2020 MITSUBISHI L200 Owner's Manual (in English)

To turn them off, push the switch again.NOTEzOn vehicles equipped with the emergency
stop signal system, while the hazard warning lamps are blinking due to having manually
pushed the switch, the emergency stop signal
system does not operate.
Refer to “Emergency stop signal system” on page 6-72.Fog lamp switchFront fog lamp switch*
The front fog lamps can be operated while
the headlamps or tail lamps are on. Turn the
knob in the “ON” direction to turn on the front fog lamps. An indication lamp in the in-
strument cluster will also come on. Turn the knob in the “OFF” direction to turn off the front fog lamps. The knob will automatically
return to its original position when you re- lease it.
NOTEz The front fog lamps are automatically turned
off when the headlamps or tail lamps are turned off. To turn the front fog lamps on again, turn the knob in the “ON” directionafter turning on the headlamps or tail lamps.NOTEz Do not use fog lamps except in conditions of
fog, otherwise excessive lamp glare maytemporarily blind oncoming vehicle drivers.Rear fog lamp switch*
The rear fog lamp can be operated when the
headlamps or front fog lamps (if so equipped)
turn on.
An indication lamp in the instrument cluster
comes on when the rear fog lamp is turned on.

[Vehicle without front fog lamps@
Turn the knob once in the “ON” direction to turn on the rear fog lamp. To turn the rear fog
lamp off, turn the knob once in the “OFF” di- rection. The knob will automatically return to
its original position when you release it.

[Vehicle with front fog lamps@
Fog lamp switch
5-632.7(20(1Instruments and controls5

Turn the knob once in the “ON” direction toturn on the front fog lamps. Turn the knob once more in the “ON” direction to turn on
the rear fog lamp. To turn the rear fog lamp off, turn the knob once in the “OFF” direc-
tion. Turn the knob once more in the “OFF” direction to turn off the front fog lamps. The
knob will automatically return to its original
position when you release it.NOTEz The rear fog lamp is automatically turned off
when the headlamps or front fog lamps (if so equipped) are turned off.
z To turn the rear fog lamp on again, turn the
knob once in the “ON” direction after turn-ing on the headlamps. (Vehicle without frontfog lamps)NOTEz To turn the rear fog lamp on again, turn the
knob twice in the “ON” direction after turn- ing on the headlamps. (Vehicle with front
fog lamps)Wiper and washer switch
The windscreen wipers and washer can be
operated with the ignition switch or the oper- ation mode in ON or ACC.
If the blades are frozen to the windscreen, do
not operate the wipers until the ice has mel- ted and the blades are freed, otherwise thewiper motor may be damaged.
CAUT,ONz If the washer is used in cold weather, the
washer fluid sprayed against the glass may freeze, which may hinder visibility. Warm
the glass with the defroster or rear window demister before using the washer.Windscreen wipersExcept for vehicles equipped
with rain sensorMIST-Misting function
The wipers will operate once.OFF-OffINT-Intermittent (Speed sensitive)LO-SlowHI-Fast
Wiper and washer switch
5-642.7(20(1Instruments and controls5

To adjust intermittent intervals
With the lever in the “INT” (speed sensitiveintermittent operation) position, the intermit-
tent intervals can be adjusted by turning the knob (A).
1- Fast
2- Slow
NOTEz The speed-sensitive-operation function of
the windscreen wipers can be deactivated.
For further information, we recommend you to consult a MITSUBISHI MOTORS Au-
thorized Service Point.
Misting function
Move the lever in the direction of the arrow
and release, to operate the wipers once.
Use this function when you are driving in
mist or drizzle.Vehicles with rain sensorMIST-Misting function
The wipers will operate once.OFF-OffAUTO-Auto-wiper control
Rain sensor
The wipers will automatically
operate depending on the degree
of wetness on the windscreen.LO-SlowHI-Fast
Rain sensor
Can only be used when the ignition switch or the operation mode is in ON.
If the lever is put in the “AUTO” position,
the rain sensor (A) will detect the extent of rain (or snow, other moisture, dust, etc.) andthe wipers will operate automatically.
Keep the lever in the “OFF” position if the
windscreen is dirty and the weather is dry.
Wiper operation under these conditions can scratch the windscreen and damage the wip-
ers.
Wiper and washer switch
5-652.7(20(1Instruments and controls5

CAUT,ONzWith the ignition switch or the operation
mode in ON and the lever in the “AUTO”
position, the wipers may automatically oper-
ate in the situations described below.
If your hands get trapped, you could suffer injuries or the wipers could malfunction. Be sure to turn the ignition switch to the
“LOCK” position or put the operation mode
in OFF, or move lever to the “OFF” position to deactivate the rain sensor.

