Page 233 of 772

•If dirt or foreign matter (Such as ice or
matter containing salt water) adheres to
the windscreen above the rain sensor or
if the windscreen is iced, it could cause
the wipers to move automatically.
However, if the wipers cannot remove
this ice, dirt or foreign matter, the
auto-wiper control will stop operation.
In this case, set the wiper lever to the
low speed position or high speed
position for manual operation, or
remove the ice, dirt or foreign matter by
hand to restore the auto-wiper
operation.
•If the auto-wiper lever is left in the
position, the wipers could operate
automatically from the effect of strong
light sources, electromagnetic waves, or
infrared light because the rain sensor
uses an optical sensor. It is
recommended that the auto-wiper lever
be switched to the
position other
than when driving the vehicle under
rainy conditions.
•The auto-wiper control functions can be
turned off.
Refer to Personalisation Features on
page 9-12.
▼ Windscreen Washer
Pull the lever toward
you and hold it to
spray washer fluid.
Washer
OFF
NOTE
If the windscreen washer is turned on
when the windscreen wipers are not
operating, the windscreen wipers operate
a few times.
If the washer does no
t work, inspect the
fluid level (page 6-32). If the fluid level
is normal, consult an expert repairer, we
recommend an Authorised Mazda
Repairer.
When Driving
Switches and Controls
4-74
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2
Page 234 of 772

Rear Window Wiper andWa s h e r
The ignition must be switched ON to use
the wiper.
▼Rear Window Wiper
Turn the wiper on by turning the rear
wiper/washer switch.
Switch Position
Wiper operation
No. Ty p e
A Ty p e
B
Stop
Intermittent
Normal
▼ Rear Window Washer
To spray washer fluid, turn the rear wiper/
washer switch to either of the
position.
After the switch is released, the washer
will stop.
If the washer does not work, inspect the
fluid level (pa ge 6-32). If the fluid level
is normal and the washer still does not
work, consult an expert repairer, we
recommend an Authorised Mazda
Repairer.
Headlight Washer*
The engine must be started and the
headlights must be turned on.
If you want to operate headlight washers,
double flick the wiper lever.
Washer
OFF
NOTE
•When the windscreen washer is
operated for the first time after turning
on the headlights, the headlight washers
operate automatically.
•If air enters the headlight washer fluid
pipe under conditions such as when the
vehicle is brand-new or after an empty
washer tank is replenished with washer
fluid, washer fluid will not spray even
when the wiper lever is operated. If this
occurs, perform the following
procedure:
1. Start the engine.
2. Turn on the headlights.
3. Double flick the wiper lever several
times until the washer fluid sprays.
When Driving
Switches and Controls
*Some models.4-75
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2
Page 235 of 772

Rear Window Defogger
The rear window defogger clears fog from
the rear window.
The ignition must be switched ON to use
the defogger.
Press the switch to turn on the rear
window defogger. The rear window
defogger operates for about 15 minutes
and then turns off automatically.
The indicator light illuminates when the
defogger is operating.
To turn off the rear window defogger
before the 15 minutes has elapsed, press
the switch again.
Manual Air-Conditioning
Indicator light
Fully Automatic Air-Conditioning
Indicator light
CAUTION
Do not use sharp instruments or window
cleaners with abrasives to clean the
inside of the rear window surface. They
may damage the defogger grid inside the
window.
NOTE
•This defogger is not designed for
melting snow. If there is an
accumulation of snow on the rear
window, remove it before using the
defogger.
•The rear window defogger setting can
be changed. After changing the setting,
the rear window defogger stops
automatically after 15 minutes have
elapsed and when the ambient
temperature is high. When the ambient
temperature is low, it continues to
operate until the switch is pressed
again.
Refer to Personalisation Features on
page 9-12.
▼ Mirror Defogger*
The mirror defoggers defrost the outside
mirrors.
The mirror defoggers operate in
conjunction with the rear window
defogger.
To turn on the mirror defoggers, switch the
ignition ON and press the rear window
defogger switch (page 4-76).
When Driving
Switches and Controls
4-76*Some models.
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2
Page 236 of 772
Manual Air-Conditioning
Indicator light
Fully Automatic Air-Conditioning
Indicator light
▼Windscreen Wiper De-icer
The thermal filaments at the following
positions heat up and facilitate the removal
of snow accumulated on the windscreen.
Left-Hand Drive Model
Right-Hand Drive Model
The windscreen wiper de-icer operates in
conjunction with the rear window
defogger.
To turn on the windscreen wiper de-icer,
switch the ignition ON and press the rear
window defogger switch (page 4-76).
Manual Air-Conditioning
Indicator light
Fully Automatic Air-Conditioning
Indicator light
When Driving
Switches and Controls
4-77
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2
Page 237 of 772
Horn
To sound the horn, press the mark on
the steering wheel.
Hazard Warning Flasher
The hazard warning lights should always
be used when you stop on or near a
roadway in an emergency.
The hazard warning lights warn other
drivers that you r vehicle is a traffic hazard
and that they must take extreme caution
when near it.
Depress the hazard warning flasher and all
the direction indicators will flash. The
hazard warning indicator lights in the
instrument cluster flash simultaneously.
NOTE
•The direction indi cators do not work
when the hazard warning lights are on.
•Check local regulations about the use of
hazard warning lights while the vehicle
is being towed to verify that it is not in
violation of the law.
When Driving
Switches and Controls
4-78
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2
Page 238 of 772
•If the brake pedal is depressed while
driving on slippery roads, the
emergency stop signal system could
operate causing all the turn and lane
change signals to flash. Refer to
Emergency Stop Signal System on page
4-88.
•While the emergency stop signal system
is operating, all the direction indicators
automatically flash rapidly to caution
the driver of a vehicle following behind
your vehicle of a sudden braking
situation. Refer to Emergency Stop
Signal System on page 4-88.
When Driving
Switches and Controls
4-79
2017-6-7 7:51:19Form No. CX-5 8FY4-EE-17E+L_Edition2
Page 239 of 772

