2008 MITSUBISHI SHOGUN Owner's Manual (in English)

General information
5
3. Open the fuel tank filler tube by slowly turning the cap
anticlockwise.
4. Insert the gun in the tank port as far as it goes. 5. When the gun stops automatically, do not fill with fuel
any more.
6. To close, turn the fuel tank filler tube cap slowly clock-
wise until you hear clicking sounds, then gently push thefuel tank filler door closed.
A- Remove B- Close
CAUTION
!●
Since the fuel system may be under pressure, remove the fuel tank fill
er tube cap slowly. This
relieves any pressure or vacuum that might have built up in the fuel tank. If you hear a hissing sound, wait until it stops before
removing the cap. Other-
wise, fuel may spray out,
injuring you or others.
CAUTION
!●
Do not tilt the gun.
BK-BK2008E1ENUK.en-uk-Section3.fm Page 5 Wednesday, January 9, 2008 4:21 PM

6 General information
Installation of accessories
E00200300774
We recommend you to consult your MITSUBISHI MOTORS Authorized Service Point. ●
The installation of accessories
, optional parts, should only
be carried out within the limits prescribed by law in your country, and in accordance wi
th the guidelines fitting
instructions and warnings contained within the documentsaccompanying the parts or accessories.
●
Improper installation of el
ectrical components may cause
an electrical fire if incorrectly
fitted. Please refer to Modi-
fication/alteration to the electri
cal or fuel systems section
within this owner’s manual.
●
Using a cellular phone or radio set inside the vehicle with- out an external antenna may
cause electrical system inter-
ference, which could lead to
unsafe vehicle operation.
●
Tyres and wheels which do not meet specifications must not be used. Refer to the “Specifications
” section for information
regarding wheel and tyre sizes.
●
When fitting accessories, ensure that maximum gross vehicle weight and maximum axle weight are not exceeded.
Important points!Due to large number of accessory
and replacement parts of dif-
ferent manufactures available in the market, it is not possible,not only for MITSUBISHI MOTORS, but also for a MIT- SUBISHI MOTORS Authorized
Service Point, to check
whether the attachment or installa
tion of such parts affects the
overall safety of your MITSUBISHI-vehicle. Even when such parts are offici
ally authorized, for example by
a “general operators permit”
(an appraisal for the part) or
through the execution of the part
in an officially approved man-
ner of construction, or when a single operation permit follow- ing the attachment or installation of such parts, it cannot be deduced from that alone, that the driving safety of your vehiclehas not been affected. Consider also that there basically
exists no liability on the part
of the appraiser or the official.
Only in the case of parts (MIT-
SUBISHI MOTORS original repl
acement or exchange parts as
well as MITSUBISHI MOTORS
genuine accessories) that are
recommended and released by a MITSUBISHI MOTORSAuthorized Service Point and that
are attached or installed by a
MITSUBISHI MOTORS Author
ized Service Point can you
assume, that optimal safety ha
s been provided. The same also
pertains to modifications of
MITSUBISHI vehicle with respect
to the production specifications. For your own safety, in such cases, you should only undert
ake modifications according to
the recommendations of a MI
TSUBISHI MOTORS Author-
ized Service Point.
BK-BK2008E1ENUK.en-uk-Section3.fm Page 6 Wednesday, January 9, 2008 4:21 PM

General information
7
Modification/alterations
to the electrical or
fuel systems
E00200400254
MITSUBISHI MOTORS has always manufactured safe, high quality vehicles. In order to maintain this safety and quality, it is important that any accessory that
is to be fitted, or any modi-
fications carried out which invo
lve the electrical or fuel sys-
tems, should be carried out
in accordance with MITSUBISHI
MOTORS guidelines.
Genuine parts
E00200500330
MITSUBISHI MOTORS has gone to great lengths to bring you a superbly crafted automobile offering the highest quality and dependability.Use MITSUBISHI MOTORS genuine parts, designed and manufactured to maintain your MITSUBISHI MOTORS auto- mobile at top performance. MITSUBISHI MOTORS genuineparts are identified by this mark
and are available at all MIT-
SUBISHI MOTORS Authorized Service Points.
CAUTION
!●
If the wiring interferes wi
th any part of the vehicle
bodywork or improper installation methods areused, i.e. protective fuses
not installed,
etc.), elec-
tronic devices may be ad
versely affected, possibly
resulting in an electrical
fire or other failures that
may cause an accident.
BK-BK2008E1ENUK.en-uk-Section3.fm Page 7 Wednesday, January 9, 2008 4:21 PM

