1996 HONDA CIVIC Workshop Manual

ground clearance radio controls navigation suspension adblue reset display

Page 513 of 2189

HONDA CIVIC 1996 6.G Workshop Manual lntake Air System
Air Cleaner (ACLI
NOTE: Do not clean the ACL element it with com-pressed air {except dry type).
D16Y5, D16Y8, 816A2 engine:
ACL ELEMENTNormal conditions:Replace air cleaner element e

Page 514 of 2189

$HONDA CIVIC 1996 6.G Workshop Manual \J 816A2 engine: DEFLECTION10-12mmBla- 112inl CABLE ADJUSTINGBRACKET NUT t lf deflection is not within specs loosen the locknut turn the adjusting nut untilthe deflection is as speci- fied, then ret$

Page 515 of 2189

HONDA CIVIC 1996 6.G Workshop Manual Intake Air System
Throttle Cable (contdl
4. Set the locknut on the cable bracket. Adjust theadjusting nut so that its free play is O mm.
5. Bemove the cable sheath from the throttle bracket,reset the

Page 516 of 2189

HONDA CIVIC 1996 6.G Workshop Manual IThrottle BodY
Description
The throttle bodY is either a single-barrel side-draft type
(D16Y5, D16Y8, 816A2 engine) or a down-draft type
(D16Y/ engine). The lower portion ot the throttle valve is
heat

Page 517 of 2189

HONDA CIVIC 1996 6.G Workshop Manual Intake Air System

J
Throttle Body (contdl
Removal
D16Y5, Dl6Y8, 81642 engine:
D15Y7 engine:
AIR CLEANER
{ACLI
22 N.m12.2 kgl.m,16 rbf.ftl
NOTE:
. Do not adjust the throttle stop screw.. After reasse

Page 518 of 2189

$HONDA CIVIC 1996 6.G Workshop Manual \ Disasssmbly Dl6Y5, Dl6Y8 engine: 2.1 N.m(0.21 ksf.m, 1.5 lblftl\ bY TP SENSOR MAPSENSORTroubleshooting, Page 11 115 3.5 N.m t0.35 kgl m,2.5 lblftl B16A2 sngine: MAP SENSORTroubleshooting, page 1 11$

Page 519 of 2189

HONDA CIVIC 1996 6.G Workshop Manual Intake Air System
Fuel Injection Air (FlA) Controt System I99 - 00 Dl6yg enginel
Dsscription
When the engine running lengine coolant below 149oF (6S"C)], the fuel Injection Air (FtA) Control Valve se

Page 520 of 2189

$HONDA CIVIC 1996 6.G Workshop Manual \J Fuol Iniection Air {FlA) Contlol Valve T$ting 1. Start the engine. 2. Remove the vacuum hose from the fitting on the intake air duct, and connect a vacuum gauge to the nose. NOTE: Engine coolant te$

Load next 8 pages

Page: < prev 1-10 ... 481-488 489-496 497-504 505-512 513-520 521-528 529-536 537-544 545-552 ... 2192 next >

emergency towing wheel bolts mileage coolant reservoir gas type ABS