2000 HONDA CIVIC Workshop Manual

Page 1185 of 2189

HONDA CIVIC 2000 6.G Workshop Manual IReassembly
HP* "n ",, hos6 or drv brush to ctoan brake assemblies.
o Use an OSHA-approved vacuum cleanel to avoid brealhing brake dust
. Contaminated brake discs or pads reduce stopping sbility.
. W

Page 1186 of 2189

HONDA CIVIC 2000 6.G Workshop Manual Rear Brake Caliper
Reassembly (contdl
L
PARKING NUT28 N.m (2.8 kgt m,20 rbr.trt
Pack all cavities of the needle bearing with the rec,
ommended rubber grease in the caliper seal set,
Coat a new cam bo

Page 1187 of 2189

HONDA CIVIC 2000 6.G Workshop Manual 10. lnstall the special tool onto the spring cover, and
turn the shaft until the locknut contacts the plate.
Check that the flared end of the spring cover is below
the circlip groove.
Install the circ

Page 1188 of 2189

HONDA CIVIC 2000 6.G Workshop Manual Rear Brake Caliper
Reassembly (contdl
16. Installthe pad spring onto the caliper.
Apply the recommended pin groase in the caliper
seal set to the sliding surface of the pins and inside
of the new pi

Page 1189 of 2189

HONDA CIVIC 2000 6.G Workshop Manual Rear Drum Brake
Index/lnspection
1.
a
a
Never use an air hose or dly brush to clean brake assemblies,
Use an OSHA approved vacuum cleanar to avoid breathing brake dust,
Contaminated brake linings or

Page 1190 of 2189

HONDA CIVIC 2000 6.G Workshop Manual Rear Drum Brake
Inspection
1.
4.
Check the wheel cylinder for leakage.
Check the brake linings for cracking, glazing, wear,
and contamination.
Measure the brake lining thickness.
Brake Lining Thicknes

Page 1191 of 2189

HONDA CIVIC 2000 6.G Workshop Manual t-
Brake Shoe Disassembly
1. Remove the tension pins by pushing the retainer
springs and turning them.
TENSION PINS
RETAINER SPRINGS
Lower the brake shoe assembly, and remove the
lower return spring.

Page 1192 of 2189

HONDA CIVIC 2000 6.G Workshop Manual Rear Drum Brake
Brake Shoe Reassembly {contdl
Connect the parking brake cable to the parking
brake lever.
Apply grease on each sliding surface.
!@ contaminated brake linings reduce
stopping ability.