2020 MITSUBISHI ASX Owner's Manual (in English)

ScreenCauseSolution (Reference)zThe brake fluid level in the reservoir has
fallen to a low level.
z There is a fault in the brake system.zImmediately stop the vehicle in a safe
place.
We recommend you to consult a MITSUBISHI MOTORS Authorized
Service Point.
Refer to “Brake warning display” on page 5-45.z There is a fault in the ABS.z Avoid sudden braking and high-speed
driving, stop the vehicle in a safe place, and take corrective measures. Refer to“ABS warning” on page 6-40.z The tyre pressure in one of the tyres is
low.z Refer to “Tyre pressure monitoring sys-
tem (TPMS)” on page 6-73.z There is a fault in the tyre pressure moni-
toring system.z Refer to “Tyre pressure monitoring sys-
tem (TPMS)” on page 6-73.z One of the doors or the tailgate is not
completely closed.
The open door is displayed.z Close the door or tailgate.
Refer to “Door ajar warning display screen (when the ignition switch or the operation mode is ON)” on page 5-17.
Indication lamp, warning lamp, and information screen display list
5-312*$(20(1Instruments and controls5

ScreenCauseSolution (Reference)zThe bonnet is open.zClose the bonnet.
Refer to “Bonnet” on page 10-03.z There is a fault in the electronic immobil-
izer (Anti-theft starting system).z Put the operation mode in OFF, and then
start the engine again.
If the warning is not cancelled, please
contact a MITSUBISHI MOTORS Au-
thorized Service Point.z The driver

ScreenCauseSolution (Reference)zThe engine is overheated.zStop the vehicle in a safe place and take
corrective measures.
Refer to “Engine overheating” on page 8-04.z The automatic transmission (CVT) fluid
temperature is too high.z Refer to “Automatic transmission IN-
VECS-III Sports Mode 6CVT (Intelligent & Innovative Vehicle Electronic Control
System III)” on page 6-22.z You turned the ignition switch to the
“ON” position or put the operation mode
in ON without fastening your seat belt.z Fasten your seat belt properly. Refer to
“Driver

ScreenCauseSolution (Reference)zThere is a fault in the engine oil circula-
tion system.z Immediately stop the vehicle in a safe
place. We recommend you to have it checked.
Refer to “Oil pressure warning display” on page 5-46.z There is a fault in the charging system.zImmediately stop the vehicle in a safe
place. We recommend you to consult a MITSUBISHI MOTORS Authorized
Service Point.
Refer to “Charge warning display” on page 5-46.z There is a fault in the SRS airbag or the
pretensioner system.z We recommend you to have it checked,
immediately.
Refer to “Supplemental restraint System (SRS) warning lamp” on page 4-34.z There is an automatic headlamp levelling
fault.z We recommend you to have it checked.
Refer to “Automatic headlamp levelling” on page 5-54.z There is a fault in the Active Stability
Control (ASC).z We recommend you to have it checked.
Refer to “Active Stability Control (ASC)”
on page 6-42.z There is a fault in the hill start assist.zHave the vehicle checked at a
MITSUBISHI MOTORS Authorized
Service Point.
Refer to “Hill start assist” on page 6-37.
Indication lamp, warning lamp, and information screen display list
5-342*$(20(1Instruments and controls5

ScreenCauseSolution (Reference)zThere is a fault in the electronically con-
trolled 4WD system.z We recommend you to have it checked.
Refer to “Electronically controlled 4WD
system” on page 6-30.z There is a fault in the CVT.z We recommend you to have it checked.
Refer to “Automatic transmission IN-
VECS-III Sports Mode 6CVT (Intelligent & Innovative Vehicle Electronic Control
System III)” on page 6-22.z The electronically controlled 4WD system
is hot.z Refer to “Electronically controlled 4WD
system” on page 6-30.z The fuel is running low.z Refuel as soon as possible. Refer to
“Fuel
remaining warning display” on page 5-15.z The outside temperature is
3

ScreenCauseSolution (Reference)zThere is a fault in the Forward Collision
Mitigation system (FCM).z We recommend you to have it checked.
Refer to “System problem warning” on page 6-55.z The FCM braking function of the Forward
Collision Mitigation system (FCM) has been activated.z Refer to “FCM braking function” on page
6-51.z The Forward Collision Mitigation system
(FCM) is temporarily unavailable for
some reason. This is not a malfunction.z Refer to “System problem warning” on
page 6-55.
(flashing in yellow)
z The Lane Departure Warning (LDW) has
detected that your vehicle is about to leave or has left the lane.Refer to “Lane Departure Warning (LDW)” on
page 6-69.
Indication lamp, warning lamp, and information screen display list
5-362*$(20(1Instruments and controls5

ScreenCauseSolution (Reference)zThere is a fault in the Lane Departure
Warning (LDW).z We recommend you to have it checked.
Refer to “LDW deactivation due to fault”
on page 6-71.z The Blind Spot Warning (BSW) sensor is
temporarily not available for some reason such as the environmental condition or in-crease of the sensor temperature.z When the warning display does not disap-
pear after waiting for a while, contact a
MITSUBISHI MOTORS Authorized
Service Point.
Refer to “When the sensor is temporarily
not available” on page 6-66.z The Blind Spot Warning (BSW) does not
operate normally because there are some malfunctions in the system.z We recommend you to have it checked,
immediately.
Refer to “When there is a malfunction in
the system or the sensor” on page 6-66.z Foreign objects, such as dirt, snow or ice,
adhere to the bumper surface around the sensor.z Remove a foreign object on the bumper
surface around the sensor.
When the warning display does not disap- pear after having cleaned the bumper sur-face around the sensor, contact a
MITSUBISHI MOTORS Authorized
Service Point.
Refer to “Blind Spot Warning (BSW):
When there is a foreign object on the sen-
sor” on page 6-67.
Indication lamp, warning lamp, and information screen display list
5-372*$(20(1Instruments and controls5

ScreenCauseSolution (Reference)
(flashing in yellow)
zThe Rear Cross Traffic Alert (RCTA) has
detected a vehicle that is approaching
your vehicle.z Pay special attention to the rear of your
vehicle.
Refer to “Rear Cross Traffic Alert (RCTA)*” on page 6-67.z There is a fault in the sensor.zWe recommend you to consult a
MITSUBISHI MOTORS Authorized
Service Point.
Refer to “Forward Collision Mitigation system (FCM): System problem warning”
on page 6-55.
Refer to “Lane Departure Warning
(LDW): System problem warning” on page 6-71.
Refer to “Automatic High-Beam (AHB): System problem warning” on page 5-51.
Indication lamp, warning lamp, and information screen display list
5-382*$(20(1Instruments and controls5