2013 SSANGYONG NEW ACTYON SPORTS Service Manual

03-57410-01
Rear RH seat
Fabric seat Leather seat
- 2 different heating wires according to fabric and leather specification

03-6
3. WARNINGS FOR POWER SEAT
Adjust the driver's seat before driving.
Make sure that the seat is firmly secured after adjusting.
Never drive the vehicle with the head restraint removed or lowered excessively. Otherwise, your neck,
spine or other parts of the body can be severely injured in the event of an accident.
If you recline the seatback excessively, you could slide under the seat belt and be injured severely in a
collision.
Do not put any object that could damage the seat on the seat.
The front and rear seats are equipped with the heated wire (seat warmer) system. Using the seat
warmer system excessively may cause minor burns. The following occupants should exercise special
care when using the heated wire seat. 1.
2.
3.
4.
5.
6.
Infant, child, old or handicapped person
Person with sensitive skin
Exhausted person
Persons who is drunk or took medicine which causes drowsiness such as sleeping pills, cold
tablets, etc. -
-
-
-
Do not place anything on the seat that insulates against the heat, such as a blanket or cushion.
Make sure that the head restraints are in place and secured properly. Never drive the vehicle with the
head restraint removed.
To minimize the injuries in a collision or an abrupt stop, make sure the seatback is in the upright
position before driving. If the seatback is reclined too much, the occupant could slide under the seat
belt in a collision or an abrupt stop and cannot be protected properly by the airbag system. 7.
5.
9.
4. CAUTIONS FOR POWER SEAT
You can operate the power seat with the ignition switch OFF. However, frequent operation of the seat
switch with the engine stopped can result in battery becoming discharged.
Operating more than one seat adjustment switch at the same time can cause damage to the seat
motor. Therefore, operate the seat switch only one at a time.
Do not use organic solvents such as benzene, thinner, alcohol or gasoline to prevent the seat cover
from being damaged while cleaning.
Do not operate the seat position adjustment switch forcefully when the seat does not move or it
contacts an object.
If the power seat is not operated, check and correct the problem before driving off. 1.
2.
3.
4.
5.

03-8
Front seat warmer switch
1. OVERVIEW
The seat consists of the front seats (driver and front passenger) and rear seats.
The heated wires are inserted into the seat cushion and seatback for front seat and is inserted into the
seat cushion for rear seat.
While the front and rear LH/RH seats have 3-point seat belt, rear center seat has 2-point seat belt.
2. SEAT/SEAT BELT LAYOUT
Driver side
Passenger side
Front seat and seat switchFront seat belt (3-point)

03-97410-01
Rear seat warmer switch
Rear seat
Rear seat
warmer switch
3-point seat belt
2-point seat belt Seat belt buckle
Rear seat belts (3-point and 2-point)

03-10
3. HOW TO ADJUST AND OPERATE SEAT
1) Front Seat
There are two types of front seats: the power seat which uses the electric motor to adjust the seat
movement, seatback and seat cushion and
the manual seat which adjusts them by pulling the lever by hand.
For both power seat and manual seat, the driver can adjust the headrest and driver lumbar support by
hand.
The heated wires are inserted into the seatback and the seat cushion, which are operated by the front
seat warmer switch located to the center fascia.
To adjust headrest ▶
To adjust headrest height
To adjust the height of the headrest, raise or
lower it while pressing the headrest sleeve (A).
To adjust headrest tilting
Pull the headrest forwards and release to adjust
its tilting angle in 3 steps.

03-117410-01
Power Seat
To adjust seat slide
Moving the slide knob forward and rearward
activates the slide motor to move the seat forward
and rearward.
To adjust seatback ▶
Manual seat
To adjust seat slide
To move the seat forward or backward, pull and
hold the seat slide lever up and move the seat as
desired. Then, release the lever.
To adjust seat back angle
When moving the upper part of the recline knob
forward/backward, the seatback angle is adjusted
as the recline motor rotates the rail.To adjust seat back angle
To change the seatback angle, lean forward
slightly and raise the lever. Then, lean back to the
desired angle and release the lever. After
adjusting, make sure the lever is returned to its
original position and the seatback is locked.

03-12
Power Seat
To adjust seat cushion angle
When moving the slide switch forward/backward,
the front and rear up/down motors rotate the rails
to move the front and rear side of the cushion
up/down.Manual seat
To adjust seat cushion angle and
height
You can adjust the angle and height of the front o
r
rear section of the seat cushion by rotating the
adjustment knob on the side of the seat clockwise
or counterclockwise.
To adjust seat cushion height
When moving the slide switch up/down,
the front rear up/down motor rotates the rail to
move the whole seat cushion up/down.To adjust driver seat lumbar support
When you raise and lower the lumbar support
lever on the power and manual seats, the lumbar
support goes in and out of the seat.