1996 HONDA CIVIC Workshop Manual

gas tank size oil dipstick service tow lug pattern headrest

Popular search:

23-220 charging steering pistons clock reset air bleeding under-hood fuse

Load previous 8 pages

Page 481 of 2189

HONDA CIVIC 1996 6.G Workshop Manual ldle Control System
lgy"t9!"_"ring Pressure (PSPI Switch Signal
(96 - 98 Models, 99 - 00 DlGy5 engine witn fU/f) (USAI
This signals the ECM/ PCN4 when the power steering load is high.
ECM/PCM CONNEC

Page 482 of 2189

HONDA CIVIC 1996 6.G Workshop Manual t
(From page 11 212)
Check lor a 3hort in the PSP
switch:1. Turn the ignition switch OFF.
2. Disconnect the 2P connector
from the PSP switch.
3. Turn the ignition switch ON (ll)
4. Measure voltage bet

Page 483 of 2189

HONDA CIVIC 1996 6.G Workshop Manual ldle Control System
Power Steering Pressure (PSP) Switch Signal
(99 - 00 Models except Dl6y5 engine with M/T) (USAI
This signals the ECM/PCM when the power steering load is high.
Wire side of female

Page 484 of 2189

$HONDA CIVIC 1996 6.G Workshop Manual \ (From page 112141 Check lor a short in tho PSP swhch:1. Turn the ignition switch OFF 2. Disconnect the 2P connector from the PSP switch 3. Turn the ignition switch ON {ll) 4. Measure vohage between$

Page 485 of 2189

HONDA CIVIC 1996 6.G Workshop Manual ldle Control System
Automatic Transaxle (CVTI Gear Position Signal
(96 -98 D16Y5 engine with CW)
ATP NP{LT GRNI
INP
GBN)
This signals the ECM when the transmission is in @ or @ position.
Check the op

Page 486 of 2189

HONDA CIVIC 1996 6.G Workshop Manual t
L
(From page 11-216)- Repair open in the wire
between the ECM {C291 and
lhe Ituge assomblv.- Repair open in the wire
betwoen the gauge assembly
and the A/T gea. Positionswitch.
ls there less than 1.

Page 487 of 2189

$HONDA CIVIC 1996 6.G Workshop Manual ldle Control System { ( a Clutch Switch Signal (Dl6YS engine with M/Tl This signals the ECM when the clutch is engaged. A {32P} ECM CONNECTORS LGl (BRN/BLK) \- cLsw(RED} Inrpaction ot dutch rwitch sig$

Page 488 of 2189

HONDA CIVIC 1996 6.G Workshop Manual {From page 11-218)
Check lho clutch switch:
1. Turn the ignition switch OFF.
2. Disconnect the 2P connector
from the clutch switch.
3. Check lor continuity between
the clutch switch connector
terminal

Load next 8 pages

Page: < prev 1-10 ... 449-456 457-464 465-472 473-480 481-488 489-496 497-504 505-512 513-520 ... 2192 next >

service schedule tyre pressure garage door opener fuses inflation pressure maintenance reset

Popular search:

timing belt tail light fuel tank capacity Lock cylinder power steering pump bracket motor cam Accessory socket connector