2006 DODGE RAM SRT-10 clutch

29. Remove input shaft (1) to input clutch hub snap
ring (3).
30. Using a suitably sized socket (2) and an arbor
press (1), remove input shaft (5) from input shaft
hub.
ASSEMBLY
Use petrolatum on all seals to ease assembly of components.
1. Using an arbor press (2), install input shaft (1) to
input shaft hub (3).

5. Install the OD/Reverse piston (1) assembly to the
input clutch retainer (2).
6. Install the input hub/shaft assembly (1) to the
OD/Reverse piston/clutch retainer assembly (2).
7. Install input hub tapered snap ring (2).Make sure
snap ring is fully seated.

8. Install the UD clutch piston (1).
9. Install UD piston return spring (1) and Disc 5067
(2).
10. Position the UD spring retainer (1) and snap ring
(2) on the piston return spring (4).

CAUTION: Compress return spring just enough to
install snap ring.
11. Using Compressor 5059A (6) and an arbor press
(1), install the UD spring retainer and snap ring
(3).
12. Install the UD clutch pack (four fibers/four steels)
(1, 3). Leave the top disc (2) out until after the
snap ring is installed.
13. Install the UD clutch flat snap ring (1).

14. Install the last UD clutch disc (1).
15. Install the OD/UD clutch reaction plate (1). The
OD/UD clutches reaction plate has a step on both
sides. Install the OD/UD clutches reaction plate
taperedstepsideup.
NOTE: Snap ring ends must be located within one
finger of the input clutch hub. Be sure that snap
ring is fully seated, by pushing with screwdriver,
into snap ring groove all the way around.
16. Install the UD/OD tapered snap ring (1).

17. Seat tapered snap ring (1) to ensure proper
installation.
18. Install input clutch assembly (1) to the Input
Clutch Pressure Fixture 8391 (2).

19. Set up Dial Indicator C-3339 (1) on the UD clutch
pack (2).
20. Using moderate pressure, press down and hold
(near indicator) the UD clutch pack (2) with screw-
driver or suitable tool and zero dial indicator (1).
When releasing pressure on clutch pack, indicator
reading should advance 0.005-0.010 inches.
CAUTION: Do not apply more than 30 psi (206
kPa) to the underdrive clutch pack.
21. Apply 30 psi (206 kPa) to the underdrive hose on
Pressure Fixture 8391 and measure UD clutch
clearance. Measure and record UD clutch pack
measurement in four (4) places, 90° apart.
22. Take average of four measurements and compare
with UD clutch pack clearance specification.
Underdrive clutch pack clearance must be
0.94-1.50 mm (0.037-0.059 in.).
23. If necessary, select the proper reaction plate to
achieve specifications.
24. Install the OD clutch pack(four fibers/three steels)
(1).

25. Install OD reaction plate waved snap ring (1).
26. Install the OD/Reverse reaction plate (1) with
largestepdown(towardsODclutchpack).
27. Install OD reaction plate flat snap ring (3).