2005 MITSUBISHI 380 Workshop Manual

REAR SEAT CUSHION TRIM COVER
INTERIOR52A-48
4. Pull draw string and attach to the centre wire as shown.
5. Reattach all outer points.
6. Work the trim into all the grooves and adjust if necessary to
remove creases as shown.

REAR SEAT BACK TRIM COVER
INTERIOR52A-49
REAR SEAT BACK TRIM COVER
REMOVAL AND FITMENT
REAR SEAT BACK TRIM REMOVAL
.
1. Remove rear seat back from the vehicle, and remove arm
rest and arm rest pivot bushes from rear seat back.
2. Release the draw string.
3. Release all outer attachment points. Release all the centre
clips.

REAR SEAT BACK TRIM COVER
INTERIOR52A-50
4. Peel cover away from the foam pad.
NOTE: Place a finger on the Blue Velcro strip when peeling
the cover to prevent the strip being pulled out of the foam
pad.

REAR SEAT BACK TRIM COVER
INTERIOR52A-51
REAR SEAT BACK TRIM FITMENT
.
1. Fit the trim over the lower wire brackets.
2. Locate the new trim onto the pad by aligning the Velcro strip
with the grooves. Use an intersection in order to align both
directions. Whenever possible work from the centre of the
trim toward the outside.
3. When all the grooves are aligned pull the cover over the
pad.

REAR SEAT BACK TRIM COVER
INTERIOR52A-52
4. Reattach the upper trim holding points including the plastic
clips.
5. Attach the centre lower trim hold points.
6. Attach the clips around the arm rest as shown.

REAR SEAT BACK TRIM COVER
INTERIOR52A-53
7. Pull inner lower arm rest trim through the hole and clip to
retainer attached to the lower part of the trim cover.
8. Pull the upper arm rest trim through the hole over the large
wire and clip to the small wire as shown.
9. Pull the draw string and attach to the wire attachment points
shown.

REAR SEAT BACK TRIM COVER
INTERIOR52A-54
10.Attach all the outer trim attachment points.
11.Work in all the seams, and adjust as required to remove any
creases.
12.Fit seat back to vehicle in reverse order of removal.

REAR SEAT ASSEMBLY
INTERIOR52A-55
REAR SEAT ASSEMBLY
REMOVAL AND INSTALLATIONM1522001800297
INSTALLATION SERVICE POINTS
.
>>A<< INSTALLATION OF REAR SEATBACK
ASSEMBLY
Press the rear seatback assembly in the direction shown in the
illustration and fit the attachment wire into the hook securely to
install the rear seatback assembly.Confirm that back is hooked
and secured by pulling forward.
.
REMOVAL STEPS
>>B<<1. REAR SEAT CUSHION
ASSEMBLY>>A<<2. REAR SEATBACK ASSEMBLY
3. REAR SEAT HOOKREMOVAL STEPS (Continued)