Misting function
Move the lever in the direction of the arrowand release, to operate the wipers once.

Use this function when you are driving in
mist or drizzle.
The wipers will operate once if the lever is raised to the “MIST” position and released
when the ignition switch or the operation
mode is in the ON or ACC position. The wip- ers will continue to operate while the lever is
held in the “MIST” position.
The wipers will operate once if the lever is moved to the “AUTO” position and the knob
(C) is turned in the “+” direction when the ig- nition switch is in the “ON” position or the operation mode is in ON.Windscreen washer
The washer fluid will be sprayed onto the
windscreen by pulling the lever towards you. The wipers operate automatically several
times while the washer fluid is being sprayed. On vehicles equipped with a headlamp wash-
er, while the headlamps are on, the headlamp washer will operate once together with the
windscreen washer.
CAUT,ONz If the washer is used in cold weather, the
washer fluid sprayed against the glass may
freeze resulting in poor visibility. Heat the glass with the defroster or demister before
using the washer.
Wiper and washer switch
5-672.7(20(1Instruments and controls5

Headlamp washer switch*
The headlamp washer can be operated withthe ignition switch or the operation mode in ON or ACC and the lamp switch at the “
”
position.

Push the button once and the washer fluid will be sprayed on to the headlamps.
NOTEz If the ignition switch or the operation mode
is in ON or ACC and the headlamps are on,the headlamp washer operates together with the windscreen washer the first time thewindscreen washer lever is pulled.Precautions to observe when
using wipers and washers
z If the moving wipers become blocked
partway through a sweep by ice or other deposits on the glass, the wipers may
temporarily stop operating to prevent the
motor from overheating. In this case,
park the vehicle in a safe place, turn the ignition switch to the “LOCK” position
or put the operation mode in OFF, and then remove the ice or other deposits.
The wipers will start operating again af- ter the wiper motor cools down, so
check that the wipers operate before us-
ing them.
z Do not use the wipers when the glass is
dry.
They may scratch the glass surface and the blades wear out prematurely.
z Before using the wipers in cold weather,
check that the wiper blades are not fro- zen onto the glass. The motor may burn
out if the wipers are used with the blades
frozen onto the glass.
z Avoid using the washer continuously for
more than 20 seconds. Do not operate the washer when the fluid reservoir is
empty.
Otherwise, the motor may burn out.
z Periodically check the level of washer
fluid in the reservoir and refill if re-quired.
During cold weather, add a recommen-
ded washer solution that will not freeze
in the washer reservoir. Failure to do so could result in loss of washer function
and frost damage to the system compo- nents.Rear window demister
switch
The rear window demister switch can be op- erated when the engine is running.
Push the switch to turn on the rear window
demister. It will be turned off automatically in about 20 minutes. To turn off the demister
within about 20 minutes, push the switch again.
Rear window demister switch
5-682.7(20(1Instruments and controls5

The indication lamp (A) will illuminate whilethe demister is on.NOTEz On vehicles equipped with heated mirrors,
when the rear window demister switch is
pressed, the outside rear-view mirrors are defogged or defrosted. Refer to “Heated mir-
ror*” on page 6-12.NOTEz The demister switch is not to melt snow but
to clear mist. Remove snow before use of
the demister switch.
z To avoid unnecessary discharge of the bat-
tery, do not use the rear window demister
during starting of the engine or when the en-
gine is not running. Turn the demister off
immediately after the window is clear.
z When cleaning the inside of the rear win-
dow, use a soft cloth and wipe gently along
the heater wires, being careful not to damage the wires.
z Do not allow objects to touch the inside of
the rear window glass, damaged or broken wires may result.
Customizing the automatic
rear window demister (Vehiclesequipped with the rear windowdemister switch - Type 2)
Function can be changed as desired, as stated
below.
z Enable automatic rear window demister:
If the outside air temperature drops be-
low approx. 3

Heated steering wheel*
The left and right grip parts of the steering wheel are warmed by the built-in heater of the steering wheel.:Heating area
When the ignition switch or the operationmode is ON, if the switch is pressed, the
heated steering wheel is activated, and the in-
dication lamp (A) on the switch comes on.
The heated steering wheel will be turned off
automatically in approximately 30 minutesafter being operated. To turn off the heated steering wheel while it is operating, press the
switch again. The indication lamp goes off, and the heated steering wheel turns off.CAUT,ONz If the following types of persons use the
heated steering wheel, it might become too hot or receive minor burns (red skin, heat blisters, etc.):