2013 SSANGYONG KORANDO Service Manual

8010-01
Pin No. Message Operating condition
Domestic Export
Tire alignment
(applies to
vehicle with
EPS)
CAN scan(This message goes off when all the CAN signal inputs
are normal)
ESCLLCD display shows this message when ESCL (Electric
Steering Column Lock) system is defective. There is
no specific ESCL warning light on the instrument
cluster.
This problem could be temporary. Turn the ignition off
and then on again to check if this message will be
disappeared.
This message helps the driver to predict the driving
direction since the tire alignment is displayed on the
instrument cluster.
The images on the left show that the tires are
aligned to the left. When the tires are aligned to the
right, the image is symmetrical vertically.
Tire alignment is displayed between level 0 and
level 5 depending on the alignment degree when
the ignition switch is turned to "ON" position from
"OFF" position with the shift lever in "P" or "N"
position. While the images up to level 2 comes on
for 5 seconds, the images from level 3 stay on.
These messages are not displayed when the EPS
check message is displayed. -
-
-
-
Pin No. Message Operating condition

5. SELF DIAGNOSIS PROCESS
1) Self Diagnosis Process Mode

8010-01
2) What Is Shown On Instrument Cluster
Supervision type
Standard type
(1) Self diagnosis for gauge
Speedometer/tachometer (RPM): Oscillates between lower mark and upper mark repeatedly. -
(2) Self diagnosis for warning lamp and indicator lamp
All the warning lamps and indicator lamps come on by MICOM control (CAN communication) and
they blink if faulty.
(However, the wired type symbols such as air bag, LH/RH turn signal indicators, hazard warning
flasher, high beam, front fog lamp do not come on.) -
(3) Miscellaneous
When entering into the self diagnosis mode, the instrument cluster illumination output will be 100%.
All the segments are ON. -
-

8510-00
1. SPECIFICATIONS
Unit Specification
Multifunction
switchRated voltage DC 12 V
Rated
loadMultifunction
turn light
switchLight switch ON: 1 A (relay load)
Dimmer & passing
switchHigh beam: 0.3 A (relay load)
Low beam: 0.3 A (relay load)
Passing: 0.3 A (relay load)
Turn signal lamp
switch0.1 A (relay load)
AUTO hazard
warning flasher
switch0.1 A (relay load)
Multifunction
wiper
switchWiper switchLO: 0.1 A (relay load)
HI: 0.1 A (relay load)
Fixed: Max. 0.1 A (relay load)
AUTO washer switch
0.1 A (relay load)
Washer switch 0.1 A (relay load)
Wiping speed control
switchMax. 25 mA
Mist switch 0.1 A (relay load)
Rear wiper & washer
switchRear wiper: 0.1 A (relay load)
Multifunction switch

Lower main switch
Item Specification
Lower main switch4WD LOCK switch DC 12V - 0.1A
ESP OFF switch DC 12V - 0.1A
Steering wheel heating switch DC 12V - 0.1A
Center fascia switch
Item Specification
Center fascia switchHazard warning flasher switch DC 12V - 0.1A (max. 30 mA)
TRIP/RESET switch DC 12V - 0.1A (max. 30 mA)
Windshield heating switch DC 12V - 0.1A (max. 30 mA)
Rear glass and outside rearview mirror
heating switchDC 12V - 0.1A (max. 30 mA)
Power window main switch
Item Specification
Power window main
switchRated voltage
DC 12 V
Operating voltage DC 9 to 16 V
Rated loadAUTO switch 0.7 A (motor load)
AUTO/MANUAL switch 10 A (motor load)
Window lock switch 10 A (motor load)
Door unlock switch 0.4 A (motor load)
Power window sub switch
Item Specification
Power window sub
switchRated voltage DC 12 V
Operating voltage DC 9 to 16 V
Rated load Manual switch 10 A (motor load)

8510-00
Audio remote control switch
Cruise control switch
Item Specification
Cruise control switchON/OFF DC 5V - 10mA
DECEL DC 5V - 10mA
ACCEL DC 5V - 10mA
RESUME DC 5V - 10mA
Item Resistance Output voltage
Audio
remote control
switchVOL -
0 to 0.3 V
VOL +
0.4 to 1.0 V
MODE
1.1 to 1.4 V
MUTE
1.5 to 1.8 V
SEEK UP
1.9 to 2.25 V
SEEK DOWN
2.26 to 2.64 V
TIP -
-
TIP +
-
Bluetooth
(hands-free)
2.66 to 3.0 V
Front seat heating and ventilation switch
Item Specification
Front seat heating
and ventilation switchDriver seat heating switch 12V - 0.1A (max. 30 mA)
Driver seat ventilation switch 12V - 0.1A (max. 30 mA)
Passenger seat heating switch 12V - 0.1A (max. 30 mA)

2. MAJOR CHANGES
Center fascia switch
Center fascia switch
- Center fascia switch design and layout changed
- Digital clock switch deleted
Outside rearview mirror switch
Outside mirror switch
- Changed from self-return type to push-lock type
Hazard warning flasher
switch
TRIP reset switch
Digital clock
Windshield
heating switch
Rear glass/outside
rearview mirror
heating switch
Windshield
heating switch
TRIP reset switchRear glass/outside
rearview mirror
heating switch
Hazard warning lamp switch

8510-00
- Addition of driver seat ventilation switch and staged operation of switch
- Front seat heating & ventilation switches classified according to specifications
Front seat heating & ventilation switch (2-level of driver seat heating and ventilation, 2-level of
passenger seat heating)
Driver seat heating switch
Driver seat ventilation switch
Passenger seat heating switch
Seat heating and ventilation unit & switch application