2022 HYUNDAI ELANTRA Owners Manual

05
5-89
Information
OCN7050060OCN7050060
<RXUYHKLFOHLVILOOHGZLWK5\I
DFFRUGLQJWRWKHUHJXODWLRQLQ\RXU
FRXQWU\DWWKHWLPHRISURGXFWLRQ<RXFDQ
ILQGRXWZKLFKDLUFRQGLWLRQLQJUHIULJHUDQW
LVDSSOLHGWR\RXUYHKLFOHRQWKHODEHO
ORFDWHGLQVLGHRIWKHKRRG
NOTICE
• The refrigerant system should only
be serviced by trained and certified
technicians to insure proper and safe
operation.
• The refrigerant system should be
serviced in a well-ventilated place.
• The air conditioning evaporator
(cooling coil) shall never be repaired
or replaced with one removed from
a used or salvaged vehicle and new
replacement MAC evaporators shall
be certified (and labeled) as meeting
SAE Standard J2842.
Information
• :KHQXVLQJWKHDLUFRQGLWLRQLQJ
V\VWHPPRQLWRUWKHWHPSHUDWXUH
JDXJHFORVHO\ZKLOHGULYLQJXSKLOOV
RULQKHDY\WUDIILFZKHQRXWVLGH
WHPSHUDWXUHVDUHKLJK$LUFRQGLWLRQLQJ
V\VWHPRSHUDWLRQPD\FDXVHHQJLQH
RYHUKHDWLQJ&RQWLQXHWRXVHWKHEORZHU
IDQEXWWXUQWKHDLUFRQGLWLRQLQJV\VWHP
RIILIWKHWHPSHUDWXUHJDXJHLQGLFDWHV
HQJLQHRYHUKHDWLQJ
• :KHQRSHQLQJWKHZLQGRZVLQKXPLG
ZHDWKHUDLUFRQGLWLRQLQJPD\FUHDWH
ZDWHUGURSOHWVLQVLGHWKHYHKLFOH6LQFH
H[FHVVLYHZDWHUGURSOHWVPD\FDXVH
GDPDJHWRHOHFWULFDOHTXLSPHQWDLU
FRQGLWLRQLQJVKRXOGRQO\EHXVHGZLWK
WKHZLQGRZVFORVHG
CN7 HMA 5.indd 5-892020-12-03 9:21:05

Convenient Features
5-90
$LUFRQGLWLRQLQJV\VWHPRSHUDWLRQWLSV
• If the vehicle has been parked in
direct sunlight during hot weather,
open the windows for a short time
to let the hot air inside the vehicle
escape.
• After sufficient cooling has been
achieved, switch back from
recirculation mode to fresh mode.
• To help reduce moisture inside of
the windows on rainy or humid
days, decrease the humidity inside
the vehicle by operating the air
conditioning system with the windows
and sunroof closed.
• During air conditioning system
operation, you may occasionally
notice a slight change in engine speed
as the air conditioning compressor
cycles. This is a normal system
operation characteristic.
• Use the air conditioning system
every month only for a few minutes
to ensure maximum system
performance.
• When using the air conditioning
system, you may notice clear water
dripping (or even puddling) on the
ground under the passenger side of
the vehicle. This is a normal system
operation characteristic.
• If you operate the air conditioner
excessively, the difference between
the temperature of the outside air and
that of the windshield could cause
the outer surface of the windshield to
fog up, causing loss of visibility. In this
case, set the mode selection button to
the
position and set the fan speed
control knob to the lowest speed
setting.
System Maintenance
Cabin air filter
OIK047401LOIK047401L[A] : Outside air, [B] : Recirculated air
[C] : Cabin air filter, [D] : Blower
[E] : Evaporator core, [F] : Heater core
The cabin air filter is installed behind
the glove box. It filters the dust or other
pollutants that enter the vehicle through
the heating and air conditioning system.
Have the cabin air filter replaced by an
authorized HYUNDAI dealer according to
the maintenance schedule. If the vehicle
is being driven in severe conditions such
as dusty or rough roads, more frequent
cabin air filter inspections and changes
are required.
If the air flow rate suddenly decreases,
the system should be checked at an
authorized HYUNDAI dealer.
Information
• 5HSODFHWKHILOWHUDFFRUGLQJWRWKH
0DLQWHQDQFH6FKHGXOH
• ,IWKHFDULVEHLQJGULYHQLQVHYHUH
FRQGLWLRQVVXFKDVGXVW\URXJK
URDGVPRUHIUHTXHQWFDELQDLUILOWHU
LQVSHFWLRQVDQGFKDQJHVDUHUHTXLUHG
• :KHQWKHDLUIORZUDWHVXGGHQO\
GHFUHDVHVZHUHFRPPHQGWKDWWKH
V\VWHPEHFKHFNHGE\DQDXWKRUL]HG
+<81'$,GHDOHU
CN7 HMA 5.indd 5-902020-12-03 9:21:05

