2010 NISSAN TIIDA Service Repair Manual

Page 817 of 3745

NISSAN TIIDA 2010  Service Repair Manual BL-308
< SERVICE INFORMATION >
BODY REPAIR
• The repair of reinforcements (such as side members) by heat-ing is not recommended since it may weaken the component.
When heating is unavoidable, do not

Page 818 of 3745

NISSAN TIIDA 2010  Service Repair Manual BODY REPAIRBL-309
< SERVICE INFORMATION >
C
DE
F
G H
J
K L
M A
B
BL
N
O P
• The spot weld on HSS panels is harder than that of an ordi- nary steel panel.
Therefore, when cutting spot welds on a HSS

Page 819 of 3745

NISSAN TIIDA 2010  Service Repair Manual BL-310
< SERVICE INFORMATION >
BODY REPAIR
• Peel off old bonding material on the surface of outer wheelhouseand clean thoroughly.
• Peel off a primer coat in the specified area where new adhesive

Page 820 of 3745

NISSAN TIIDA 2010  Service Repair Manual BODY REPAIRBL-311
< SERVICE INFORMATION >
C
DE
F
G H
J
K L
M A
B
BL
N
O P
- Remove foam material remaining on vehicle side.
- Clean area in which foam was removed.
- Install service part.
- Insert noz

Page 821 of 3745

NISSAN TIIDA 2010  Service Repair Manual BL-312
< SERVICE INFORMATION >
BODY REPAIR
Sedan
1. Body side outer2. Front pillar lower reinforcement 3. Body side insulation (foam) front pil-
lar
4. Roof panel assembly 5. Body side insulation (Foa

Page 822 of 3745

NISSAN TIIDA 2010  Service Repair Manual BODY REPAIRBL-313
< SERVICE INFORMATION >
C
DE
F
G H
J
K L
M A
B
BL
N
O P
Replacement OperationINFOID:0000000005396727
DESCRIPTION
1. Body side outer 2. Front pillar lower reinforcement 3. Body side i

Page 823 of 3745

NISSAN TIIDA 2010  Service Repair Manual BL-314
< SERVICE INFORMATION >
BODY REPAIR
This section is prepared for technicians who have attained a high level of skill and experience in repairing col-
lision-damaged vehicles and also use modern

Page 824 of 3745

NISSAN TIIDA 2010  Service Repair Manual BODY REPAIRBL-315
< SERVICE INFORMATION >
C
DE
F
G H
J
K L
M A
B
BL
N
O P
The symbols used in this section for cutting and welding / brazing operations are shown below.
PIIA0149E
Revision: January 201