2013 SSANGYONG TURISMO Service Manual

09-10
4. Self-diagnosis
PAS self-diagnosis mode (outputs warning beep via exterior buzzer) ▶
System enters into this mode when gear shifted "R" position after initial ignition ON
The self-diagnosis fails and the buzzer sounds under any of the following conditions: -
-
Open circuit in sensor (TX)
Open circuit in power wires (+ and -)
In the event of sensor failure itself a.
b.
c.
If normal, warning buzzer sounds for 0.065 seconds. -
Alarm interval during self-diagnosis ▶

09-118790-01
5. Wiring diagram

09-12
6. FLOW CHART

11-38910-05
1. SPECIFICATION
1) Audio Head Unit
Item Specification
Audio Voltage DC 14.4V
Operating voltage DC 10.8V~16.0V
Output 45W/1ch 4ch
Current consumption 5 A or less Up to 10 A
Leakage current 3 mA or less
Radio Frequency FM: 87.5~108MHz
AM: 531~1602KHz
MW: 522~1620KHZ
LW: 144~290KHZ
Preset FM1: 6ch
FM2: 6ch
AM: 6ch
MW : 6ch
LW : 6ch
Usable sensitivity AM: 25dBu
FM: 10dBu
S/N raito (limit value) AM: 54dB
FM: 60dB
LCD Type FSTN
Operating voltage 9.0V VDD: 3.0~3.3V
Operating temperature-30℃ ~ +80℃
Operating temperature-40℃ ~ +85℃
Size (W x H) 132X36
Bluetooth Component MD-5XR (Bluetooth multimedia module)
Application technologyBluetooth 2.0+EDR (Enhanced Data Rate)
Specification Supports HFP, A2DP, AVRCP profile formats
(HFP, A2DP: profile for calling)
(AVRCP: profile for listening music)

11-4
2) Micro Pole Antenna
3) Speaker
Item Specification
Front tweeter speakerSpeaker size 42 mm
Max. input 25 W
Impedance5 KHz of 4Ω ±15%
Front door speakerSpeaker size 6.5 inch
Max. input 40 W
Impedance400 Hz of 4Ω ±15%
Quarter speakerSpeaker size 171X241 mm, 6X9 inch
Max. input 40 W
Impedance300 Hz of 4Ω ±15%
Item Specification
Operating current Max. 150 mA
Operating voltage DC 10.5 V ~ 16 V
Operating temperature-30℃ ~ +60℃
Storage temperature-40℃ ~ +80℃
I/O impedance75Ω (FM)
4) Handsfree microphone
Item Specification
Storage temperature-30 ~ 80℃
Operating temperature-40 ~ 85℃
Sensitivity-35 ± 2 dB
ImpedanceUp to 2.2 ㏀
S/N ratio* 60dB or higher
S/N ratio (signal to noise ratio): Describes noise level in relation to the signal level in dB *

11-58910-05
Audio head unit assembly
Bluetooth setting mode and design changed
Steering wheel switch
- Power button deleted, steering wheel heating (option) switch added
- Design changed
2. MAJOR CHANGES
USB/AUX jack assembly
Ø3.5 3-pole stereo AUX input and USB port used, USB/AUX jack assembly added

11-6
Radio antenna specification changed
Changed to micro pole antenna from glass antenna (with radio antenna amplifier)

11-78910-05
3. CAUTIONS AND WARNING FOR SAFETY
Ssangyong is not liable for any personal injury and material damage, caused by violation of traffic
regulations or neglect of observing actual traffic and driving situations.
Colors on display figures in this manual may differ from actual display due to publication concerns. -
-
Do not disassemble or modify this system.
If doing so, it may cause an accident, fire or electric shock.
Do not use the system if it is malfunctioning (sound or video output problem).
Doing so may lead to an accident or electric shock.
Please contact a Ssangyong service dealer immediately.
The system should be used only when the engine is started.
Using the system for an extended period of the with the engine off may discharge the battery.
Do not leave beverages or foreign materials around the system.
If they enter the system, they may cause a fire.
The system may break down if a disc not supported by this system is inserted.
Do not apply impact to or drop this system.
It might cause malfunction.
Never leave the system in a hot or cold place for an extended period of time. Therefore, do not park
the vehicle in a hot or cold place. The ambient temperature should be -30℃ ~ +80℃ for
proper operation. -
-
-
-
-
-
-