05
5-91
Checking the amount of air
conditioner refrigerant and
compressor lubricant
When the amount of refrigerant is low,
the performance of the air conditioning
is reduced. Overfilling also reduces the
performance of the air conditioning
system.
Therefore, if abnormal operation is
found, have the system inspected by an
authorized HYUNDAI dealer.
NOTICE
It is important that the correct type and
amount of oil and refrigerant are used.
Otherwise, damage to the compressor
and abnormal system operation may
occur. To prevent damage, the air
conditioning system in your vehicle
should only be serviced by trained and
certified technicians.
WARNING
Vehicles equipped with R-1234yf
Since the refrigerant is
mildly flammable and
operated at high pressure,
the air conditioning system
should only be serviced
by trained and certified
technicians. It is important
that the correct type
and amount of oil and
refrigerant are used.
All refrigerants should be reclaimed
with proper equipment.
Venting refrigerants directly to the
atmosphere is harmful to individuals
and environment. Failure to heed these
warnings can lead to serious injuries.
OCN7050060OCN7050060
$LUFRQGLWLRQLQJUHIULJHUDQWODEHO
You can find out which air conditioning
refrigerant is applied to your vehicle on
the label located inside of the hood.
„„ExampleExample
OHYK059001OHYK059001
Each symbols and specification on
the air conditioning refrigerant label is
represented as below:
1. Classification of refrigerant
2. Amount of refrigerant
3. Classification of Compressor lubricant
4. Caution
5. Flammable refrigerant
6. To require registered technician to
service air conditioning system
CN7 HMA 5.indd 5-912020-12-03 9:21:05

Convenient Features
5-92
AUTOMATIC CLIMATE CONTROL SYSTEM
ãIF EQUIPPED
ä
OCN7050110LOCN7050110L
1. Driver’s temperature control knob
2. Passenger’s temperature control knob
3. AUTO (automatic control) button
4. SYNC button
5. OFF button
6. Front windshield defroster button
7. Air conditioning button
8. Air intake control button
9. Rear window defroster button
10. Fan speed control button
11. Mode selection button
12. Climate control information screen
CN7 HMA 5.indd 5-922020-12-03 9:21:06

05
5-93
Automatic heating and air
conditioning
OCN7050112OCN7050112
1. Press the AUTO button
The modes, fan speeds, air intake and
air-conditioning will be controlled
automatically according to the
temperature setting you select.
OCN7050113OCN7050113
You can control the blower strength in
three stages by pushing the AUTO button
during automatic operation.
- HIGH : Provide rapid air conditioning
and heating with strong blower
- MEDIUM : Provide air conditioning
and heating with medium strength
blower
- LOW : Is suitable for drivers that prefer
lower air speedsWhen you select the temperature to HI
or LO in AUTO mode, the fan speed is set
to ‘HIGH’.
„„Driver’s seatDriver’s seat„„Passenger’s seatPassenger’s seat
OCN7050114OCN7050114
2. Turn the temperature control knob
to set the desired temperature. If
the temperature is set to the lowest
setting (Lo), the air conditioning
system will operate continuously.
• To turn the automatic operation off,
select any button of the following:
- Mode selection button
- Front windshield defroster button
(Press the button one more time
to deselect the front windshield
defroster function. The ‘AUTO’ sign
will illuminate on the information
screen once again.)
- Fan speed control toggle switch
The selected function will be
controlled manually while other
functions operate automatically.
• For your convenience and overall
system efficiency, use the AUTO
button and set the temperature to
72°F (22°C).
CN7 HMA 5.indd 5-932020-12-03 9:21:06

Convenient Features
5-94
OCN7050133OCN7050133
Information
1HYHUSODFHDQ\WKLQJQHDUWKHVHQVRUWR
HQVXUHEHWWHUFRQWURORIWKHKHDWLQJDQG
FRROLQJV\VWHP
Manual heating and air
conditioning
The heating and cooling system can be
controlled manually by pushing buttons
other than the AUTO button. In this case,
the system works sequentially according
to the order of buttons selected. When
pressing any button except the AUTO
button while using automatic operation,
the functions not selected will be
controlled automatically.
1. Start the engine.
2. Set the mode to the desired position.
To improve the effectiveness of
heating and cooling, select the mode
according to the following:
- Heating:
- Cooling:
3. Set the temperature control to the
desired position.
4. Set the air intake control to fresh
mode.
5. Set the fan speed control to the
desired speed.
6. If air conditioning is desired, turn the
air conditioning system on.
7. Press the AUTO button in order to
convert to full automatic control of
the system.
CN7 HMA 5.indd 5-942020-12-03 9:21:06

05
5-95
Mode selection
OCN7050103NOCN7050103N
CN7 HMA 5.indd 5-952020-12-03 9:21:07

Convenient Features
5-96
OCN7050115OCN7050115
The mode selection toggle switch
controls the direction of the air flow
through the ventilation system.
The air flow outlet direction is cycled as
follows:
)DFHOHYHO%'
Air flow is directed toward the upper
body and face. Additionally, each outlet
can be controlled to direct the air
discharged from the outlet.
%L/HYHO%&'(
Air flow is directed towards the face and
the floor.
)ORRU/HYHO$&'(
Most of the air flow is directed to the
floor, with a small amount of the air
being directed to the windshield and side
window defrosters.
)ORRU 'HIURVW$&'(
Most of the air flow is directed to the
floor and the windshield with a small
amount directed to the side window
defrosters.
CN7 HMA 5.indd 5-962020-12-03 9:21:07