2011 Lexus CT200h Owner's Manual (in English)

545
4-3. Do-it-yourself maintenance
4
Maintenance and care
CT200h_EE (OM76041E)License plate lights
Open the back door and remove
the cover.
Use a flathead screwdriver
wrapped in a cloth.
Turn the bulb base counter-
clockwise.
Remove the light bulb.
STEP1
STEP2
STEP3

546
4-3. Do-it-yourself maintenance
CT200h_EE (OM76041E)Lights other than the above
If any of the lights listed below has burnt out, have it replaced by
any authorized Lexus dealer or repairer, or another duly quali-
fied and equipped professional.
Headlight low beams (LED type)
Front position lights and daytime running lights
Side turn signal lights
Stop/tail lights
High mounted stoplight
Outer foot light
After replacing the bulbs
After lifting up the air cleaner duct or
removing the power control unit cover,
return the duct or the cover to their origi-
nal positions with the clips.
Push up center portion
Insert
Press

547
4-3. Do-it-yourself maintenance
4
Maintenance and care
CT200h_EE (OM76041E)
LED lights
The headlight low beams (LED type), front position lights, daytime running
lights, side turn signal lights, stop/tail lights and high mounted stoplight
consist of a number of LEDs. If any of the LEDs burn out, take your vehicle
to any authorized Lexus dealer or repairer, or another duly qualified and
equipped professional to have the light replaced.
Condensation build-up on the inside of the lens
Contact any authorized Lexus dealer or repairer, or another duly qualified
and equipped professional for more information in the following situations.
Temporary condensation build-up on the inside of the headlight lens does
not indicate a malfunction.
Large drops of water have built up on the inside of the lens.
Water has built up inside the headlight.
When replacing light bulbs
P. 5 3 2
CAUTION
Replacing light bulbs
Turn off the lights. Do not attempt to replace the bulb immediately after
turning off the lights.
The bulbs become very hot and may cause burns.
Do not touch the glass portion of the light bulb with bare hands. Hold the
bulb by the plastic or metal portion.
If the bulb is scratched or dropped, it may blow out or crack.
Fully install light bulbs and any parts used to secure them. Failure to do so
may result in heat damage, fire, or water entering the headlight unit. This
may damage the headlights or cause condensation to build up on the lens.
To prevent damage or fire
Make sure bulbs are fully seated and locked.

548
4-3. Do-it-yourself maintenance
CT200h_EE (OM76041E)

5When trouble arises
549
CT200h_EE (OM76041E)
5-1. Essential information
Emergency flashers .......... 550
If your vehicle needs to be
towed.............................. 551
If you think something is
wrong ............................. 5575-2. Steps to take in an
emergency
If a warning light turns on
or a warning buzzer
sounds ............................ 558
If a warning message is
displayed ........................ 565
If you have a flat tire
(vehicles with a spare
tire) ................................ 586
If you have a flat tire
(vehicles without a spare
tire) ................................ 600
If the hybrid system will not
start ................................ 614
If you lose your keys ....... 616
If the electronic key does
not operate properly....... 617
If the 12-volt battery is
discharged ...................... 620
If your vehicle overheats . 627
If the vehicle becomes
stuck............................... 632
If your vehicle has to be
stopped in an
emergency...................... 634

550
CT200h_EE (OM76041E)
5-1. Essential information
Emergency flashers
NOTICE
To prevent 12-volt battery discharge
Do not leave the emergency flashers on longer than necessary when the
hybrid system is not operating.
Use the emergency flashers if the vehicle malfunctions or is involved
in an accident.
Press the switch to flash all
the turn signal lights. To turn
them off, press the switch
once again.

5
551
5-1. Essential information
When trouble arises
CT200h_EE (OM76041E)
If your vehicle needs to be towed
Before towing
The following may indicate a problem with your hybrid transmis-
sion. Contact any authorized Lexus dealer or repairer, or another
duly qualified and equipped professional before towing.
The hybrid system is operating but the vehicle will not move.
The vehicle makes an abnormal sound.
If there is a malfunction in the P position control system, the smart
entry & start system or the immobilizer system, or if the 12-volt
battery is discharged, the vehicle cannot be towed with the front
wheels on the ground, as the front wheels may be locked. In this
case, transport the vehicle with both front wheels or all four wheels
lifted.
If towing is necessary, we recommend having your vehicle towed by
any authorized Lexus dealer or repairer, or another duly qualified and
equipped professional or a commercial towing service, using a lift-
type truck or flat bed truck.
Use a safety chain system for all towing, and abide by all state/provin-
cial and local laws.

552
5-1. Essential information
CT200h_EE (OM76041E)
Emergency towing
If a tow truck is not available in
an emergency, your vehicle
may be temporarily towed
using a cable or chain secured
to the emergency towing eye-
let(s). This should only be
attempted on hard surfaced
roads for short distances at
under 30 km/h (18 mph).
A driver must be in the vehicle
to steer and operate the brakes.
The vehicle’s wheels, drive
train, axles, steering and brakes
must be in good condition.