1998 HONDA INTEGRA Workshop Manual

Page 401 of 1681

HONDA INTEGRA 1998 4.G Workshop Manual Synchro Ring, Gear
Inspection
1. Inspect the synchro ring and gear.
Ar Inspect the inside of the synchro ring for wear.
B: Inspect the teeth on the synchro ring tor wear(rounded off).
ccGOOD WORN
C: I

Page 402 of 1681

HONDA INTEGRA 1998 4.G Workshop Manual Clutch Housing Bearing
Replacement
Mainshaft:
L Remove the ball bearing using the special tools as
shown.
3/8" .16 SLIDE HAMMER
{Commorcially avsil.blo)
ADJUSTABLE BEARINGPULLER. 25 - 40 mm07736 - A0

Page 403 of 1681

HONDA INTEGRA 1998 4.G Workshop Manual Countershaft:
1. Bend the tab on the lock washer down, then remove
the bolt and bearing retainer plate.
CLUTCH
;:-<I
Il{oustNG
2.Remove the needle bearing using the special
as shown, then remove the o

Page 404 of 1681

HONDA INTEGRA 1998 4.G Workshop Manual Mainshaft Thrust Glearance
1. Remove the 72 mm thrust shim and oil guide plate
from the transmission housing
72 mm THRUST SHIM
Adiustment
TRANSMISSIONHOUSING
\,
Bo
OIL GUIDE PLATE
Install the 3rd/4th

Page 405 of 1681

HONDA INTEGRA 1998 4.G Workshop Manual I
\
72 mm Thrust Shim
Part NumberThickness
23931 - P21 -0000.60 mm (0.0236 in)
B23932-P21-0000.63 mm (0.0248 in)
c23933 - P21 -0000.66 mm (0.0260 in)
D23934 P21 0000.69 mm (0.0272 in)
E23935 P21 - 000

Page 406 of 1681

HONDA INTEGRA 1998 4.G Workshop Manual Mainshaft Thrust Clearance
g. Slide the mainshaft base over the mainshaft.
Adjustment (contdl
/\
/-
MAINSHAFT BASE07GAJ - PG20130
Aftach the mainshaft holder to the mainshaft as fol-
lows:
NOTE:
o Ea

Page 407 of 1681

HONDA INTEGRA 1998 4.G Workshop Manual I
t
\
Transmission
Reassembly
1. Install the new oil seal.
2. Set the change piece.
3. lnstall the shift rod.
4. Install the steel ball, the spring, and the set screw.
5. Install the change piece atta

Page 408 of 1681

HONDA INTEGRA 1998 4.G Workshop Manual Transmission
Reassembly (contdl
1t. lnstallthe change holder assembly.
6x1.0mm15 N.m (1.5 kgf.m,11 rbf.ft)
lnstall the shift piece and the
the shift piece shaft.
interlock, then installt2.
6x1.0mm