2020 MITSUBISHI L200 Owner's Manual (in English)

See the following section for details on howto play music files.
Refer to “Listen to an iPod*” on pages 7-31,
7-55.
Refer to “Listen to Audio Files on a USB De-
vice*” on pages 7-33, 7-57.How to connect a USB memory
device
1. Park your vehicle in a safe place and
turn the ignition switch to the “LOCK”
position or put the operation mode in
OFF.
2. Open the cover (A) (if so equipped) on
the centre console.
3. Connect a commercially available USB
connector cable (C) to the USB memory
device (B).
4. Connect the USB connector cable to the
USB input terminal.
NOTEz Do not connect the USB memory device to
the USB input terminal directly.
The USB memory device may be damaged.
5. To remove the USB connector cable,
turn the ignition switch to the “LOCK”
position or put the operation mode in
OFF first and perform the installation steps in reverse.
CAUT,ONz After removing the USB connector cable, be
sure to close the terminal cover (if so equip- ped). Entry of foreign matter into the termi-
nal may cause a malfunction.How to connect an iPod
1. Park your vehicle in a safe place and
turn the ignition switch to the “LOCK” position or put the operation mode in
OFF.
2. Open the USB input terminal cover (A)
(if so equipped) on the centre console.
USB input terminal*
7-932.7(20(1For pleasant driving7Type 1 Type 2

3. Connect the connector cable to the iPod.
NOTEzUse a genuine connector cable from Apple
Inc.
4. Connect the connector cable to the USB
input terminal.
5. To remove the connector cable, turn the
ignition switch to the “LOCK” position
or put the operation mode in OFF first and perform the installation steps in re-verse.CAUT,ONz After removing the connector cable, be sure
to close the terminal cover (if so equipped). Entry of foreign matter into the terminalmay cause a malfunction.Types of connectable devices
and supported file specifica- tions
Except for vehicles equipped with the Bluetooth

Model nameCondition
USB memory device
Storage capacity of
256 Mbytes or more
(File System is
FAT16/32)Models other than
USB memory devi-
ces and iPodsDigital audio player
supporting mass stor-
age class
In some countries, for connectable device types for “iPod*,” “iPod classic*,” “iPod nano*,” “iPod touch*” and “iPhone*,” access
the MITSUBISHI MOTORS website.
Please read and agree to the “Warning about Links to the Web Sites of Other Companies”.
The websites mentioned above may connect you to websites other than the MITSUBISHI
MOTORS website.
http://www.mitsubishi-motors.com/en/prod-
ucts/ index.html
*: “iPod,” “iPod classic,” “iPod nano,” “iPod
touch” and “iPhone” are registered trade- marks of Apple Inc. in the United States and
other countries.
NOTEz Depending on the type of the USB memory
device or other device connected, the con-
nected device may not function properly or the available functions may be limited.
z It is recommended to use an iPod with firm-
ware updated to the latest version.NOTEz You can charge your iPod by connecting it to
the USB input terminal when the ignition switch or the operation mode is in ON orACC.
z Do not keep your USB memory device or
iPod in your vehicle.
z It is recommended that you back up files in
case of data damage.
z Do not connect to the USB input terminal
any device (hard disk, card reader, memory reader, etc.) other than the connectable devi-
ces specified in the previous section. The de- vice and/or data may be damaged. If any of
these devices was connected by mistake, re- move it after turning the ignition switch to the “LOCK” position or putting the opera-
tion mode in OFF.
File specifications
You can play music files of the following
specifications that are saved in a USB memo-ry device or other device supporting mass
storage class. When you connect your iPod, playable file specifications depend on the connected iPod.
ItemConditionFile formatMP3, WMA, AAC,
WAVMaximum number of
levels
(including the root)
Level 8
ItemConditionNumber of folders700Number of files65,535HDMI terminal*
You can connect a commercially available HDMI device such as a video camera and a
smart phone to the HDMI terminal (A).
NOTEz For details, refer to the separate owner’s
manual for a Smartphone Link Display Au-
dio.
HDMI terminal*
7-952.7(20(1For pleasant driving7

To connect
1.Park your vehicle in a safe place and
turn the ignition switch to the “LOCK”
position or put the operation mode in
OFF.
2. Connect a commercially available
HDMI cable to the HDMI device.
3. Connect a HDMI cable to the HDMI ter-
minal.
4. To remove the HDMI cable, perform the
installation steps in reverse.
Sun visors
1- To eliminate front glare
2- To eliminate side glare
Card holder
Cards can be slipped into the holder (A) on
the back of the sun visor.
Vanity mirror
A vanity mirror is fitted to the back of the sun visor on the passenger side.AshtrayCAUT,ONz Put out matches and cigarettes before they
are placed in the ashtray.
z Don’t put papers and other things that burn
into your ashtrays. If you do, cigarettes or
other smoking materials could set them on fire, causing damage.
z Always close the ashtray. If left open, other
cigarette butts in the ashtray may be rekin-
dled.
Sun visors
7-962.7(20(1For pleasant driving7 Type 1 Type 2

