Page 97 of 292

95
Berlingo2VP_en_Chap04_Ergonomie_ed02-2016Berlingo2VP_en_Chap04_Ergonomie_ed02-2016
Overhead storage unit
This is located above the sun visors
and can accommodate various objects
(a
jumper, file, gloves...).
The openings concealed by the sun
visors allow you to see and access the
objects
stored in the overhead storage
unit.
The maximum weight permitted in the
overhead
storage unit is 5 Kg.
Do
not place objects in this storage
unit
which could present a risk to the
occupants.
Central storage console
This console offers an appreciable
additional storage area: it can be
removed and clips onto a base which
also incorporates two cup holders at
the
rear.
Ensure
that the object (bottle, can...)
placed in the cup holder is retained
securely
and does not risk being
dislodged
while driving.
Any liquid which could spill presents
a
risk of damage on contact with the
instrument panel and centre console
controls.
T
ake care.
Sun visor
To prevent dazzle from ahead, fold the
sun visor down.
A
pocket is provided in the driver's sun
visor
for storing toll cards, tickets, ...
Storage compartment under
seats
Storage compartments are available,
with or without lid, in the floor under the
front
seats.
To gain access to them, move the seat
forward.
The
lid must be lifted from the
rear
of the seat.
EASE OF USE and COMFORT
4
Practical information
Page 98 of 292

96
Berlingo2VP_en_Chap04_Ergonomie_ed02-2016Berlingo2VP_en_Chap04_Ergonomie_ed02-2016
SEATING AREA FITTINGS
Floor boxes
Two boxes are available, located under
the rear passenger footwells.
To
open them, slide your fingers into
the
recess and lift the lid.
Aircraft style tables
To put the table in place, pull it
upwards and fold it down.
As a safety precaution, above a high
pressure, the table is designed to
unhook.
To
put it back in place, with the table
vertical, engage one side then the
other
, forcing slightly.
Do
not place hard or heavy objects
on
the table.
They
could become
dangerous
projectiles in the event of
sharp
braking or impact.
A
bag hook is provided on the side of
each
table.
Side blinds
Side blinds may be available on the
sliding side doors.
Pull the side blind by the tab to install it.
To avoid damaging the blind when
opening the door, check that the tab is
hooked
securely.
Always guide the blind slowly
using the tab, both when raising
and
when lowering.
Practical information
Page 99 of 292
97
Berlingo2VP_en_Chap04_Ergonomie_ed02-2016Berlingo2VP_en_Chap04_Ergonomie_ed02-2016
MODUTOP ROOF
The multifunction roof extends the
overhead
storage unit. It consists of
the
following components:
Storage compartments
Storage compartments are provided
on each side of the roof. The maximum
authorised
load is 6 kg.
The translucent base assists with
finding
objects stored inside.
Do
not store objects which could
present
a risk to the occupants.
Courtesy lamp
The operation of the courtesy lamp is
identical to that of the front courtesy lamp.
Refer to chapter 4 "Practical
information", "Courtesy lamps"
section.
EASE OF USE and COMFORT
4
Practical information
Page 100 of 292
98
Berlingo2VP_en_Chap04_Ergonomie_ed02-2016Berlingo2VP_en_Chap04_Ergonomie_ed02-2016
From insideFrom outside
Rear box
This roof box can be accessed from
the
rear seats and the boot.
From
the rear seats, slide the flaps to
open.
Vents
A 3-position control allows you to
adjust the air flow through the vents.
The
vents are also fitted with a scented
air
freshener.
From the boot, place your thumb on
the recess then pull the handle to
open.
Open
carefully
to
prevent
objects
stored in this interior roof box from
fallin
g
out.
The
maximum
authorised
load
is
10
kg.
Practical information
Page 101 of 292
99
Berlingo2VP_en_Chap04_Ergonomie_ed02-2016Berlingo2VP_en_Chap04_Ergonomie_ed02-2016
SCENTED AIR FRESHENER
The scented air freshener diffuses
a fragrance in the passenger
compartment from the roof console
vents.
Adjusting the flow
Turn the chromed button to adjust the diffusion:
-
to the left to decrease,
-
to
the right to increase.
To stop the diffusion, turn the chromed
button
fully to the left.
Removing the scented air
freshener
- Press the button down while turning
it a quarter of a turn to the left to
the stop.
-
Remove the scented air freshener
from
the roof console.
-
Replace
the cartridge.
EASE OF USE and COMFORT
4
Practical information
Page 102 of 292

100
Berlingo2VP_en_Chap04_Ergonomie_ed02-2016Berlingo2VP_en_Chap04_Ergonomie_ed02-2016
Replacing a cartridge
The scented air freshener refill consists of a cartridge B and its sealing case C.
-
Remove
the protective film D.
-
Place the head of the cartridge
B
on the button A of the scented air
freshener.
-
T
urn it a quarter of a turn to lock it
on
the button and remove the case.
-
Insert the scented air freshener in
its
location.
You can change the cartridges at any
time and store cartridges which have
already been started in their original
case.
The scented air freshener button A is
independent
of the cartridge.
The cartridges are supplied without the
button A.
Inserting the scented air
freshener
After fitting or changing the cartridge:
-
Put
the scented air freshener back
in
place in its location.
-
T
urn it a quarter of a turn to the
right.
Good practice
As a safety precaution, only use the
cartridges provided for this purpose.
Do
not dismantle the cartridges.
Keep the cartridge sealing cases
which
are used as packaging when the
cartridges
are not in use.
Never
try to refill the cartridges with
fragrances other than those available
from
CITROËN dealers.
Keep out of reach of children and
animals.
A
void contact with the skin
and
eyes. If swallowed, consult a
doctor
and show him the packaging or
product
label.
The scented air freshener button A can
only
be
fixed
on
the
multifunction
roof
console
with
a
cartridge.
Therefore, always retain button A and
a
cartridge.
The cartridges are available from
CITROËN
dealers.
Practical information
Page 103 of 292
101
Berlingo2VP_en_Chap04_Ergonomie_ed02-2016Berlingo2VP_en_Chap04_Ergonomie_ed02-2016
MODUTOP ROOF BARS
The maximum authorised weight on
each
roof bar is 35 kg. In all cases, the load must rest on
the non-slip bands provided for this
purpose and must not touch the roof or
the
glazing of the roof.
Recommendations for loading the
roof
This procedure requires the use of
a spanner supplied with the tools for
changing
a wheel.
These two longitudinal Modutop roof
bars can be removed.
Chapter 9, "Changing a wheel"
section.
-
Open
the protective covers.
-
Slacken
the four screws using the
spanner
and remove them.
-
T
urn the bars 90° placing the
hollow
parts towards the front.
-
Refit
the the 4 screws and tighten
them
using the spanner.
-
Close
the protective covers.
-
Use the strap passages
A only to
secure
the load firmly.
EASE OF USE and COMFORT
4
Practical information
Page 104 of 292
102
Berlingo2VP_en_Chap04_Ergonomie_ed02-2016Berlingo2VP_en_Chap04_Ergonomie_ed02-2016
ExTERIOR ROOF BARS
If you install transverse bars on these bars, refer to the weight values\
indicated
by the manufacturer but do not exceed: 75 kg.
Practical information