2016 Peugeot 308 Owner's Manual

183
308_en_Chap06_conduite_ed02-2015
Modification of the cruise control speed and/or
the inter-vehicle time
Press button 5, the six memorised speeds and
the inter-vehicle time setting are displayed in
the touch screen.
F
Ch

oose a speed setting: it is displayed in
the instrument panel,
F
pr

ess or the " +" or " -" button to choose
a new inter-vehicle time setting between
2.5
se

conds and 1 second.
thi

s setting remains memorised, whatever the
state of the system.
the s

election screen closes after a few
moments.
the m

odifications are then accepted. In the event of the presence of a
vehicle detected by the radar, if the
speed selected is much higher than
the speed of that vehicle, the system
is not activated and the alert message
"Activation not possible, conditions
unsuitable" is displayed until driving
conditions are safe to allow activation of
the system.
Exceeding the programmed
speed
It is possible to exceed the programmed speed
temporarily by depressing the accelerator
pedal.
Simply release the accelerator pedal to return
to the programmed speed.
If the programmed setting is unintentionally
exceeded, descending a steep hill for example,
the speed setting in the instrument panel
flashes as a warning.
Button 5 (MEM)
6
Driving

184
308_en_Chap06_conduite_ed02-2015
the following table describes the alerts and the messages displayed for the different driving situations.the display of these alerts is not sequential.
Driving situations and associated alerts
Symbol Display in the
instrument panel Associated message
Comments
No vehicle detected:
the system operates as a standard cruise control.
Detection of a vehicle, at the limit of the range of the radar:
the system operates as a standard cruise control.
"SP
eeD A

DJ
uSteD"D

etection of a vehicle that is too close or running at a speed lower than your
vehicle's cruise speed setting.
the s

ystem uses engine braking to slow your vehicle (within a limit of 20 mph
(30 km/h)) and then hold it at the speed of the vehicle in front so as to observe the
programmed inter-vehicle time.
When automatically slowing down behind a vehicle, your true speed may be higher
than the "adjusted speed" displayed.
"SP
eeD A

DJ
uSteD"W

hen the adjusted speed reaches the limit of regulation (speed setting less than
20 mph (30 km/h)), the adjusted speed flashes together with the speed setting to
signal that automatic deactivation of the system is imminent.
"Cruise control
paused". If the system exceeds the limit of speed adjustment possible by the system and in
the absence of any reaction by the driver (operation of the direction indicator, change
of lane, reduction of the speed of the vehicle), the system is automatically paused.
the d

isplay of the deactivation message is accompanied by an audible signal.
Driving

185
308_en_Chap06_conduite_ed02-2015
When the active cruise control is
automatically paused, it can only be
reactivated when safe conditions are
restored.
the
message "Activation
not possible, conditions unsuitable"
is displayed while reactivation is not
possible.
When the conditions allow, it is
recommended that the function be
reactivated by pressing button 2 (S
et+)


or 3 (S
et-)

, which will make the current
speed of your vehicle the new cruise
speed setting, rather than by pressing
button 4 (on/pause) which reactivates
the cruise control using the old cruise
speed setting, which may be very
different from the current speed of your
vehicle.the s peed regulation range is limited to a
maximum difference of 20 mph (30 km/h)
between the speed setting and the speed of the
vehicle in front.
Above this, the system goes into pause if the
safe distance becomes too low.
the a

ctive cruise control uses only engine
braking to slow the vehicle. Consequently the
vehicle looses speed slowly, as when releasing
the accelerator pedal.
the s

ystem is paused automatically:
-
if t

he vehicle in front slows down to much
or too suddenly, and the driver does not
brake,
-
if a v

ehicle comes between your vehicle
and the vehicle in front,
-
if t

he system does not slow the vehicle
enough to continue to maintain a safe
distance, for example when descending a
steep hill.
Limits of operation
As the radar's field of view is quite narrow, it is
possible that the system may not detect:
the c
ruise control does not take account of:
- st ationary vehicles,
- ve hicles driving in the opposite direction.
-
ve

hicles of reduced width, such as
motorcycles, for example, -
ve

hicles not running in the middle of the
lane,
-
veh
icles entering a corner,
-
ve
hicles changing lane at the last
moment.
6
Driving

