2012 SSANGYONG KORANDO Service Manual

03-278710-01
5) Seat Belt
Seat belt warning ▶
When turning the ignition switch (IGN1) to ON from OFF position, the BCM sends the driver and front
passenger seat belt warning signals to the instrument cluster module through the CAN
communication, and the buzzer sounds for 0.6 seconds with the interval of 0.02 s ON and 1.38 s
OFF. If the driver/passenger seat belts are fastened, the buzzer does not sound but the warning lamp
blinks during the period. (the buzzer is controlled by BCM and the warning lamp is controlled by ICM)
For the passenger seat, however, the system detects if the passenger seat is empty or occupied and
operates the warning lamp only for the first time.
After that, the only seat belt reminder detects if the passenger seat is occupied.
For the driver seat, the seat belt reminder operates only when the seat belt is not fastened at the
vehicle speed of 25 km/h or higher.
The instrument cluster module controls the driver/passenger seat belt warning lamps by receiving the
driver/passenger seat belt warning lamp signals.
When turning the ignition switch (IGN1) to OFF position during the warning operation, the buzzer
stops and the warning lamp goes off.
If the driver/passenger seat belt is fastened during the warning operation, the buzzer stops but the
warning lamp blinks for the remaining time of the period.
If the driver/passenger seat belt signal changes to "unfastened" from "fastened" with IGN1 ON, the
driver/passenger seat belt warning lamp comes on and the buzzer sounds again for 0.6 seconds.
But, if the condition for seat belt reminder operation is met during the warning operation, the warning
operation stops and the seat belt reminder function is activated. 1.
2.
3.
4.
5.

03-28
Seat belt reminder ▶
Operating conditions for seat belt reminder are as follows: IGN ON, engine running (over 300 rpm),
vehicle speed of 25 km/h or higher, driver seat belt unfastened, passenger seat belt unfastened and
passenger seat occupied. In addition, if the seat belt reminder is activated at the speed of 25 km/h or
higher and the speed reduces to below 25 km/h within 5 minutes, the interior buzzer sound stops. The
buzzer sounds for 5 minutes again when the speed is 25 km/h or higher.
The seat belt reminder stops its operation when fastening the seat belt, but starts the operation again if
unfastening the seat belt.
If the seat belt reminder is initially operated due to unfastened driver seat belt, the buzzer sounds with
the interval of 0.02s ON/1.18s OFF, the instrument cluster sends the driver seat belt warning signal
(SBR) and the seat belt warning lamp stays on.
At this time, the buzzer sounds for 5 minutes.
If the seat belt reminder is operated due to unfastened passenger seat belt when the passenger seat
belt reminder sensor detects that the passenger seat is occupied, the instrument cluster sends the
driver seat belt warning signal and the seat belt warning lamp stays on.
For this case, the indicator shows each status of the driver and passenger seats but the indoor buzzer
is common to both seats.
If the simultaneous operating condition for the indoor buzzer is met, the driver seat has the priority.
If the driver seat belt is fastened, the same operation is also carried out in the passenger seat
automatically.
The buzzer and the warning lamp are operated according to the vehicle speed as below table during
the seat belt reminder operation. 1.
2.
3.
4.
5.
Seat belt reminder operation
<007700990090009600990090009b00a000470096008d00470089009c00a100a1008c0099004700960097008c00990088009b00900096009500610047007a0069007900470d7d00470072008c00a000470099008c009400900095008b008c00990047009e00
880099009500900095008e00470d7d0047007a009c00950099>oof warning ⇒ Tail lamp ON
<009e00880099009500900095008e00470d7d0047006f008800a100880099008b0047009e00880099009500900095008e0047008d00930088009a008f008c009900470d7d0047007b009c009900950047009a0090008e009500880093004700930088009400
970055> 6.
Buzzer Warning lamp
25 Km/h ~ 49 Km/h 0.02s ON / 1.18s OFF Keep ON
50 Km/h ~ 99 Km/h 0.02s ON / 0.98s OFF Keep ON
10 Km/h ~ 49 Km/h 0.02s ON / 0.78s OFF Keep ONFunction
Vehicle speed
Seat belt remind warning lamp (EU only)
This lamp comes on for 6 seconds after turning on the ignition switch. If the vehicle speed goes
over 10 km/h without fastened the seat belt, the inside buzzer sounds. -

03-298710-01

03-30
6) Sunroof
Sunroof warning ▶
When removing the ignition key with the sunroof open (without SKM) or when opening the driver door
with IGN OFF or ACC and sunroof open (with SKM), the indoor buzzer sounds for 10 seconds with
the interval of 0.02s ON/1.58s OFF.
When opening and closing the driver door or closing the sunroof during indoor buzzer operation, the
buzzer stops its operation immediately.
When closing the driver door or sunroof and opening again during warning operation, the sunroof
warning does not work. If the condition is met after the ignition switch is turned to "ON" position again,
the indoor buzzer sounds for 10 seconds with the interval of 0.02s ON/1.58s OFF.
The sunroof warning has a priority over the tail lamp ON warning. 1.
2.
3.
4.

