Page 177 of 407

Downloaded from www.Manualslib.com manuals search engine 3
Care of Your Cassette Tape Player
A tape player that is not cleaned regularly can cause reduced sound
quality, ruined cassettes, or a damaged mechanism. Cassette tapes should
be stored
in their cases away from contaminants, direct sunlight, and
extreme heat.
If they aren't, they may not operate properly or cause
failure of the tape player.
Your tape player should be cleaned regularly each month or after every
15 hours of use. If you notice a reduction in sound quality, try a known
good cassette to see
if the tape or the tape player is at fault. If this other
cassette has no improvement
in sound quality, clean the tape player.
Clean your tape player
with a wiping-action, non-abrasive cleaning
cassette, and follow the directions provided
with it.
Cassettes are subject to wear and the sound quality may degrade over
time. Always make sure that the cassette tape is
in good condition before
you have your tape player serviced.
Care of Your Compact Discs
Handle discs carefully. Store them in their original cases or other
protective cases and away from direct sunlight
and dust. If the surface of
a disc is soiled, dampen a clean, soft cloth
in a mild, neutral detergent
solution and clean it, wiping from the center to the edge.
A
Be sure never to
touch the signal
surface when
handling discs. Pick
up discs
by grasping
the outer edges or
the edge
of the hole
and the outer edge.
163
Page 178 of 407
Downloaded from www.Manualslib.com manuals search engine Power Antenna Mast Care
Your power antenna will look its best and work well if it’s cleaned from
time
to time.
To Clean the Antenna Mast:
1. lbrn on the ignition and radio to raise the antenna to full mast
extension.
2. Dampen a clean cloth with mineral spirits or equivalent solvent.
3. Wipe cloth over the mast sections, removing any dirt.
4. Wipe dry with clean cloth before retracting.
5. Make the antenna go up and down by turning the radio or ignition on
6. Then repeat if necessary.
and
off.
NOTICE:
I Don’t lubricate the power antenna. Lubrication could damage
I
I
164
Page 179 of 407
Downloaded from www.Manualslib.com manuals search engine I
YOUR DRIVING AND THE ROAD
P
Here you’ll find information about driving on different kinds of roads and
in varying weather conditions. We’ve also included many other useful tips
I
on driving.
RORD SIGNS
The road signs you see everywhere are coded by color, shape and
symbols. It’s a good idea
to know these codes so that you can quickly
grasp
the basic meaning or intent of the sign even before you have a
chance
to read it.
165
Page 180 of 407
Downloaded from www.Manualslib.com manuals search engine Color of Road Signs
WRONG
WAY
RAILROAD ADVANCE
CROSSING NO
PASSING
ZONE
NARROW
BRIDGE
YELLOW indicates a general warning. Slow down and be careful when
you see
a yellow sign. It may signal a railroad crossing ahead, a no passing
166
.. -
-
Page 181 of 407
Downloaded from www.Manualslib.com manuals search engine zone, or some other potentially dangerous situation. Likewise, a yellow
solid line painted on the road means “Don’t Cross.’’
A
A
WORKERS
AHEAD FLAGGER
AHEAD
LOW
SHOULDER
ORANGE indicates road construction or maintenance. You’ll want to
slow down when you
see an orange sign, as part of the road may be closed
off or torn up. And there may be workers and maintenance vehicles
around, too.
GREEN is used to guide the driver. Green signs may indicate upcoming
freeway exits or show the direction
you should turn to reach a particular
place.
Page 182 of 407
Downloaded from www.Manualslib.com manuals search engine ~
~ HOSPITAL INFORMATION
BLUE signs with white letters show motorists’ services.
‘
L
CANOEING SWIMMING
BROWN signs point out recreation areas or points of historic or cultural
interest.
Shape of Road Signs
The shape of the sign will tell you something, too.
168
Page 183 of 407
Downloaded from www.Manualslib.com manuals search engine STOP
An OCTAGONAL (eight-sided) sign means STOP. It is always red with
white letters.
A DIAMOND-shaped sign is a warning of something ahead - for
example, a curve, steep hill, soft shoulder, or a narrow bridge.
A TRIANGLE, pointed downward, indicates YIELD. It assigns the
right-of-way
to traffic on certain approaches to an intersection.
169
Page 184 of 407
Downloaded from www.Manualslib.com manuals search engine A TRIANGULAR sign also is used on two-lane roads to indicate a NO
PASSING ZONE. This sign will be on the left side of the roadway.
KEEP
RIGHT
LEFT OR
THROUGH
ONLY
RIGHT TURN
ONLY
RECTANGULAR (square or oblong) signs show speed limits, parking
regulations, give directions, and such information as distances
to cities.
170
c