2000 HONDA CIVIC Workshop Manual

towingengine oilESP inoperativechild restraintwarning lightsreset infotainment system
Popular search:
tailgateFuse box coneoxygenB16a2headrestrecommended oilfuel type
Previous
Next
Load previous 8 pages

Page 857 of 2189

HONDA CIVIC 2000 6.G Workshop Manual 17. 18. 19. lnstall the reverse idler gear and the gear shaft holder (see page 14-175). lnstall the differential assembly in the torque con- verter housing. Assemble the mainshaft sub-assembly and the

Page 858 of 2189

HONDA CIVIC 2000 6.G Workshop Manual Transmission 26. Slip the special tool onto the mainshaft as shown, MAINSHAFT HOLDER07GAB - PF50101 Installthe park lever on the control shaft. Assemble the one-way clutch and the park gearwith the co

Page 859 of 2189

HONDA CIVIC 2000 6.G Workshop Manual 36. Remove the special tool from mainshaft, then stake each locknut using a 3.5 mm punch as shown COUNTERSHAFTLOCKNUT Set the park lever in the El position, then verify that the park Pawl engages the

Page 860 of 2189

HONDA CIVIC 2000 6.G Workshop Manual Torque Converter/Drive plate 6x1.0mm12 N.m (1.2 kgt.m, 8.7 lbf.ft) / E PLATE 74 N.m 17.5 kgl.m, 54 lbf.ftlTorque in a ctisscaoss oattern. @ @ L 14-182

Page 861 of 2189

HONDA CIVIC 2000 6.G Workshop Manual Transmission 1. lnstallation Flush the ATF cooler as described on page l4-187 and 14-188. Install the torque converter assembly securely with a new O-ring on the mainshaft STARTER MOTOR 14 mm DOWEL PI

Page 862 of 2189

HONDA CIVIC 2000 6.G Workshop Manual Transmission Installation (contdl 9. Attach the torque converter to the drive plate witheight drive plate bolts and torque as follows:Rotate the crankshaft pulley as necessary to tightenthe bolts to

Page 863 of 2189

HONDA CIVIC 2000 6.G Workshop Manual 16. Install a new set ring on the end of each driveshaft 17. Installthe right and left driveshafts (see ssction 16) CAUTION: Whil6 installing the driveshafE in the diffarential, be surs not lo allow

Page 864 of 2189

HONDA CIVIC 2000 6.G Workshop Manual Transmission Installation {contd) Connect the lock-up control solenoid connector. andinstall the transmission ground cable. 6 x 1.0 mm12 N.m {1.2 kgf.m, 8.7 lbl.ft} LOCK.UP CONTROLSOLENOID CONNECTOR
Load next 8 pages
Page:   < prev 1-10 ... 825-832 833-840 841-848 849-856 857-864 865-872 873-880 881-888 889-896 ... 2192 next >
fuse chartjackingdead batterywheel torquefuel typeair conditioning
Popular search:
intake manifoldradiatorengine overheatfilterspare tire locationtransmission oilwidth