Brake System
▼Foot Brake
This vehicle has power-assisted brakes
that adjust automatically through normal
use.
Should power-assist fail, you can stop by
applying greater force than normal to the
brake pedal. But the d
istance required to
stop will be greater than usual.
WA R N I N G
Do not coast with the engine stalled or
turned off,
find a safe place to stop:
Coasting with the engine stalled or turned
off is dangerous. Braking will require more
effort, and the brake's power-assist could
be depleted if you pump the brake. This will
cause longer stopping distances or even an
accident.
Shift to a lower gear when going down
steep hills:
Driving with your foot continuously on the
brake pedal or steadily applying the brakes
for long distances is dangerous. This causes
overheated brakes, resulting in longer
stopping distances or even total brake
failure. This could cause loss of vehicle
control and a serious accident. Avoid
continuous application of the brakes.
Dry off brakes that have become wet by
driving slowly, releasing the accelerator
pedal and lightly applying the brakes
several times until the brake performance
returns to normal:
Driving with wet brakes is dangerous.
Increased stopping distance or the vehicle
pulling to one side when braking could
result in a serious accident. Light braking
will indicate whether the brakes have been
affected.
CAUTION
Do not drive with your foot held on the
clutch pedal or brake pedal, or hold the
clutch pedal depressed halfway
unnecessarily. Doing so could result in
the following:
The clutch and brake parts will wear
out more quickly.
The brakes can overheat and adversely
affect brake performance.
Always depress the brake pedal with the
right foot. Applying the brakes with the
unaccustomed left foot could slow your
reaction time to an emergency situation
resulting in insufficient braking
operation.
Wear shoes appropriate for driving in
order to avoid your shoe contacting the
brake pedal when depressing the
accelerator pedal.
When Driving
Brake
4-80
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2
Page 240 of 772

▼Electric Parking Brake (EPB)
The EPB equipment applies the parking
brake using an electric motor. When the
EPB is applied, the EPB switch indicator
light turns on.
Indicator light
WA R N I N G
Do not drive the vehicle with the EPB
applied:
If the vehicle is driven with the parking
brake applied, the brake parts may
generate heat and the brake system may
not operate, leading to an accident.
Before driving, release the EPB and verify
that the EPB indicator light is turned
off.
NOTE
•The EPB cannot be applied or released
while the vehicle battery is dead.
•If the EPB is repeatedly applied and
released it may stop operating to
prevent overheating of the motor. If this
occurs, wait approx. 1 minute before
operating the EPB switch again.
•An operation sound occurs when
applying or releasing the EPB, however,
this does not indicate a malfunction.
•If the EPB is not used for long periods,
an automatic inspection of the system is
performed while the vehicle is parked.
An operation sound can be heard,
however, this does not indicate a
problem.
•When the EPB is applied and the
ignition is switched OFF, an operation
sound can be heard, however, this does
not indicate a problem.
•The brake pedal may move while the
EPB is being applied or released,
however, this does not indicate a
problem.
•If the EPB switch is continually pulled
while driving the vehicle, the EPB will
be applied and the EPB warning beep
will be activated. When the switch is
released, the EPB is released and the
beep stops.
•If the EPB is applied with the ignition
switched off or in ACC, the EPB
indicator light in the instrument cluster
and the indicator light in the switch may
turn on for 15 seconds.
•When running the vehicle through an
automatic car wash, it may be necessary
to switch the ignition off with the
parking brake released depending on
the type of automatic car wash.
When applying the EPB
The EPB can be applied regardless of the
ignition switch position.
Securely depress the brake pedal and pull
up the EPB switch.
The EPB is applied and the EPB indicator
light and the EPB switch indicator light
turn on.
When Driving
Brake
4-81
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2