1994 MAZDA MX-5 Workshop Manual

CONSTRUCTION @ I Trunk lid I @ I Splash protector No. @I I Rear deck member Part Name @ @ I @ I Light housing No. Rear end panel Rear deck panel @ I Floor center pan Part Name @ I @ / Rear fender panel @ @I @ I Crossmember No. 3 Seal plate Quarter panel Floor side panel I @ I Rear fender, lower @ Fuel filler lid @ @ 1 Floor side plate I I I I @ 1 Side sill B, inner Crossmember No. 4 Tank floor pan assy @ @ 1 Bumper bracket @ @ Trunk floor assy @ @ I Q / Front header, upper Door body Side sill, outer @ Floor side panel Rear side frame -1 .............. Both side rust-proof treated steel .............. One side rust-proof treated steel (Reverse side only) Side sill reinforcement Striker reinforcement Side sill C, inner @ @ 0 @ Side panel, inner Wheel inner house Beltline reinforcement Corner junction @ @ @ Side sill A, inner Hinge pillar, outer Cowl side panel Gartner Banana

CONSTRUCTION HIGH-STRENGTH STEEL STRUCTURAL VIEW Front TI .............. High-strength steel Gartner Banana

CONSTRUCTION . Gartner Banana

Gartner Banana

PANEL REPLACEMENT CROSSMEMBER (NO. 1) ............................................. 36 SHROUD PANEL ASSY ............................................... 38 WHEEL APRON PANEL ............................................... 40 WHEEL APRON PANEL ASSY .................................... 42 COWL SIDE PANEL ...................................................... 44 SIDE SILL PANEL ASSY .............................................. 46 FRONT PILLAR, OUTER COWL SlDE PANEL, HINGE PILLAR, INNER COWL SlDE PANEL AND SIDE SILL PANEL ............................................ 48 REAR FENDER PANEL ................................................ 52 REAR END PANEL ....................................................... 54 TRUNK FLOOR PAN, FLOOR SIDE PANEL .............. 56 Gartner Banana

PANEL REPLACEMENT Welding Symbol ....................................... Spot welding ................................... .... MIG plug welding ..................................... 4- MIG spot welding ti.&+ ....................................... continuous MIG welding at cut-and-join location ....................................... Braze welding ....................................... Rough cut location CROSSMEMBER (NO. 1) 1 Name of part to be replaced Location of part to be replaced I REMOVAL I To drill away 8 points indicated by (A), first rough-cut as shown in the illustration, and remove the crossmember. When drilling other than points (A), do not make open holes. Do not damage the front side frame when rough-cutting. Gartner Banana

L PANEL REPLACEMENT INSTALLATION 0 When installing new parts, measure the dimensions to verify that they are as specified. 37 Gartner Banana

PANEL REPLACEMENT - SHROUD PANEL ASSY REMOVAL Work should be performed after the crossmember No. 1 is removed. When drilling away the spot welds, do not make open holes. Gartner Banana