2000 HONDA CIVIC Workshop Manual

wiper bladesbootjackingload capacityoil pressurebluetooth
Popular search:
clock resetIgnition diagramoil changediagramP1359air suspensiontrans
Previous
Next
Load previous 8 pages

Page 1041 of 2189

HONDA CIVIC 2000 6.G Workshop Manual Driveshafts Reassembly U.S. and Canada-Producad Driv€shafts Note these items during reassembly . Clean the disassembled parts with solvent, and dry them thoroughly with compressed air, Do not wash

Page 1042 of 2189

HONDA CIVIC 2000 6.G Workshop Manual l/ tt Brazil-Produced Driveshafts Note these items during reassembly . clean the disassembled parts with solvent, and dry them thoroughly with compressed ajr. Do not wash the rubber parts with solvent

Page 1043 of 2189

HONDA CIVIC 2000 6.G Workshop Manual Driveshafts Reassembly (contdl Japan-Produced Driveshafts Note these items during reassembly. . Clean the disassembled pans with solvent, and dry them thoroughly with compressed air. Do not wash the

Page 1044 of 2189

HONDA CIVIC 2000 6.G Workshop Manual lnboard Joint Side: 1, Wrap the splines with vinyl tape to prevent damage to the boots and dynamic damPer. TAPE INBOARD BOOT DYNAMIC DAMPER Install the dynamic damper and inboard boot to the driveshaf

Page 1045 of 2189

HONDA CIVIC 2000 6.G Workshop Manual Driveshafts Reassembly (contdl 8. Fit the inboard joint onto the driveshaft, and note these items: . Reinstall the inboard joint onto the driveshaft by aligning the marks on the inboard joint with th

Page 1046 of 2189

HONDA CIVIC 2000 6.G Workshop Manual l. 11. Set the double loop band onto the boot and dynam- ic damper with the band end toward the front ot the vehicle. LOOP BANO Pull up the slack in the band bY hand Mark a position on the band 10 - 1

Page 1047 of 2189

HONDA CIVIC 2000 6.G Workshop Manual Driveshafts 17. Reassembly (contdl Unwind the boot band tool, and cut off the excess 5- 10 mm (0.2 - 0.4 in) from the clip. 5-10mm10.2 - 0.a inl Secure the end of the boot band by tapping it downwith

Page 1048 of 2189

HONDA CIVIC 2000 6.G Workshop Manual J) 4. lnsert the driveshaft into the outboard joint until the stop ring is close on the ioint. DRIVESHAFT To completely seat the outboard joint, pick up the driveshaft and joint, and drop them from ab
Load next 8 pages
Page:   < prev 1-10 ... 1009-1016 1017-1024 1025-1032 1033-1040 1041-1048 1049-1056 1057-1064 1065-1072 1073-1080 ... 2192 next >
technical specificationscarplayopen bonnetUSB portweightautomatic transmission fluid
Popular search:
11-175CD playerTiming ignitionair bleedingbrakesCigaretteWindow motor