To use the moveable ashtray, open the lid.
Mounting position for movea-ble ashtray
The moveable ashtray can be fitted at the in- dicated position.
Cigarette lighter
The cigarette lighter can be used while the ig- nition switch or the operation mode is in ON or ACC.
1- Push all the way in.
The cigarette lighter will automatically return to its original position with a “click” when ready. Pull it out for use.
After use, insert the cigarette lighter to its
original position in the socket.NOTEz Do not leave the cigarette lighter removed
from its socket, because the socket might be- come clogged by foreign material and be
short-circuited.CAUT,ONz Do not touch the heating element or the cig-
arette lighter housing, hold the knob only to prevent burns.
z Do not allow children to operate or play with
the cigarette lighter as burns may occur.
z Something is wrong with the cigarette light-
er if it does not pop back out within approxi-
mately 30 seconds of being pushed in.
Pull it out and have the problem corrected at MITSUBISHI MOTORS Authorized Serv-
ice Point.
z Do not use any electric appliance that is not
approved by MITSUBISHI MOTORS . Do-
ing so could damage the socket. If you used the cigarette lighter after damaging the sock-
et, the cigarette lighter might pop out or fail to come out after being pushed in.
Cigarette lighter
7-972.7(20(1For pleasant driving7 For the front seat
For the rear seat Type 1 Type 2

CAUT,ONzWhen the cigarette lighter socket is used as a
power source for an electric appliance, be sure that the electric appliance operates at
12 V and has an electric capacity of 120 W or less. In addition, long use of the electricappliance without running the engine may
run down the battery.Accessory socket
The accessory socket can be used while the
ignition switch or the operation mode is in
ON or ACC.
To use a plug-in type accessory, open the lid, and insert the plug in the accessory socket.
CAUT,ONz Be sure to use a “plug-in” type accessory op-
erating at 12 V and at 120 W or less.
When using more than one socket at the same time, make sure that the electrical ac-
cessories are 12 V accessories and that the total power consumption does not exceed
120 W.
z Long use of the electric appliance without
running the engine may run down the bat- tery.
z When the accessory socket is not in use, be
sure to close the lid, because the socketmight become clogged by foreign materialand be short-circuited.USB port (for charging)*
The USB port (for charging) can be used as a
power source of the USB appliances when
the ignition switch or the operation mode is in ON or ACC.
There are two USB ports (for charging) loca-
ted on the back of the floor console box. When using the USB port (for charging),
open the lid and connect the USB connector
cable to it.CAUT,ONz When the USB port (for charging) is not in
use, be sure to close the lid, because theUSB port (for charging) might be short-
circuited by clogging foreign materials and
the connected devices and the USB port (for
charging) might be damaged.
z Insert the USB connector cable in the USB
port (for charging) firmly.
If the USB connector cable does not insert in
it firmly, it may become extremely hot and the fuses may blow.
Accessory socket
7-982.7(20(1For pleasant driving7

CAUT,ONzBe sure that the power consumption does not
exceed 10.5 W {The peak outlet current or
voltage of the USB port (for charging) is DC 5 V-2.1 A}.
The connected devices or the USB port (for
charging) may be damaged.
z Do not use the reversible USB connector ca-
ble on the USB connector board that is loca-ted in the centre.
The USB port (for charging) might be dam-
aged.
z Long use of the electric appliance without
running the engine may run down the bat- tery.NOTEz These USB ports (for charging) can be used
only as a power source. They do not connect
to the audio devices of the vehicles.
z Do not charge many mobile devices together
by using a multi-plug adapter of the USB
port (for charging).
z If water or spillt beverages are splashed on
the USB ports (for charging), stop using it
and have the vehicle checked by a MITSUBISHI MOTORS Authorized Serv-
ice Point.Digital clock*
The digital clock indicates the time with the ignition switch or the operation mode is in
ON or ACC.
To set the time
Set the time by pressing the various buttons
as described below.
1- To adjust the hour
2- To adjust the minutes
3- To reset the minutes to zero

10:30 - 11:29...... Changes to 11:00
11:30 - 12:29...... Changes to 12:00
NOTEz If the battery cables are disconnected during
repairs or for any other reason, reset the
clock to the correct time after they are recon-
nected.Interior lamps
1- Front room & map lamps*
2- Rear room lamp
NOTEz If you leave the lamps on without running
the engine, you will run down the battery.
Before you leave the vehicle, make sure that
all the lamps are off.
Digital clock*
7-992.7(20(1For pleasant driving7

Room lampsPosition of
lamp switchOn/off control1-ON
(
)
The lamp illuminates re-
gardless of whether a door
is open or closed.Position of
lamp switchOn/off control2-DOOR
(
)
Delayed off function[Vehicles without central
door lock system@
The lamp illuminates when
a door is opened. It goes off
approximately 7 seconds af-
ter all doors are closed.
However, the lamp goes off
immediately when the igni-
tion switch is turned to the
“ON” position with all
doors closed.
[Vehicles with central door
lock system@
The lamp illuminates when
a door is opened. It goes off
approximately 15 seconds
after the all doors are
closed.
However, the lamp goes off
immediately with all doors
closed in the following ca-
ses:Position of
lamp switchOn/off control2-DOOR
(
)z When the ignition
switch is turned to the
“ON” position or the
operation mode is put in ON.
z When the central door
lock function is used to
lock the vehicle.
z When the keyless entry
key or the keyless oper- ation key is used to
lock the vehicle.
z If the vehicle is equip-
ped with the keyless
operation system, when the keyless operationfunction is used to lock
the vehicle.
Interior lamps
7-1002.7(20(1For pleasant driving7Front* Rear