2017 MAZDA MODEL CX-5 Owner's Manual - RHD (UK, Australia) (in English)

Type A
Type B
Without spare tyre
Jack lever
Towing eyelet
Emergency flat tyre
repair kit
Jack lever Towing eyelet
Emergency flat tyre
repair kit
If Trouble Arises
Flat Tyre
7-16
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

▼Jack*
To remove the jack
1. Open the luggage board, and lift it.
2. Remove the jack.
To secure the jack
Perform the removal procedure in reverse.
Maintenance
•Always keep the jack clean.
•Make sure the moving parts are kept
free from dirt or rust.
•Make sure the screw thread is
adequately lubricated.
▼Spare Tyre*
Your Mazda has a tem
porary spare tyre.
The temporary spare tyre is lighter and
smaller than a conventional tyre, and is
designed only for emergency use and
should be used only for VERY short
periods. Temporary spare tyres should
NEVER be used for long drives or
extended periods.
WA R N I N G
Do not install the temporary spare tyre on
the front wheels (driving wheels):
Driving with the temporary spare tyre on
one of the front driving wheels is
dangerous. Handling will be affected. You
could lose control of the vehicle, especially
on ice or snow bound roads, and have an
accident. Move a regular tyre to the front
wheel and install the temporary spare tyre
to the rear.
CAUTION
 When using the temporary spare tyre,
driving stability may decrease compared
to when using only the conventional
tyre. Drive carefully.
 To avoid damage to the temporary spare
tyre or to the vehicle, observe the
following precautions:
 Do not exceed 80 km/h (50 mph).
If Trouble Arises
Flat Tyre
*Some models.7-17
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

Avoid driving over obstacles. Also, do
not drive through an automatic car
wash. This tyre's diameter is smaller
than a conventional tyre, so the
ground clearance is reduced.
 Do not use a tyre chain on this tyre
because it will not fit properly.
 Do not use your temporary spare tyre
on any other vehicle, it has been
designed only for your Mazda.
 Use only one temporary spare tyre on
your vehicle at the same time.
To remove the spare tyre
1. Open the luggage board, and remove it.
2. For vehicles equipped with asub-woofer, uncouple the connector.
Connector
NOTE
Extra strength may be required to
uncouple the connector. Be sure to
squeeze the tab firmly.
If Trouble Arises
Flat Tyre
7-18
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

3. For vehicles equipped with asub-woofer, loosen the hold-down bolt
and remove the woofe r and spare tyre.
For vehicles not equipped with a
sub-woofer, turn the spare tyre
hold-down bolt anticlockwise and
remove the spare tyre.
Spare tyre hold-down bolt
To secure the spare tyre
Store the spare tyre in the reverse order of
removal. After storing, verify that the
spare tyre is stored securely.
Emergency Flat Tyre
Repair Kit
*
The emergency flat tyre repair kit included
with your Mazda is for a temporary repair
of a slightly damaged flat tyre resulting
from running over nails or similar sharp
objects on the road surface.
Perform the emergency flat tyre repair
without removing the nail or similar sharp
object which punc tured the tyre.
NOTE
Your vehicle is not eq uipped with a spare
tyre. In the event of a flat tyre, use the
emergency flat tyre repair kit to repair the
tyre temporarily. When doing the repair,
refer to the instruct ions included in the
emergency flat tyre repair kit. If an
emergency repair was performed on a flat
tyre using the emergency flat tyre repair
kit, have an expert repairer, we
recommend an Authorised Mazda
Repairer, repair or replace the tyre as
soon as possible.
If Trouble Arises
Flat Tyre
*Some models.7-19
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

▼About the Emergency Flat Tyre
Repair Kit
The emergency flat tyre
repair kit includes
the following items.