03-318710-01
7) Room Lamp
Door coupled room lamp and dimming control ▶
When opening any of doors while the room lamp switch in overhead console is pressed in ("Door"
coupled position), the room lamps come on. If the key is removed and door stays open, the room lamps
automatically goes off after 10 minutes. The sleep mode will be deactivated when the door is locked or
closed with the lamp OFF automatically.
When closing the door with IGN ON, the room lamps go off immediately.
When closing the door with IGN OFF, the room lamps stays on for 2 seconds and are dimmed out for
3 seconds.
When turning the ignition switch to ON position during dimming out operation, the room lamps go off
immediately.
When receiving the door unlock signal with IGN OFF, key removed and door closed, the room lamps
come on for 30 seconds. (It operates depending on REKES unlock and manual unlock signals for
BCM with SKM.)
4. When receiving the door unlock signal again in Step (4), the overhead room lamp and center room
lamp stay on for 30 seconds additionally. (For BCM with SKM, the extension depends on the REKES
unlock signal.)
When opening a door during the linked and dimming operation, the room lamps stays ON. When
closing it again, the system performs the operation in Step (1) and (2).
When all the door switches are changed from its closing state to its opening state, the room lamps are
dimmed out. The room lamps go off immediately when entering into the theft deterrent mode. (For
BCM with SKM, door lock is carried out by the REKES lock and manual lock signals.)
The room lamps come on when the auto approach function is activated. 1.
2.
3.
4.
5.
6.
7.
8.Room lamp control by door coupled room lamp operation ▶

03-32
8) Key Hole Illumination
When opening the door with IGN OFF, the key hole lamp comes on.
When closing the door, the key hole lamp stays on for 10 seconds and goes off.
When turning the ignition switch to ON position during the operation of key hole illumination, it goes of
f
immediately.
When receiving the door lock signal (entering into theft deterrent mode), the lamp goes off.
The key hole illumination function has a priority over the immobilizer function.
If the communication with the immobilizer is interrupted, the lamp comes on for 11 seconds with the
interval of 0.5s ON/0.5s OFF regardless of the operating conditions of key hole lamp.
When turning the ignition switch to ON position in "Virgin" condition, the lamp comes on for 8 seconds
with the interval of 0.5s ON/0.5s OFF. 1.
2.
3.
4.
5.
6.
(*1) ON: IGN ON
OFF: IGN OFF(*2) Open: driver or passenger door is open
Close: driver and passenger door are closed
Room lamp OFF control ▶
The room lamps stop operating when the BCM enters into the theft deterrent or sleep mode. (This is
to prevent battery discharge if the overhead room lamp and sensor room lamp switch is ON position.)
The room lamps go off automatically 10 minutes after the key is removed. After that, if the door unlock
or all door open signal is received and the key is inserted, the sleep mode is deactivated and the room
lamps operate for another 10 minutes.
The room lamps come on when the key is inserted (BCM without SKM) or the ignition switch is turned
to "ACC" or "ON" position (BCM with SKM) while the room lamps are OFF. 1.
2.
3.

03-338710-01
9) Defogger (Heated Wire) Timer
Front defogger timer control ▶
When turning ON the front defogger switch with IGN2 ON (engine speed over 300 rpm), the front
defogger operates for 12 minutes.
When turning OFF the front defogger switch during the operation, the defogger stops working.
If turning ON the defogger again within 10 minutes after completion of the first 12 minute operation, the
defogger additionally operates for 6 minutes one time only. (However, this not applied if the defogger
has been turned off by engine stop or defogger switch)
The defogger stops working when the ignition switch is turned to OFF position or engine speed is lower
than 300 rpm. 1.
2.
3.
4.

03-34
Rear defogger timer control ▶
When turning ON the rear defogger switch with IGN2 ON (engine speed over 300 rpm), the rear
defogger and outside rearview mirror defogger operate for 12 minutes.
When turning OFF the rear defogger switch during the operation, the defogger stops working.
If turning ON the defogger again within 10 minutes after completion of the first 12 minute operation, the
defogger additionally operates for 6 minutes one time only. (However, this not applied if the defogger
has been turned off by engine stop or defogger switch)
The defogger stops working when the ignition switch is turned to OFF position or engine speed is lower
than 300 rpm. 1.
2.
3.
4.