Page 585 of 683

You can change the vehicle speed
setting at which the warning is
triggered.
▼120 km/h Warning Beep*
If the vehicle speed exceeds 120
km/h, a chime sounds for 5 seconds.
▼Blind Spot Monitoring (BSM)
Warn in g Beep*
The Blind Spot Monitoring (BSM)
warning beep operates when the
direction indicator lever is operated to
the side where the Blind Spot
Monitoring (BSM) warning light is
illuminated.
▼Front Cross Traffic Alert (FCTA)
Warn in g Beep*
The Front Cross Traffic Alert (FCTA)
warning beep is activated if there is a
possibility of collision with a vehicle
approaching from the front on the left
and right sides of the vehicle.
▼Rear Cross Traffic Alert (RCTA)
Warn in g Beep*
The Rear Cross Traffic Alert (RCTA)
warning beep is activated if there is a
possibility of collision with a vehicle
approaching from the rear on the left
and right sides of the vehicle.
▼Lane Departure Warning Sound*
While the system is operating, if the
system determines that the vehicle may
depart from the lane, it sounds a
warning sound.
NOTE
The volume of the Lane Departure
Warning System (LDWS) warning
sound can be changed.
Refer to the Settings section in the
Mazda Connect Owner's Manual.
▼Mazda Radar Cruise Control
(MRCC) System Warnings*
The Mazda Radar Cruise Control
(MRCC) system warnings notify the
driver of system malfunctions and
cautions on use when required.
Check based on the beep sound.
Warning beep type Notification content
The beep sounds 1
time while the Mazda
Radar Cruise Control
(MRCC) is operatingThe vehicle speed is
slower than 25 km/h
(16 mph) and the
Mazda Radar Cruise
Control (MRCC) sys-
tem has been cancel-
led.
The beep sounds in-
termittently while the
Mazda Radar Cruse
Control (MRCC) is op-
erating.The distance between
your vehicle and the
vehicle ahead is too
close. Check the safety
of the surrounding
area and reduce vehi-
cle speed.
▼Mazda Radar Cruise Control with
Stop & Go function (MRCC with
Stop & Go function) System
Warnings
*
The Mazda Radar Cruise Control with
Stop & Go function (MRCC with Stop
& Go function) system warnings notify
the driver of system malfunctions and
cautions on use when required.
Check based on the beep sound.
Warning beep type Notification content
The beep sounds 1
time while the Mazda
Radar Cruise Control
with Stop & Go func-
tion (MRCC with Stop
& Go function) is op-
eratingIf a malfunction occurs
in the system, make
sure that the Mazda
Radar Cruise Control
with Stop & Go func-
tion (MRCC with Stop
& Go function) has
been cancelled.
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
*Some models.7-71
Page 586 of 683