Tyre sealant Injection hose
Compressor Valve core
tool
Spare valve
core
Speed restriction
sticker
Instructions
WA R N I N G
Do not allow children to touch the tyre
sealant:

Ingestion of tyre sealant is dangerous. In
the event tyre sealant is accidentally
swallowed, drink large amounts of water
immediately and seek medical
assistance.
 Tyre sealant that comes into contact
with the eyes and skin is dangerous. If
tyre sealant enters the eyes or contacts
the skin, flush immediately with large
amounts of water and seek medical
assistance.
NOTE
•The tyre sealant cannot be reused.
Purchase new tyre sealant at an
Authorised Mazda Repairer.
•The emergency flat tyre repair kit cannot
be used in the following cases.
Consult an expert repairer, we
recommend an Authorised Mazda
Repairer.
•The period of effective use for the tyre
sealant has expired. (The period of
effectiveness is indicated on the bottle
label.)
•The tear or puncture exceeds about 4
mm (0.16 in).
•The damage has occurred to an area
of the tyre other than the tread.
•The vehicle has been driven with
nearly no air remaining in the tyre.
•The tyre has come off the wheel rim.
•Damage to the wheel rim has
occurred.
•The tyre has two or more punctures.
▼ Using the Emergency Flat Tyre
Repair Kit
1. Park on a level surface off the
right-of-way and set the parking brake.
2. Put a vehicle with an automatic
transaxle in Park (P), a manual
transaxle in Reverse (R) or 1, and turn
off the engine.
3. Turn on the hazard warning flasher.
If Trouble Arises
Flat Tyre
7-20
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

4. Unload passengers and luggage, andremove the emergency flat tyre repair
kit.
Type A
Type B
5. Shake the tyre sealant well.
CAUTION
If the bottle is shaken after the injection
hose is screwed on, tyre sealant could
spray out from the injection hose. Tyre
sealant contacting clothing or other
objects may be impossible to remove.
Shake the bottle before screwing on the
injection hose.
NOTE
The tyre sealant can be used at outside
temperatures down to
－30°C (－
22°F).
In extremely cold temperatures (0°C
(32°F) or below), the tyre sealant
hardens easily and injection of the
sealant will be difficult. Warm the
sealant inside the vehicle before doing
the injection work.
6. Remove the cap from the bottle. Screw
on the injection hose with the bottle's
inner cap left on to break the inner cap.

Injection hose
Bottle
If Trouble Arises
Flat Tyre
7-21
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

7. Remove the valve cap from the flattyre. Press the back of a valve core tool
to the core of the tyre valve and bleed
all the remaining air.

Valve core tool
Valve
Valve cap
CAUTION
If there is air remaining in the tyre when
the valve core is removed, the valve
core could fly out. Remove the valve
core carefully.
8. Turn the valve core anticlockwise with the valve core tool and remove the
valve core.

Valve Valve core
NOTE
Store the valve core in a place where it
will not get dirty.
9. Remove the plug from the injectionhose and insert the injection hose into
the valve.

Injection hose
Plug
10. Hold the bottom of
the bottle upright,
squeeze the bottle with your hands,
and inject the entire amount of tyre
sealant into the tyre.

Valve
NOTE
The tyre sealant cannot be reused.
Purchase a new tyre sealant kit at an
Authorised Mazda Repairer.
11. Pull out the injection hose from the
valve. Reinsert the valve core into the
valve and turn it cloc kwise to install it.
If Trouble Arises
Flat Tyre
7-22
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

NOTE
Do not throw away the empty tyre
sealant bottle after use. Return the
empty tyre sealant bottle to an
Authorised Mazda Repairer when
replacing the tyre. The empty tyre
sealant bottle will need to be used to
extract and dispose of the used sealant
from the tyre.
12. Adhere the speed restriction sticker to
the speedometer.

WA R N I N G
Attach the speed restriction sticker in a
place where it can be viewed easily by
the driver:
Applying the speed restriction sticker
to the steering wheel is dangerous as
it could interfere with the air bag
deployment and result in serious
injury.
 Do not apply the sticker to any
position other than the position
indicated in the illustration of the
speedometer.
13. Install the compressor hose to the tyre
valve.

Valve Compressor hose
14. Insert the compressor plug into theinterior accessory socket and switch
the ignition to A CC (page 5-144).

Compressor plug
Compressor
Centre console
CAUTION
Before pulling out the compressor
plug from the electrical socket, make
sure the compressor power switch is
off.
 The compressor turns on and
off with
the push-button switch.
15. Turn the compressor switch on and inflate the tyre carefully to the correct
inflation pressure.
If Trouble Arises
Flat Tyre
7-23
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2