Page 14 of 292
12
Berlingo2VP_en_Chap01_vue-ensemble_ed02-2016
TECHNICAL DATA - M AINTENANCE
Identification markings,
serial number ,
paint code, tyres
201
Windscreen wash, level
158
Changing bulbs,
lighting
181-186 Checks
159-160
-
battery
,
-
brake
pads,
-
brake
drums, discs.
-
parking
brake,
-
carbon/passenger compartment filter,- oil filter,
- particle filter,
-
gearbox,
Emissions control
41
Engine
fuses
187,
190
Opening the bonnet, stay
154 Levels
157-158
-
engine
oil dipstick,
-
brake
fluid,
-
coolant.
-
power
steering fluid,
-
Diesel additive,
Bleeding
water, Diesel filter
160
W
arning lamps
32-39
Under the bonnet-
Diesel
156
-
petrol
155
Fuel cut-of
f, Diesel
priming
163
AdBlue
® 164-169
Dimensions
193-196
Petrol
engines
/
weights
197-198
Diesel
engines
/
weights
197,
199-200
Location
Page 50 of 292

48
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
Instruments and controls
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
Trip recorder zero
reset button
After this operation, if you wish
to disconnect the battery, lock
the
vehicle and wait for at least five
minutes, otherwise the zero re-set will
not
be registered.
Engine oil level indicator
Depending on your vehicle's engine,
when the ignition is switched on,
the engine oil level is indicated for
a few seconds, after the service
information. Oil level
correct
Low oil level
Flashing of "OIL",
linked
with the
service warning lamp,
accompanied by an
audible signal and a message in the
screen, indicates a low oil level which
could
damage the engine.
If the low oil level is confirmed by a
check
using the dipstick, it is essential
that
the level is topped up.
Oil level gauge
fault
Flashing of "OIL--"
indicates a
malfunction of the
engine oil level indicator. Contact
a
CITROËN dealer or a qualified
workshop.
The level read will only be correct
if the vehicle is on level ground
and the engine has been of
f for
more
than 30 minutes.Dipstick
A = maximum, never exceed
this level as a surplus of oil
may
damage the engine.
Contact a CITROËN dealer
or a qualified workshop
without
delay.
B = minimum, top up the level
via the oil filler cap, using the
grade of oil suited to your
engine.
Lighting dimmer
With the ignition on, press
the button until the zeros
appear.
With the lighting on,
press the button to vary
the brightness of the
instruments
and controls.
When the lighting reaches
the minimum
(or maximum) setting, release the
button then press it again to increase
(or
reduce)
the brightness.
As soon as the lighting is of the
required
brightness, release the button.
Zero reset
Your CITROËN dealer or a qualified workshop carries out this operation
after
each service.
However, if you carry out the service
yourself, the re-set procedure is as
follows:
-
switch of
f the ignition,
-
press and hold the trip recorder
reset button,
-
switch
on the ignition.
The
display begins a countdown.
When the display shows "=0", release
the
button; the spanner disappears.
Page 157 of 292
155
Berlingo2VP_en_Chap07_Verification_ed02-2016Berlingo2VP_en_Chap07_Verification_ed02-2016
PETROL ENGINE
1. Screenwash fluid reservoir.
2.
Fusebox.
3.
Engine
coolant header tank.
Battery
connections:
+
Positive
terminal.
-
Negative
point (earth).
Take
care when working under the bonnet.
4. Brake and clutch fluid reservoir.
5.
Air
filter.
6.
Engine
oil dipstick.7.
Engine oil filler cap.
8.
Power
steering fluid reservoir.
CHECKS
7
Under the bonnet
Page 158 of 292
156
Berlingo2VP_en_Chap07_Verification_ed02-2016Berlingo2VP_en_Chap07_Verification_ed02-2016
DIESEL ENGINE
4. Brake and clutch fluid reservoir.
5.
Air
filter.
6.
Engine
oil dipstick.
7.
Engine
oil filler cap. 8.
Power steering fluid reservoir.
9.
Priming pump
(except
BlueHDi engines).
1.
Screenwash
fluid
reservoir.
2.
Fusebox.
3.
Engine
coolant
header
tank.
Battery
connections:
+
Positive
terminal.
-
Negative
point (earth).
Take
care
when
working
under
the
bonnet.
Under the bonnet
Page 159 of 292

157
Berlingo2VP_en_Chap07_Verification_ed02-2016Berlingo2VP_en_Chap07_Verification_ed02-2016
LEVELS
Oil change
This must be carried out at
the intervals specified in the
manufacturer's
servicing schedule.
Ask
for
advice from a CITROËN dealer.
Remove
the dipstick before filling.
Check
the level after filling (never
exceed
the max mark).
Refit
the oil filler cap before closing the
bonnet.
Changing the brake fluid
The brake fluid must be changed at the intervals stated, according to the
manufacturer's servicing schedule.
Use
fluids recommended by the
manufacturer
, which meet the DOT4
standard.
The level must be between the MIN
and
MAX marks on the reservoir.
If
fluid has to be added frequently,
this indicates a fault which must be
checked
by a CITROËN dealer or
a
qualified workshop as soon as
possible.
Warning lamps
If you have to remove / refit the engine style cover, handle it with
care
to avoid damaging the fixing
clips.
Oil level
It is recommended that the oil level be
checked every 3 000 miles (5 000 km)
and topped up if necessary between oil
changes.
Check
the level with the vehicle level,
engine
cold, using the dipstick.
Dipstick
Viscosity selection
In all cases, the oil selected must
meet
the requirements specified in the
manufacturer's
service schedule.
These regular maintenance
operations
will keep your vehicle
in
good working order.
Ask
for
advice from a CITROËN dealer or refer
to the maintenance and warranty guide
in
the handbook pack.
Checks using the warning
lamps in the instrument panel
is described in chapter 3,
"Instruments and controls"
section.
There
are two marks on
the
dipstick:
A = maximum
If
you fill past this mark,
contact a CITROËN
dealer
or a qualified
workshop.
B
= minimum
Never allow the level to
fall
below this mark.
To maintain the reliability
of engines and emission
control systems, the use
of additives in engine oil
is
prohibited.
CHECKS
7
Levels