2020 MITSUBISHI L200 Owner's Manual (in English)

CAUT,ONzInstallation of audio equipment or repairs in
the vicinity of the pretensioner seat belts or
floor console must be performed in line with MITSUBISHI MOTORS guidelines. It is
important to do so because the work could affect the pretensioner systems.
z If you need to scrap the vehicle, please con-
sult a MITSUBISHI MOTORS Authorized
Service Point. It is important to do so be- cause unexpected activation of the preten-
sioner seat belts could cause injuries.NOTEz The pretensioner seat belts will be activated
if the vehicle suffers a severe impact, even if
the seat belts are not worn.
z The pretensioner seat belts are designed to
work only once. After the pretensioner seat
belts have been activated, we recommend
you to have them replaced by a MITSUBISHI MOTORS Authorized Serv-
ice Point.SRS warning
The same warning lamp/display is shared by
the SRS airbags and the pretensioner seat belts.
Refer to “SRS warning lamp/display” on page 4-34.
Force limiter system
In the event of a collision, each force limiter
system will effectively absorb the load ap- plied to the seat belt so as to minimize the
impact to the passenger.
Child restraint
When transporting children in your vehicle, some type of child restraint system should al-
ways be used according to the size of the child. This is required by law in most coun-
tries.
The regulations concerning driving with chil- dren in the front seat may differ from country
to country. You are advised to comply with the relevant regulations.
:ARN,NGz When possible, put children in the rear
seat. Accident statistics indicate that chil-
dren of all sizes and ages are safer when properly restrained in the rear seat rather than in the front seat.
z Holding a child in your arms is no substi-
tute for a restraint system. Failure to use
a proper restraint system can result in se-
vere or fatal injury to the child.
z Each child restraint device or fixing is to
be used only by one child.:ARN,NGz When attaching a child restraint system
to the rear seat, adjust the front seat toprevent the front seatbacks from touching
the child

:ARN,NGzExtreme Hazard!
NEVER use a rearward facing child re- straint on a seat protected by an ACTIVEAIRBAG in front of it, DEATH or SERI-
OUS INJURY to the CHILD can occur.NOTEz The labels may be in different positions de-
pending on the vehicle model.
Use rearward facing child restraints in the
rear seat or turn off the front passenger’s air- bag ON-OFF switch. Refer to “To turn an air-
bag off” on page 4-27.
:ARN,NGz A REARWARD FACING CHILD RE-
STRAINT must NOT be used in the front passenger seat if the front passenger

:ARN,NGzWhen installing a child restraint system,
refer to the instructions provided by the manufacturer of the restraint system.
Failure to do so can result in severe or fa- tal injury to the child.
z After installation, push and pull the child
restraint system back and forth, and side
to side, to see that it is properly secured. If
the child restraint system is not installed securely, it may cause injury to the childor other occupants in the case of accident
or sudden stops.
z When the child restraint system is not in
use, keep your child restraint system fixed
firmly or remove it from the vehicle in or- der to prevent it from being thrown
around inside the vehicle during an acci- dent.NOTEz Depending on the seating position in the ve-
hicle and the child restraint system that you have, the child restraint can be attached us-
ing one of the following two locations:

Suitability for various ISOFIX positions (Double cab)
Mass groupSize classFixture
Vehicle ISO-
FIX positions* 1Recommended Child
Restraint Systems* 2UN-R44 Approval
No.UN-R129 Approval No.Rear outboardCarrycotFISO/L1X

For detailed information, consult your MITSUBISHI MOTORS Authorized Service Point.CAUT,ONzWhen installing a child restraint system, remove the head restraint from the seat.
z When attaching a child restraint system to the rear seat, adjust the front seat to prevent the front seatbacks from touching the child’s feet and child restraint
system.
z “BABY-SAFE i-SIZE” and “BABY-SAFE i-SIZE FLEX BASE” are designed for children 40-83 cm in height.Definition of characters to be inserted in the table above:
z
IUF- Suitable for ISOFIX forward restraint child restraint systems of universal category approved for use in the mass group.
z IL- Suitable for ISOFIX child restraint systems of semi-universal category approved for use in the mass group.
z IL# - Suitable for particular ISOFIX child restraint systems of MITSUBISHI MOTORS GENUINE Parts.
See the above table of “Recommended Child Restraint Systems”
z X- ISOFIX position not suitable for ISOFIX child restraint systems in this mass group.

i-Size child restraint system (Double cab) Seating Position* 1Recommended Child
Restraint Systems* 2UN-R129 Approval
No.Front passengerSecond outboardRear centre
i-Size child restraintsystemXi-UX
BABY-SAFE i-SIZE:MZ315055
BABY-SAFE i-SIZE FLEX BASE:MZ315056
E1-000008
*1
: Vehicles with i-Size marking. (Refer to “Lower anchorage location” on page 4-20.)
* 2
: MITSUBISHI MOTORS Europe B.V. reserves the right to changes without any prior announcement.
For detailed information, consult your MITSUBISHI MOTORS Authorized Service Point.
Child restraint
4-152.7(20(1Seat and seat belts4

CAUT,ONz“BABY-SAFE i-SIZE” and “BABY-SAFE i-SIZE FLEX BASE” are designed for children 40-83 cm in height, and up to 13 kg in weight.Definition of characters to be inserted in the table above:
z
i-U- Suitable for i-Size “universal” child restraint system forward and rearward facing.
z X- Seating position not suitable for i-Size “universal” child restraint systems.

Suitability for various seating positionsClub cab
Mass group
Seating position
Recommended Child Restraint Systems *1UN-R44
Approval No.UN-R129
Approval No.
Front passengerRear Out- boardActivated air- bagDeactivated
airbag *20 - Up to 10 kgXUX

CAUT,ONzWhen installing a child restraint system, remove the head restraint from the seat. However, do not remove the head restraint when installing a booster cush-
ion (see 4-22.)
z When installing a child restraint system (Mass group II & III) on the front passenger seat, please move the seatbacks position to 2 steps rearward from
upright position.
z “BABY-SAFE i-SIZE” is designed for children 40-83 cm in height.Definition of characters to be inserted in the table above:
z
U- Suitable for “universal” category restraints approved for use in this mass group.
z L#- Suitable for particular child restraint systems of
MITSUBISHI MOTORS GENUINE Parts. See the above table of “Recommended
Child Restraint Systems”.
z X- Seating position not suitable for children in this mass group.
Double cab
Mass group
Seating position Recommen-
ded ChildRestraint
Systems *1
UN-R44
Approval No.UN-R129
Approval No.
Front passengerRear Out- boardRear centre
Activated air- bagDeactivated
airbag *20 - Up to 10 kgXUUU

Mass group
Seating position Recommen-ded ChildRestraint
Systems *1
UN-R44
Approval No.UN-R129
Approval No.
Front passengerRear Out- boardRear centre
Activated air- bagDeactivated
airbag *2II & III - 15 kg to
36 kgXU *3
, L#U*3
, L#XKIDFIX XP:
MZ315025E1-04301304