2000 HONDA CIVIC Workshop Manual

winter tyresgarage door openerservicehigh beamoil pressurefuse box
Popular search:
coolant capacityfuse boxwasher fluidStarteroctaneo ringPage 66
Previous
Next
Load previous 8 pages

Page 1265 of 2189

HONDA CIVIC 2000 6.G Workshop Manual 11.Thoroughly mix the adhesive and hardener together on a glass or metal plate wilh a putty knife. NOTE: . Clean the plate with a sponge and alcohol before mixing. . Follow the instructions that came

Page 1266 of 2189

HONDA CIVIC 2000 6.G Workshop Manual Rear Window Removal 3D: CAUTION: . Put on gloves to ptotect your hands.. Us€ seat cove6 to avoid damaging any surfaces.. Do not damage the rear window defogger grid lines.. Take carg nol scratch the

Page 1267 of 2189

HONDA CIVIC 2000 6.G Workshop Manual tlnstallation 1. 3. Using a knife, scrape the old adhesive smooth to a thickness of about 2 mm (0.08 in.) on the bonding surface around the entire rear window opening flange. NOTE: . Do not scrape do

Page 1268 of 2189

HONDA CIVIC 2000 6.G Workshop Manual Rear Window Installation (contd) Install the fasteners to the hatch as snown. >: Fastener locations, 4 Set the rear window upright on the hatch, then cen-ter it in the opening. Make alignment marks a

Page 1269 of 2189

HONDA CIVIC 2000 6.G Workshop Manual 3 t 9. With a sponge, apply a light coat of body primer to the original adhesive remaining around the rear window opening flange. Let the body primer dry for at least 10 minutes. NOTE: . Do not apply

Page 1270 of 2189

HONDA CIVIC 2000 6.G Workshop Manual Rear WindowOuarter Glass Installation {contd) 13. Use suction cups to hold the rear window over theopening. align it with the alignment marks made inslep 6. and set it down on the adhesive. Lightly p

Page 1271 of 2189

HONDA CIVIC 2000 6.G Workshop Manual Uppcr portion: Lower oortion: PROTECTIVETAPE l ADHESIVE Pillar portion: Carefully remove the quarter glass NOTE: Check the quarter glass trim and clips for damage, and replace them if necessary 3. )

Page 1272 of 2189

HONDA CIVIC 2000 6.G Workshop Manual Quarter Glass Installation (contd) 4. Glue the upper and lower rubber dams to the insideIace of the quaner glass, as shown, to contain theadhesive during installation. NOTE: Be careful not to touch t
Load next 8 pages
Page:   < prev 1-10 ... 1233-1240 1241-1248 1249-1256 1257-1264 1265-1272 1273-1280 1281-1288 1289-1296 1297-1304 ... 2192 next >
navigation updateheaterdisplayfog light bulbTPMSengine oil
Popular search:
bolt patternlightpark assistInjectorsground clearanceD16y7fuse box