2020 MITSUBISHI OUTLANDER PHEV Owner's Manual (in English)

Warning display listScreenCauseSolution (Reference)
zOne or more failure is occurring in the
Plug-in Hybrid EV System.z Have your vehicle inspected by a
MITSUBISHI MOTORS Authorized
Service Point.z One or more failure is occurring in the
Plug-in Hybrid EV System.z Immediately park the vehicle in a safe
place and contact a MITSUBISHI
MOTORS Authorized Service Point.z The parking lock unit is in failure. The
Plug-in Hybrid EV System cannot be keptin standstill condition without applying the parking brake.
z Park the vehicle at a safe, flat place and
apply the parking brake. Contact a
MITSUBISHI MOTORS Authorized
Service Point.
Refer to “Electrical Parking switch” on page 7-18.
z You are attempting to set the operation
mode to “ON” when the charge connector
is connected to the charge port.z Disconnect the charge connector from the
charge port before operating the power
switch.z Charging was interrupted due to system
failure or EV charging cable failure.
z There is a system failure or the EV charg-
ing charge cable is faulty. Immediately
stop using the cable and contact a
MITSUBISHI MOTORS Authorized
Service Point.
Indication lamp, warning lamp, and information screen display list
6-252**(20(1Instruments and controls6

ScreenCauseSolution (Reference)
zNormal charging

ScreenCauseSolution (Reference)
zThe drive battery temperature is too cold.
z When the vehicle is under running, stop
the vehicle in a safe place and contact a MITSUBISHI MOTORS Authorized
Service Point.
z When the vehicle is parked during the
daytime, wait for the outside temperature to rise and re-start the Plug-in hybrid sys-tem once the outside temperature has ris-
en.
Refer to “Cautions and actions to deal with intense cold” on page 2-10.z The battery charge mode is selected when
the drive battery temperature is cold.z You do not have to take any actions, but
the time needed to charge the drive bat-
tery will become longer.z The drive battery is extremely cold. The
Plug-in Hybrid EV System will not start
until the drive battery is warm enough.z Even if the drive battery is fully charged,
connect the EV charging cable (normal charger). Then, the drive battery warmingsystem is operated and the drive battery isautomatically warmed up. While the drive
battery warning system is operating,
“BATTERY TOO COLD” will be dis- played. (Vehicles equipped with drive bat-
tery warming system)
Refer to “Charging from rated AC 220-240 V outlet” on page 3-12.
Refer to “Cautions and actions to deal with intense cold” on page 2-10
Indication lamp, warning lamp, and information screen display list
6-272**(20(1Instruments and controls6

ScreenCauseSolution (Reference)zThe drive battery is extremely cold.zStop the vehicle at a safe place if the vehi-
cle is under running.
When the vehicle has been parked during
the daytime, wait for the outside tempera-
ture to rise and re-start the Plug-in Hybrid EV system once the outside temperaturehas risen.
Refer to “Cautions and actions to deal with intense cold” on page 2-10z Charging lid is open.z Close the charge lid.
Refer to “Charging from rated AC
220-240 V outlet” on page 3-12.z When the air conditioner stops because
the drive battery level becomes low by us- ing the air conditioner during charging.z Turn the power switch to OFF once the
drive battery has been charged sufficient- ly, then turn the power switch to ON. The
air conditioner can be used again.z When the air conditioner can be used
again in the following conditions.
The drive battery is sufficiently charged when the “A/C AND HEAT ARE NOT
AVAILABLE BATTERY CHARGE LOW” indication is displayed or the drivebattery is sufficiently heated when the “BATTERY TOO COLD” indication is
displayed, etc.z Turn the power switch to OFF once, and
then turn the power switch to ON. The air conditioner can be used again.
Indication lamp, warning lamp, and information screen display list
6-282**(20(1Instruments and controls6

ScreenCauseSolution (Reference)zWhen the operation mode of the power
switch is put in ON during charging.z The electric devices can be used during
charging. Refer to “How to use an electricdevice during charging” on page 3-24.
z EV priority mode is not available because
the drive battery level is low.
z Refer to “EV switch” on page 7-25.
zEV priority mode is not available because
the cruise control or the Adaptive Cruise
Control System (ACC) is operating.
z EV priority mode is not available because
the drive battery is too cold.z EV priority mode is not available because
the EV priority mode is limited to protect
the Plug-in Hybrid EV System or the out-
side temperature is too low.
Indication lamp, warning lamp, and information screen display list
6-292**(20(1Instruments and controls6

ScreenCauseSolution (Reference)
zEV priority mode is cancelled because the
drive battery level is low.
z EV priority mode is cancelled because the
vehicle speed of the cruise control or theAdaptive Cruise Control System (ACC) is
set.z EV priority mode is cancelled because the
drive battery temperature has become too
cold.
z EV priority mode is cancelled because the
protecting device of the Plug-in Hybrid
EV System is operated.
z Preparation to open the fuel tank filler
door is in progress.z Wait until the preparation is complete. Re-
fer to “Filling the fuel tank” on page 2-15.
Indication lamp, warning lamp, and information screen display list
6-302**(20(1Instruments and controls6

ScreenCauseSolution (Reference)zPreparation to refuel has been completed
and the fuel tank filler door is open.z Please begin refueling.
For information on how to refuel, refer to “Filling the fuel tank” on page 2-15.z There is a fault in the refueling system.zContact a
MITSUBISHI MOTORS Au-
thorized Service Point to have the system checked.
Refer to “Filling the fuel tank” on page
2-15.z The fuel tank filler door is open.z Check that the fuel cap is closed, then
close the fuel tank filler door.
Refer to “Filling the fuel tank” on page 2-15.z You have selected the warm air with the
air conditioner switch while driving in the EV priority mode.
(Vehicle without electric heater)z If you want to use the heating, cancel the
EV priority mode.
Refer to “EV switch” on page 7-25.z You have pressed the EV switch while
heating.
(Vehicle without electric heater)z If you want to use the EV priority mode,
stop the heating.
Refer to “Automatic climate control air conditioner” on page 8-06
Indication lamp, warning lamp, and information screen display list
6-312**(20(1Instruments and controls6

ScreenCauseSolution (Reference)zSPORT mode is not available because the
remaining fuel quantity is low.z Refer to “SPORT mode switch” on page
7-30.z SPORT mode is cancelled because the re-
maining fuel quantity has become low.z Battery save mode or battery charge mode
is not available because the engine cool-
ant temperature is high or the remaining fuel quantity is low.z Refer to “SAVE/CHARGE mode switch”
on page 7-27.z Battery save mode or battery charge mode
is cancelled because the engine coolant
temperature has become high or the re- maining fuel quantity has become low.
z You have forgotten to turn off the lamps.zRefer to “Lamps (headlamps, fog lamps,
etc.) auto-cutout function” on page 6-58.Indication lamp, warning lamp, and information screen display list
6-322**(20(1Instruments and controls6