2001 TOYOTA AVALON Service Repair Manual

P12478
Adhesive
LU-2
- LUBRICATIONOIL AND FILTER
1227 Author
: Date
:
2001 AVALON (RM808U)
6. REMOVE OIL PRESSURE GAUGE AND REINSTALL
OIL PRESSURE SWITCH
(a) Remove the oil pressure gauge.
(b) Apply adhesive to 2 or 3 threads of the oil pressure switch.
Adhesive: Part No. 08833-00080, THREE BOND 1344,
LOCTITE 242 or equivalent
(c) Using SST, install the oil pressure switch.
SST 09816-30010
Torque: 13 N´m (130 kgf´cm, 9 ft´lbf)
7. START ENGINE AND CHECK FOR LEAKS

LU01Q-03
B06524
B06486
SST
B06479
SST
Additional
3/4 Turn
- LUBRICATIONOIL AND FILTER
LU-3
1228 Author
: Date
:
2001 AVALON (RM808U)
REPLACEMENT
CAUTION:

Prolonged and repeated contact with mineral oil will
result in the removal of natural fats from the skin,
leading to dryness, irritation and dermatitis. In addi-
tion, used engine oil contains potentially harmful
contaminants which may cause skin cancer.

Exercise caution in order to minimize the length and
frequency of contact of your skin to used oil. Wear
protective clothing and gloves. Wash your skin thor-
oughly with soap and water, or use water-less hand
cleaner, to remove any used engine oil. Do not use
gasoline, thinners, or solvents.

In order to preserve the environment, used oil and
used oil filter must be disposed of only at designated
disposal sites.
1. DRAIN ENGINE OIL
(a) Remove the oil filler cap.
(b) Remove the oil drain plug, and drain the oil into a contain-
er.
2. REPLACE OIL FILTER
(a) Using SST, remove the oil filter.
SST 09228-07501
(b) Check and clean the oil filter installation surface.
(c) Apply clean engine oil to the gasket of a new oil filter.
(d) Lightly screw the oil filter into place, and tighten it until the
gasket contacts the seat.
(e) Using SST, tighten it an additional 3/4 turn.
SST 09228-07501

LU-4
- LUBRICATIONOIL AND FILTER
1229 Author
: Date
:
2001 AVALON (RM808U)
3. REFILL WITH ENGINE OIL
(a) Clean and install the oil drain plug with a new gasket.
Torque: 45 N´m (460 kgf´cm, 33 ft´lbf)
(b) Fill with fresh engine oil.
Capacity:
Drain and refill w/ Oilfilter change
w/o Oilfilter change4.7 liters (5.0 US qts, 4.1 lmp. qts)
4.5 liters (4.8 US qts, 4.0 lmp. qts)
Dry fill5.2 liters (5.5 US qts, 4.6 lmp. qts)
(c) Install the oil filler cap.
4. START ENGINE AND CHECK FOR OIL LEAKS
5. RECHECK ENGINE OIL LEVEL

LU01R-04
B09034
 Gasket RH Fender Apron Seal
PS Pump Drive Belt
A/C Compressor
Connector
A/C CompressorEngine Moving
Control Rod
No.2 RH Engine Mounting
Bracket
Front Exhaust Pipe
Stay

PS Pump Drive Belt
Adjusting Strut
Generator Drive Belt
Adjusting Bar Bracket
 Gasket

62 (630, 46)
33 (330, 24)
21 (210, 15)
64 (650, 47)
32 (320, 23)
62 (630, 46)
N´m (kgf´cm, ft´lbf) : Specified torque
 Non-reusable partBracket Generator Drive
Belt
43 (440, 32)
Compression Spring
Generator Generator
Connector
43 (440, 32)
- LUBRICATIONOIL PUMP
LU-5
1230 Author
: Date
:
2001 AVALON (RM808U)
OIL PUMP
COMPONENTS

B06519
B08672
No.2 Timing Belt CoverTiming Belt
Timing Belt Guide
No.2 Generator
Bracket RH Engine Mounting Bracket
Crankshaft
PulleyGasket
Engine Wire
Protector
RH Camshaft Timing Pulley
No.2 Idler Pulley
Crankshaft
Timing PulleyDust Boot
Timing Belt Plate Plate Washer


215 (2,200, 159)
43 (440, 32)
27 (280, 20)
Timing Belt TensionerN´m (kgf´cm, ft´lbf) : Specified torque
 Non-reusable part
28 (290, 21)
No.1 Timing Belt Cover
125 (1,300, 94)
*88 (900, 65)
LH Camshaft
Timing Pulley
No.1 Idler Pulley
34 (350, 25)

Precoated part
* For use with SST
125 (1,300, 94)
LU-6
- LUBRICATIONOIL PUMP
1231 Author
: Date
:
2001 AVALON (RM808U)

B08905
N´m (kgf´cm, ft´lbf): Specified torque
 Non-reusable partNo.3 Timing Belt Cover
Gasket
BushingCollar
A/C Compressor
Housing Bracket
Oil Pan Baffle Plate Crankshaft
Position Sensor
Connector Crankshaft
Position
Sensor
Oil PumpEngine Wire
Oil Strainer
No.2 Oil Pan
x 10x 6
x 9 O-Ring
No.1 Oil Pan
 Gasket
Drain Plug
8.5 (85, 74 in.´lbf)
8 (80, 69 in.´lbf)
8 (80, 69 in.´lbf)
10 mm Head 8 (80, 69 in.´lbf)
12 mm Head 19.5 (200, 14)
10 mm Head 8 (80, 69 in.´lbf)
12 mm Head 19.5 (200, 14)
14 mm Head 37.2 (380, 27)
8 (80, 69 in.´lbf)
45 (460, 33)
8 (80, 69 in.´lbf)
x 6
x 17
 Gasket
19.5 (200, 14)
No.1 Exhaust Pipe
Support Bracket
- LUBRICATIONOIL PUMP
LU-7
1232 Author
: Date
:
2001 AVALON (RM808U)

B08678
N´m (kgf´cm, ft´lbf) : Specified torque
 Non-reusable partx 10
49.1 (500, 36)
 Crankshaft Front
Oil Seal
Relief Valve
Spring
Plug Oil Pump Body
Driven RotorDrive RotorOil Pump Body Cover
LU-8
- LUBRICATIONOIL PUMP
1233 Author
: Date
:
2001 AVALON (RM808U)

LU01T-03
B04138
B04139
- LUBRICATIONOIL PUMP
LU-1 1
1236 Author
: Date
:
2001 AVALON (RM808U)
DISASSEMBLY
1. REMOVE RELIEF VALVE
Remove the plug, spring and relief valve.
2. REMOVE DRIVE AND DRIVEN ROTORS
Remove the 10 screws, pump body cover, drive and driven ro-
tors.