2006 DODGE RAM SRT-10 mirror

SUN VISOR
REMOVAL
1. Remove the three screws (1) that secure each sun
visor (2) to the roof panel and remove the visor
from the headliner (3).
2. If equipped, disconnect the wire harness connector
for the illuminated vanity mirror (4).
INSTALLATION
1. If equipped, connect the wire harness connector for
the illuminated vanity mirror (4).
2. Position the sun visor (2) onto the headliner (3).
3. Install the three screws (1) that secure each sun
visor to the roof panel. Tighten the screws to 2.2
Nꞏm (20 in. lbs.).

WINDSHIELD
WARNING
WINDSHIELD SAFETY PRECAUTIONS
Do not operate the vehicle within 24 hours of windshield installation. It takes at least 24 hours for urethane
adhesive to cure. If it is not cured, the windshield may not perform properlyinanaccident.
Urethane adhesives are applied as a system. Use glass cleaner, glass prep solvent, glass primer, PVC
(vinyl) primer and pinch weld (fence) primer provided by the adhesive manufacturer. If not, structural
integrity could be compromised.
DaimlerChrysler does not recommend glass adhesive by brand. Techniciansshould review product
labels and technical data sheets, and use only adhesives that their manufactures warranty and will
restore a vehicle to the requirements of fmvss 212. Technicians should also insure that primers and
cleaners are compatible with the particular adhesive used.
Be sure to refer to the urethane manufacturer’s directions for curing timespecifications and do not
use adhesive after its expiration date.
Vapors that are emitted from the urethane adhesive or primer could cause personal injury or death.
Use them in a well-ventilated area.
Skin contact with urethane adhesive should be avoided. Personal injury ordeath may result.
Always wear eye and hand protection when working with glass.
Protect all painted and trimmed surfaces from coming in contact with urethane or primers.
Be careful not to damage painted surfaces when removing moldings or cutting urethane around windshield.
REMOVAL
1. Remove inside rear view mirror (3) (Refer to 23 -
BODY/INTERIOR/REAR VIEW MIRROR -
REMOVAL).
2. Remove cowl grille (2) (Refer to 23 - BODY/EXTE-
RIOR/COWL GRILLE - REMOVAL).

17. Install cowl grille (2) (Refer to 23 - BODY/EXTE-
RIOR/COWL GRILLE - INSTALLATION).
18. Install rear view mirror support bracket (4) (Refer
to 23 - BODY/INTERIOR/REAR VIEW MIRROR -
INSTALLATION).
19. Install rear view mirror (3) (Refer to 23 - BODY/
INTERIOR/REAR VIEW MIRROR -
INSTALLATION).
20. Install the a-pillar weatherstrip retainer (1) (Refer
to 23 - BODY/WEATHERSTRIP/SEALS/A-PILLAR
WEATHERSTRIP RETAINER - INSTALLATION)
21. After urethane has cured, remove tape strips and
water test windshield to verify repair.