIC 2D HC2 (0A 01 0C)-31TBG6000.book 182 ページ >0>.>/6年>0月>/>0日 金曜日 午後4時>/6分
Page 184 of 585
183
uuClimate Control SystemuUsing Automatic Climate Control
Controls
■To rapidly defrost the windows
1.Press the button.
2. Press the button.1To rapidly defrost the windows
After defrosting the windows, switch over to fresh air
mode. If you keep the syst em in recirculation mode,
the windows may fog up from humidity. This
impedes visibility.
16 CIVIC 2D HC2 (0A 01 0C)-31TBG6000.book 183 ページ >0>.>/6年>0月>/>0日 金曜日 午後4時>/6分