Warning beep type Notification content
The beep sounds in-
termittently while the
Mazda Radar Cruise
Control with Stop &
Go function (MRCC
with Stop & Go func-
tion) is operating.The distance between
your vehicle and the
vehicle ahead is too
close. Check the safety
of the surrounding
area and reduce vehi-
cle speed.
▼Excessive Speed Warning*
If the vehicle speed exceeds the speed
limit sign displayed in the active driving
display/instrument cluster, the area
around the speed limit sign flashes in
amber and the warning sound is
activated at the same time. If the
vehicle speed continues to exceed the
displayed speed limit sign, the
indication stops flashing and remains
on.
▼Speed Limiter Warning Beep*
If the vehicle speed exceeds the set
speed by about 5 km/h (3 mph) or
more, a warning beep operates
continuously. The warning beep
operates until the vehicle speed
decreases to the set speed or less.
CAUTION
If the set speed is set lower than the
current vehicle speed by pressing the
RES switch down (SET-) the warning
beep is not activated for about 30
seconds even if the vehicle speed is
faster than the newly set speed by 5
km/h (3 mph). Be careful not to drive
over the set speed.
NOTE
When the system is temporarily
cancelled by depressing the accelerator
pedal fully, the ISA/ASL display shows
the cancel display. Even if the vehicle
speed exceeds the set speed by about
5 km/h (3 mph) or more while the
cancel display is displayed, the warning
sound is not operated.
▼Collision warning*
If there is a possibility of a collision
with a vehicle ahead or an obstruction
at the rear of the vehicle, a warning
sound is activated intermittently at the
same time as the warning indications
are displayed in the instrument cluster
or active driving display.
▼Door-ajar Warning Beep
A warning beep is actived if the vehicle
is driven with any door or liftgate ajar.
Drive the vehicle after closing the
doors and liftgate.
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
7-72*Some models.
Page 587 of 683
When Liftgate Cannot be
Opened
▼When Liftgate Cannot be Opened
If the battery is dead, the liftgate
cannot be unlocked and opened.
In this case, the liftgate can be
unlocked by taking care of the dead
battery situation.
Refer to Jump-Starting on page 7-39.
If the liftgate cannot be unlocked even
if the dead battery situation has been
resolved, the electrical system may
have a malfunction.
In this case, the liftgate can be opened
using the following procedure as an
emergency measure.
1. Wrap the end of a
flathead
screwdriver in a cloth and remove
the cap on the interior surface of
the liftgate using it.
2. Turn the lever to the right to unlock
the liftgate.
(With power liftgate)
(Without power liftgate)
After performing this emergency
measure, have the vehicle inspected at
an expert repairer (we recommend an
Authorised Mazda Repairer) as soon as
possible.
If Trouble Arises
When Liftgate Cannot be Opened
7-73
Page 588 of 683
If the Active Driving
Display Does Not
Operate
▼If the Active Driving Display Does
Not Operate
If the active driving display does not
operate, switch the ignition off and
then restart the engine. If the active
driving display does not operate even
with the engine restarted, have the
vehicle inspected at an expert repairer
(we recommend an Authorised
Mazda Repairer).
If Trouble Arises
Active Driving Display Does Not Operate
7-74
Page 589 of 683
Windscreen Wipers
Operate at High Speed
▼Windscreen Wipers Operate at
High Speed
The windscreen wipers may operate at
high speed if there is a problem with
the wiper control. If the windscreen
wipers operate at high speed
regardless of the wiper switch
operation, have your vehicle inspected
by an expert repairer (we recommend
an Authorised Mazda Repairer).
If Trouble Arises
Windscreen Wipers Operate at High Speed
7-75
Page 590 of 683
Page 591 of 683
8Customer Information
Important consumer information including warranties and add-
on equipment.
Warranty..................................8-2
Registering Your Vehicle in A
Foreign Country..................... 8-2
Add-On Non-Genuine Parts and
Accessories........................... 8-2
Cell Phones.............................. 8-4
Cell Phones Warning.............. 8-4
Collection and Processing of Data in
the Vehicle............................... 8-5
Collection and Processing of Data
in the Vehicle........................ 8-5
Declaration of Conformity......... 8-9
Declaration of Conformity ...........
............................................ 8-9
Electromagnetic
Compatibility......................... 8-66
Electromagnetic
Compatibility...................... 8-66
Collection/Disposal of Old
Equipment/Used Battery......... 8-68
Information for Users on
Collection and Disposal of Old
Equipment and Used
Batteries.............................. 8-68
8-1
Page 592 of 683

Registering Your Vehicle
in A Foreign Country
▼Registering Your Vehicle in A
Foreign Country
Registering your vehicle in a foreign
country may be problematic
depending on whether it meets the
specific emission and safety standards
of the country in which the vehicle will
be driven. Consequently, your vehicle
may require
modifications at personal
expense in order to meet the
regulations.
In addition, you should be aware of
the following issues:
Satisfactory vehicle servicing may be
difficult or impossible in another
country.
The fuel specified for your vehicle may
be unavailable.
Parts, servicing techniques, and tools
necessary to maintain and repair your
vehicle may be unavailable.
There might not be an Authorised
Mazda Repairer in the country you
plan to take your vehicle.
The Mazda warranty is valid only in
certain countries.
Add-On Non-Genuine
Parts and Accessories
▼Add-On Non-Genuine Parts and
Accessories
Please note that technical alterations
to the original state of your Mazda
vehicle can
affect the safety of the
vehicle. Such technical alterations
include not only the use of unsuitable
spare parts, but also accessories,
fittings or attachments, including rims
and tyres.
Genuine Mazda Parts and Genuine
Mazda Accessories have been
specifically designed for Mazda
vehicles.
Other parts and accessories than those
mentioned above have not been
examined and approved by Mazda
unless explicitly stated by Mazda. We
cannot certify the suitability of such
products. Mazda is not liable for any
damage caused by the use of such
products.
WARNING
Be very careful in choosing and
installing add-on electrical
equipment, such as mobile
telephones, two-way radios, stereo
systems, and car alarm systems:
Incorrectly choosing or installing
improper add-on equipment or
choosing an improper installer is
dangerous. Essential systems could be
damaged, causing engine stalling ,
air-bag (SRS) activation,
ABS/TCS/DSC inactivation, or a fire in
the vehicle.
Mazda assumes no responsibility for
death, injury, or expenses that may
Customer Information
Warranty
8-2