Page 233 of 622
STEERING WHEEL AND MIRRORS
212
G17016
Zone number
If the direction is displayed several seconds after adjustment,
the calibration is finished.
CAUTION
Do not adjust the display while the vehicle is moving.
Be sure to adjust the display only when the vehicle is
stopped.
CALIBRATING THE COMPASS (circling calibration)
G17011
“CAL” appears on the display in case the circling calibration is
required due to a drastic change in the magnetic field. To
rectify this, follow the calibration procedure below.
Page 234 of 622

STEERING WHEEL AND MIRRORS
213
G17012
Drive the vehicle slowly (at 8 km/h (5 mph) or lower) in a circle
until the direction is displayed. If there is not enough space to
drive in a circle, drive around the block until the direction is
displayed.
After driving in 1 to 3 circles in the above method, calibration
is complete with the “CAL” off the display and the direction
shown on the display.
If calibration cannot be performed because of the vehicle is
magnetized, take your vehicle to a Lexus dealer.
Do not perform circling calibration of the compass in a place
where the earth’s magnetic field is subject to interference by
artificial magnetic fields (underground parking, under a
steel tower, between buildings, roof parking, near a
crossing, near a large vehicle, etc.).
During calibration, do not operate electric systems (moon
roof, power windows, etc.) as they may interfere with the
calibration.
CAUTION
When doing the circling calibration, be sure to secure
a wide space, and watch out for people and vehicles
in the neighborhood. Do not violate any local traffic
rules while performing circling calibration.
Do not adjust the display while the vehicle is moving.
Be sure to adjust the display only when the vehicle is
stopped.
Page 235 of 622
STEERING WHEEL AND MIRRORS
214
VANITY MIRRORS
G17017
To use the vanity mirror, swing the sun visor down and
slide the cover.
The vanity light comes on when you slide the cover. However
if the sun visor is not hooked securely, the light may not come
on.
NOTICE
To prevent the battery from being discharged, do not
leave the cover open for a long time while the engine is
stopped.
Page 236 of 622
SECTION 1 – 8
215
INSTRUMENTS AND CONTROLS
Touch screen
Overview216
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . . . . . . .
Information menu 218
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . .
Page 237 of 622
G18042
Vehicles with Navigation system
G18043
Vehicles without Navigation system
TOUCH SCREEN
216
OVERVIEW
1 Touch screen
2 “CLIMATE” button
The air conditioning operation screen is
shown.
(See page 254 for details.)
3 “AUDIO” button
The audio operation screen is shown.
(See page 274 for details.)
4 “INFO”button
The information menu screen is shown.
(See page 218 for details.)
5 “DISP” button
The display adjustment screen is
shown.
(See page 251 for details.)
Page 238 of 622
TOUCH SCREEN
217
Initial screen
G18001
When you select the engine switch in “ACC” or “IG −ON” mode,
the initial screen appears and the system begins operating.
After a few seconds, the initial screen disappears.
CAUTION
When the vehicle is stopped with the engine running,
always apply the parking brake for safety.
Touch switch operation
This system is operated mainly by the switches on the screen.
To prevent damage to the screen, lightly touch switches on the
screen with your finger. When you touch a switch on the
screen, a beep sounds.
Do not use objects other than your finger to touch the screen.
INFORMATION
If the system does not respond to a touch of a switch,
move your finger away from the screen and then
touch it again.
You cannot operate dimmed switches.
Wipe off fingerprints on the surface of the display
using a glass cleaning cloth.
The displayed image may become darker and moving
images may be slightly distorted when the display is
cold.
Page 239 of 622
TOUCH SCREEN
218
INFORMATION MENU
G18044
Vehicles with Navigation system*
G18045
Vehicles without Navigation system
*For other functions such as Maintenance and Calender, see
“Navigation System Owner’s Manual”. For “Lexus park Assist”, see “Setting the park assist system”\
on page 385. For “Adjust clock”, see “Clock” on page 103.
Trip information
Trip information such as driving time, driving distance,
average vehicle speed, fuel consumption, etc. can be
displayed on the screen.
1. Push the
“INFO” button to display the Information
Menu screen.
G18045
2. Touch the “Trip Info.” switch.
Page 240 of 622

TOUCH SCREEN
219
G18003
Consumption
The consumption is calculated and displayed based on
the driving distance and the fuel consumption for 2
seconds with engine running.
The value is updated every 0.5 seconds.
If you are driving at low speeds just before stopping, the
accurate figure may not be shown.
After Refueling
The consumption after refueling is calculated and
displayed based on the total driving distance and the total
fuel consumption after refueling.
The value is updated every 10 seconds.
When refueling, be sure to stop your vehicle and turn the
engine switch off. Cruising Range
How far you can drive with the remaining fuel is
displayed.
Even though the display indicates sufficient miles to run, if the
fuel level on the fuel gauge approaches “E” or the low fuel level
warning light comes on, fill the fuel tank as soon as possible.
INFORMATION
When you first start driving your new vehicle, the
correct cruising range may not be shown. One or
more refills of 10 gallons or more may be required for
the system to set its calibration.
The cruising range displayed is calculated based on
past fuel consumption and may vary according to
your driving style and road condition.