8 General informationUsed engine oils safety
instructions and dis-
posal information
E00200600025
Protect the environmentIt is illegal to pollute drains, water courses and soil. Use authorized waste collection faci
lities, includi
ng civic amenity
sites and garages providing facili
ties for disposal of used oil
and used oil filters. If in doub
t, contact your local authority for
advice on disposal.
WARNING
!●
Prolonged and repeated contact may cause serious skin disorders, including
dermatitis and cancer.
●
Avoid contact with the skin as far as possible and wash thoroughly after any contact.
●
Keep used engine oils ou
t of reach of children.
BK-BK2008E1ENUK.en-uk-Section3.fm Page 8 Wednesday, January 9, 2008 4:21 PM

1
Locking and unlocking
Keys . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1- 2 Electronic immobilizer (Anti-theft starting system). .
. . . . . . . . . . . . . . .1- 3
Keyless entry system* . . . . . .
. . . . . . . . . . . . . . . .1- 5
Doors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1- 7Central door locks . . . . . . . . . . . . . . . . . . . . . . . . .1- 9“Child-protection” rear doors (5-door models) . . .1- 11Approach lamp* . . . . . . . . . . . . . . . . . . . . . . . . . . .1- 12Backdoor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1- 13Electric window control . . . . . .
. . . . . . . . . . . . . . .1- 16
Rear side/quarter window . . . . . . . . . . . . . . . . . . .1- 20Sunroof*. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1- 21
BK-BK2008E1ENUK.en-uk-Section4.fm Page 1 Wednesday, January 9, 2008 4:22 PM

1-2 Locking and unlocking
1
Keys
E00300101161
The keys fit all locks.
NOTE●
The key number is stamped on the tag as indicated in the illustration.Make a record of the key nu
mber and store the key and
key number tag in separate pl
aces, so that you can order a
key in the event the original keys are lost.
Type 1
Type 2
BK-BK2008E1ENUK.en-uk-Section4.fm Page 2 Wednesday, January 9, 2008 4:22 PM

Locking and unlocking
1-3
1
●
The key is a precision electroni
c device with a built-in sig-
nal transmitter. Please observe the following in order to prevent damage. • Do not leave where it may be exposed to heat caused bydirect sunlight, such as on top of the dashboard. • Do not take the remote control transmitter apart. • Do not excessively bend the key or subject it to strongimpacts. • Keep the remote control transmitter dry. • Keep away from magnetic objects such as key holders.• Keep away from devices th
at produce magnetism, such
as audio systems, computers and televisions. • Do not clean with
ultrasonic cleaners.
• Do not leave the key where it may be exposed to high temperature or high humidity.
●
The engine is designed so that it will not start if the ID code registered in the immobi
lizer computer and the key’s
ID code do not match. Refer to the section entitled “Elec- tronic immobilizer” for details and key usage.
Electronic immobilizer
(Anti-theft starting system)
E00300201087
The electronic immobilizer is de
signed to reduce significantly
the possibility of vehicle theft. The purpose of the system is to immobilize the vehicle if an inva
lid start is attempted. A valid
start attempt can only be achieved using a key “registered” to the immobilizer system.
BK-BK2008E1ENUK.en-uk-Section4.fm Page 3 Wednesday, January 9, 2008 4:22 PM

1-4 Locking and unlocking
1
NOTE●
In the following cases, the
vehicle may not be able to
receive the registered ID code
from the registered key and
the engine may not start. • When the key contacts a key ring or other metallic ormagnetic object (Type A) • When the key grip contacts metal of another key (Type B)• When the key contacts or is close to other immobilizing keys (including keys of other vehicles) (Type C) In cases like these, remove the object or additional key from the vehicle key. Then tr
y again to start the engine.
If the engine does not start, we recommend you to con- tact your MITSUBISHI MOTORS Authorized Service Point.
BK-BK2008E1ENUK.en-uk-Section4.fm Page 4 Wednesday, January 9, 2008 4:22 PM