2012 Lexus CT200h Owner's Manual (in English)

559
4-3. Do-it-yourself maintenance
4
Maintenance and care
CT200h_OM_OM76067E_(EE)
LED lights
The headlight low beams (LED type), front position lights, daytime running
lights, side turn signal lights, stop/tail lights and high mounted stoplight
consist of a number of LEDs. If any of the LEDs burn out, take your vehicle
to any authorized Lexus dealer or repairer, or another duly qualified and
equipped professional to have the light replaced.
Condensation build-up on the inside of the lens
Contact any authorized Lexus dealer or repairer, or another duly qualified
and equipped professional for more information in the following situations.
Temporary condensation build-up on the inside of the headlight lens does
not indicate a malfunction.
Large drops of water have built up on the inside of the lens.
Water has built up inside the headlight.
When replacing light bulbs
P. 5 4 4
CAUTION
Replacing light bulbs
Turn off the lights. Do not attempt to replace the bulb immediately after
turning off the lights.
The bulbs become very hot and may cause burns.
Do not touch the glass portion of the light bulb with bare hands. Hold the
bulb by the plastic or metal portion.
If the bulb is scratched or dropped, it may blow out or crack.
Fully install light bulbs and any parts used to secure them. Failure to do so
may result in heat damage, fire, or water entering the headlight unit. This
may damage the headlights or cause condensation to build up on the lens.
To prevent damage or fire
Make sure bulbs are fully seated and locked.

560
4-3. Do-it-yourself maintenance
CT200h_OM_OM76067E_(EE)

5When trouble arises
561
CT200h_OM_OM76067E_(EE)
5-1. Essential information
Emergency flashers .......... 562
If your vehicle needs to
be towed ......................... 563
If you think something
is wrong ......................... 5705-2. Steps to take in an
emergency
If a warning light turns
on or a warning buzzer
sounds ............................ 571
If a warning message is
displayed ........................ 578
If you have a flat tire
(vehicles with a
spare tire) ....................... 599
If you have a flat tire
(vehicles without a
spare tire) ....................... 613
If the hybrid system will
not start .......................... 627
If you lose your keys ....... 629
If the electronic key does
not operate properly....... 630
If the 12-volt battery
is discharged .................. 633
If your vehicle overheats . 639
If the vehicle becomes
stuck............................... 644
If your vehicle has to be
stopped in an
emergency...................... 646

562
CT200h_OM_OM76067E_(EE)
5-1. Essential information
Emergency flashers
Emergency flashers
If the emergency flashers are used for a long time while the hybrid system is
not operating (while the “READY” indicator is not illuminated), the 12-volt
battery may discharge.
The emergency flashers are used to warn other drivers when the vehi-
cle has to be stopped in the road due to a breakdown, etc.
Press the switch.
All the turn signal lights will
flash. To turn them off, press
the switch once again.

5
563
5-1. Essential information
When trouble arises
CT200h_OM_OM76067E_(EE)
If your vehicle needs to be towed
Before towing
The following may indicate a problem with your hybrid transmis-
sion. Contact any authorized Lexus dealer or repairer, or another
duly qualified and equipped professional before towing.
The hybrid system is operating but the vehicle will not move.
The vehicle makes an abnormal sound.
If there is a malfunction in the P position control system, the smart
entry & start system or the immobilizer system, or if the 12-volt
battery is discharged, the vehicle cannot be towed with the front
wheels on the ground, as the front wheels may be locked. In this
case, transport the vehicle with both front wheels or all four wheels
lifted.
If towing is necessary, we recommend having your vehicle towed by
any authorized Lexus dealer or repairer, or another duly qualified and
equipped professional or a commercial towing service, using a lift-
type truck or flat bed truck.
Use a safety chain system for all towing, and abide by all state/provin-
cial and local laws.

564
5-1. Essential information
CT200h_OM_OM76067E_(EE)
Emergency towing
If a tow truck is not available in
an emergency, your vehicle
may be temporarily towed
using a cable or chain secured
to the emergency towing eye-
let(s). This should only be
attempted on hard surfaced
roads for short distances at
under 30 km/h (18 mph).
A driver must be in the vehicle
to steer and operate the brakes.
The vehicle’s wheels, drive
train, axles, steering and brakes
must be in good condition.

5
565
5-1. Essential information
When trouble arises
CT200h_OM_OM76067E_(EE)
Installing towing eyelets
Remove the eyelet cover using
a flathead screwdriver.
To protect the bodywork, place
a rag between the screwdriver
and the vehicle body as shown
in the illustration.
Insert the towing eyelet into the
hole and tighten partially by
hand.
Tighten down the towing eyelet
securely using a wheel nut
wrench.
STEP1
STEP2
STEP3

566
5-1. Essential information
CT200h_OM_OM76067E_(EE)
Towing with a sling-type truck
Do not tow with a sling-type
truck to prevent body damage.
Towing with a wheel-lift type truck
From the front
Release the parking brake.
From the rear
Use a towing dolly under the
front wheels.