186
308_en_Chap06_conduite_ed02-2015
In the event of a fault with the active cruise
control, you are alerted by an audible signal
and display of the message message "Driving
aid functions fault".
Have the system checked by a P
eu
ge
Ot
d

ealer or a qualified workshop. When the cruise control is working, take
care if making a maintained press on
one of the cruise control programmed
speed modification buttons: this can
lead to a very quick change in the
speed of your vehicle.
Do not use the active cruise control on
slippery sur faces or in heavy traffic.
When descending a steep hill, the
cruise control may not be able to
prevent the vehicle from exceeding the
programmed speed.
When ascending a steep hill or when
towing, it might not be possible to attain
or maintain the programmed speed.
Operating fault
the operation of the radar, located in
t he front bumper, may be disturbed in
certain weather conditions, for example:
with accumulations of snow, ice,
mud,
...
C

lean the front bumper, removing the
snow, mud, ...
the u

se of mats not approved by
P
eu

ge
Ot m
ay inter fere with the
operation of the active cruise control.
to av

oid any risk of jamming the pedals:
-
en

sure that mats are secured
c o r r e c t l y,
-
ne

ver fit one mat on top of another.
Driving

187
308_en_Chap06_conduite_ed02-2015
Display of inter-vehicle time
using a radar located at the front of the vehicle,
t his system helps the driver maintain a safe
distance between their vehicle and the one in
front, by displaying the current inter-vehicle
time in the instrument panel.
It is the time interval, expressed in seconds,
that separates two vehicles in line.
the
r

ecommended safe value is about 2 seconds:
refer to the legislation or highway code in force
in your country.Activation / deactivation*
F Press this button, the indicator
l amp comes on.
the m

easurement is displayed for
information only: the system takes no
action on the vehicle.
thi

s system does not in any
circumstances replace the need for
vigilance on the part of the driver who
must remain in control of the vehicle at
all times.
the s

ystem is not designed for urban
use nor for more dynamic driving
(bends, acceleration, harsh braking…)
but rather when driving at a steady
speed.
the s

ystem is active in a speed range
between 42 and 93 mph (70 and
150
k

m/h).
Stationary vehicles and certain other
road users (such as bicycles for
example) are not detected.
the s

ystem displays inter-vehicle
time values of between 3 seconds and
0.5 of a second.
Below 0.5 of a second, the value
displayed is maintained at this level,
even if the true inter-vehicle time is less.
the s

tate of the system is memorised when the
ignition is switched off. Activation of the system is done in the " Driving
assistance " menu, with the engine running.
* Depending on version.
Conditions for display
the active cruise control must not be selected
( the active cruise control information is
displayed instead of that for the inter-vehicle
t i m e).
6
Driving

188
308_en_Chap06_conduite_ed02-2015
Once the speed conditions are met, a symbol is displayed in the instrument panel.
Displays
SymbolAssociated message Comments
No vehicle detected by the radar.
A vehicle is detected but the inter-vehicle time is more than 3 seconds. No value is
displayed.
A vehicle is detected.
the i

nter-vehicle time is 3 seconds or less.
the m
inimum value
displayed is 0.5 seconds, even if the true inter-vehicle time is lower.
"SYS
teM IN

AC
tIVe: Sp
eed
unsuitable" If the speed of your vehicle is outside the operating range.
Where the speed is not suitable, a message is displayed while the speed is outside limits
(below 42 mph (70 km/h) or above 93 mph (150 km/h), approximately). However, when
decelerating, the system is deactivated below 27 mph (45 km/h).
"SYS
teM IN

AC
tIVe: Vi
sibility
reduced"
the s

ystem switches to standby automatically if the sensor does not detect the vehicle in
front correctly (very difficult weather conditions, sensor out of adjustment, ...).
Driving

189
308_en_Chap06_conduite_ed02-2015
the vehicle being followed may not be detected
i n certain conditions such as, for example:
-
when

turning,
-
wh

en changing lane,
-
wh

en the vehicle in front is out of the range
of the sensor (maximum range: around
10 0
m)

.
Operating limits
In the event of a fault with the system,
this warning lamp is displayed
accompanied by a message.
Operating fault
Have the system checked by a Peu geOt
d ealer or a qualified workshop.
At the first use of the system after
repair, a message may be displayed
indicating that the system is initialising.
the s

ystem is not available while this is
in progress. As soon as the message
disappears the system is operational
again. If the message does not
disappear, contact a P
eu

ge
Ot d
ealer
or a qualified workshop.
the o
peration of the radar, located in
the front bumper, may be disturbed in
certain weather conditions, for example:
with accumulations of snow, ice,
mud,
...
C
lean the front bumper, removing the
snow, mud, ...
6
Driving

190
308_en_Chap06_conduite_ed02-2015
emergency collision alert system and emergency collision braking system
Emergency collision alert
the emergency collision alert system can be
a ctivated or deactivated by the driver.
From the secondary page of the " Driving
assistance " menu:
F
Selec

t the "Vehicle settings " menu.
F
Ch

eck the " Collision risk alert and auto
braking " line and confirm.
thi

s system has been designed to
improve driving safety.
the d

river must constantly monitor
the traffic conditions, to assess the
distance and relative speed of other
vehicles.
the c

ollision risk alert system does not
replace the need for vigilance on the
part of of the driver.
thi

s system operates from 20 mph
(30
k

m/h), only when other vehicles are
running in the same direction as your
vehicle; the system does not detect
stationary objects. A radar is fitted at
the front of the vehicle.
System providing a warning to the driver that
their vehicle is at risk of collision with the
vehicle in front.
Driving