Page 449 of 828
02-358710-01
The defogger system uses the heated glass to remove the moisture and frost on the windows,
which can disturb safe driving.
The defogger (including de-icer) activates the corresponding switch and the STICS controls the
operating time.
Tailgate and outside rearview mirror heate
d
glass switch
Pressing switch activates tailgate and
outside rearview mirror heated glass for
approx. 12 minutes
Windshield heated glass (de-icer) switch
Pressing switch activates windshield heated
glass for approx. 12 minutes
Page 450 of 828
02-36
▶Front Defogger Timer
The front defogger output is "ON" when turning on the front defogger switch with the
engine started (IGN ON)
The output stops when turning on the front defogger switch again during its operation.
The output is "ON" only for 6 minutes when turning on the front defogger switch within 10
minutes after completion of output for 12 minutes. This can be done only once.
The output is "OFF" when the ignition switch is "OFF". 1.
2.
3.
4.
Page 451 of 828
02-378710-01
▶Rear Defogger Timer
The rear defogger output is "ON" when turning on the rear defogger switch with the engine
started (IGN ON)
The output stops when turning on the rear defogger switch again during its operation.
The output is "ON" only for 6 minutes when turning on the rear defogger switch within 10
minutes after completion of output for 12 minutes. This can be done only once.
The output is "OFF" when the ignition switch is "OFF". 1.
2.
3.
4.
Page 452 of 828
02-38
▶Headlamp Control (Escort)
The headlamp control supplies the power to headlamp relay for 20 seconds and turns off
when receiving the escort signal from the remote control key after receiving the lock signal
from the remote control key (armed) with the ignition switch off.
If the escort signal is received again during this time, the operation is extended once for
20 seconds.
However, only when the system is in armed mode when receiving the escort signal from
the remote control key, the power supply and output is turned on.
The headlamp relay output is turned off immediately after receiving the lock signal from
the remote control key during its operation.
However, signals other than lock or escort signal from the remote control key will be
overridden. 1.
2.
Page 453 of 828
02-398710-01
▶Door Lock/Unlock Control by Door Lock Switch
The door lock system outputs "LOCK" signal for 0.5 seconds when positioning the driver's
or passenger's door lock knob to the lock from unlock position.
The door lock system outputs "UNLOCK" signal for 0.5 seconds when positioning the
driver's or passenger's door lock knob to the unlock from lock position.
"LOCK" or "UNLOCK" by the door lock switch is ignored when outputting the "LOCK" or
"UNLOCK" signal by other functions.
All door lock signals are "UNLOCK" for 0.5 seconds just for once when receiving the
"LOCK" signal within 0.5 seconds after closing the driver's or passenger's door while the
ignition key is removed. 1.
2.
3.
4.
Page 454 of 828
02-40
▶Door Lock/Unlock Control by Central Door Lock Switch
When the central door lock switch is activated, LOCK/UNLOCK output is performed.
(However, if the driver's/passenger's lock switch is previously locked, UNLOCK output is
performed and if the driver's/passenger's lock switch is unlocked, LOCK output is
performed.)
The input of the central door lock switch is overridden in armed mode. 1.
2.
Page 455 of 828
02-418710-01
▶Door Lock/Unlock Control by Remote Control Key
The door lock relay output is "ON" for 0.5 seconds when receiving the lock signal from the
remote control key.
The door unlock relay output is "ON" for 0.5 seconds when receiving the unlock signal
from the remote control key. 1.
2.
Page 456 of 828

02-42
The door lock system outputs "LOCK" when the vehicle speed maintains over 30 km/h.
However, it doesn't output "LOCK" when all doors are locked or failed.
If any of doors is unlocked after outputting "LOCK" in step 1, outputs "LOCK" up to 5 times
(except step (1)) at the interval of one second.
If any of doors is unlocked after 5 times of "LOCK" outputs, the door
(driver's/passenger's/rear) is regarded as "FAIL".
If the door that was regarded as fail is changed (UNLOCK to LOCK), it will be recognized
as a normal one.
If any door is regarded as FAIL, the auto door lock function does not work. (if it is
occurred when the vehicle speed is over 30 km/h, the auto door lock output does not
occur even if the vehicle speed falls below 30 km/h and accelerates again to over 30
km/h.) Nonetheless, the central door lock function works properly.
When the system receives "UNLOCK" signal from a door switch, it outputs "LOCK" signals
5 times. If additional "LOCK" signal from another door switch is detected during the
period, the system outputs five "LOCK" signals 5 times for the switch.
The door lock system outputs "UNLOCK" automatically if the "LOCK" output conditions are
established by this function or the key is cycled (IGN=OFF) (even when there is no "LOCK"
output while the vehicle speed maintains over 30 km/h under lock condition).
(If the LOCK condition is established with the ignition switch ON, the system outputs
UNLOCK signal unconditionally when turning the ignition switch to OFF position.)
However, when the ignition key is turned to "OFF" position, the lock output conditions will
be cancelled.
The "FAIL" condition of the door will be erased when the ignition key is turned to "OFF"
position. 1.
2.
3.
4.
5.
6.
7.
8. ▶Auto Door Lock
T2: 0.5 s
(*1) LOCK: Driver's & Passenger's & Rear door & = Lock